USGS ScienceSearch

USGS · wsp1229

Ground-water conditions in the Milwaukee-Waukesha area, Wisconsin

Abstract

Three major aquifers underlie the Milwaukee-Waukesha area: sandstones of Cambrian and Ordovician age, Niagara dolomite of Silurian age, and sand and gravel deposits of Pleistocene age. The Maquoketa shale of Ordovician age acts as a more or less effective seal between the Pleistocene deposits and Niagara dolomite above and the sandstone aquifer below. Crystalline rocks of pre-Cambrian age form an impermeable basement complex below the Paleozoic sedimentary rocks. The Paleozoic strata dip east at 25 to 30 feet to the mile. There is no evidence that any of the faults and folds known or surmised to be present acts as a barrier to the movement of ground water. The bedrock surface underlying the Milwaukee-Waukesha area is formed by the Niagara dolomite except in northeastern Milwaukee County, where it is dolomite and shale of the Milwaukee formation of Devonian age, and in some of the preglacial valleys where the uppermost bedrock formation is the Maquoketa shale. Unconsolidated deposits of glacial drift cover the surface of the bedrock almost completely. Buried valleys in the bedrock surface contain as much as 150 feet of water-bearing sand and gravel deposits. These deposits, along with the Niagara dolomite, could be developed as sources of water supplemental to that of the sandstone aquifer. The Niagara dolomite is an important aquifer; it yields water from crevices and solution channels. The sandstone aquifer consists of the Galena dolomite, the Platteville limestone, and the St. Peter sandstone of Ordovician age, and the Eau Claire and Mount Simon sandstones of Cambrian age. The St. Peter and Mount Simon are the most productive formations but the others supply some water to wells. Static water levels in the shallow aquifers have not declined to any great extent except in downtown Milwaukee, where a 50-foot-deep cone of depression exists. Static water levels in the sandstone aquifer declined as much as 350 feet in the Milwaukee area from 1880 through 1950. Recharge to the two shallow aquifers occurs locally from precipitation within the area. The major recharge area of the sandstone aquifer lies about 25 miles west of Wauwatosa. Some ground water is recharged to the sandstone aquifer locally by leakage from the Niagara dolomite, mostly through deep uncased wells. Ground water is the source of six municipal supplies and many industrial and commercial supplies in the area. Pumpage from deep wells has increased from about 2.5 mgd in 1900 to about 25 mgd in 1949, of which 6.0 mgd was derived from the shallow aquifers. The total withdrawal from the shallow aquifers, including the 6.0 mgd from the deep wells, was about 19.5 mgd in 1949. Thus the total in 1949 was 38.5 mgd for the area as a whole. Coefficients of transmissibility and storage for the sandstone aquifer were obtained by means of controlled pumping tests at Wauwatosa, Waukesha, Greendale, Town of Lake, and Jefferson. The coefficients were used to calculate the amount of water recharged from the Niagara dolomite to the sandstone aquifer in the area. About 5.5 mgd of the 23 mgd pumped from deep wells in 1950 was supplied locally by leakage from the Niagara dolomite. The coefficients, with corrections for boundaries, were also applied to past records of pumpage to calculate the water-level decline in the sandstone aquifer at Wauwatosa from 1880 through 1950. The calculated decline was 317 feet, and the actual decline was 307 feet. The future water-level decline in the sandstone aquifer at Wauwatosa resulting from estimated future pumping conditions was computed. If the pumpage in the area as ?. whole increases from about 23 mgd in 1950 to about 28 mgd in 1960, the water levels at Wauwatosa will decline as much as 65 feet more by 1960. It is estimated that the available recharge to the sandstone aquifer underlying the Milwaukee-Waukesha area is approximately 60 mgd. It is recommended that new deep wells be located to the west toward the recharge area and that the shallow aquifers be used as auxiliary sources to void excessive lowering of water levels in the sandstone aquifers. Conservation should be practiced by all users of ground water to avoid waste resulting in lower water levels and higher pumping costs.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 42.8444° to 43.1978° latitude; -88.5413° to -87.8268° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Frank Clingan Foley, W.C. Walton, W.J. Drescher. 1953. Ground-water conditions in the Milwaukee-Waukesha area, Wisconsin. https://doi.org/10.3133/wsp1229

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper

Sediment-quality assessment of Franklin D. Roosevelt Lake and the upstream reach of the Columbia River, Washington, 1992

Elevated concentrations of trace elements were found in bed sediment of Lake Roosevelt and the Columbia River, its principal source of inflow. Trace-element concentrations in whole water samples did not exceed criteria for freshwater organisms. Bed sediments of Lake Roosevelt were analyzed for organic compounds associated with wood-pulp waste. Dioxins and furans were found in suspended sediment and water of the Columbia River. Abundance and diversity of benthic invertebrate communities were analyzed.

Water Supply Paper