USGS Science⌕ Search

USGS · sir20095058

Hydrodynamic simulations of physical aquatic habitat availability for Pallid Sturgeon in the Lower Missouri River, at Yankton, South Dakota, Kenslers Bend, Nebraska, Little Sioux, Iowa, and Miami, Missouri, 2006-07

Abstract

The objective of this study was to assess the sensitivity of habitat availability in the Lower Missouri River to discharge variation, with emphasis on habitats that might support spawning of the endangered pallid sturgeon. We constructed computational hydrodynamic models for four reaches that were selected because of evidence that sturgeon have spawned in them. The reaches are located at Miami, Missouri (river mile 259.6–263.5), Little Sioux, Iowa (river mile 669.6–673.5), Kenslers Bend, Nebraska (river mile 743.9–748.1), and Yankton, South Dakota reach (river mile 804.8–808.4). The models were calibrated for a range of measured flow conditions, and run for a range of discharges that might be affected by flow modifications from Gavins Point Dam. Model performance was assessed by comparing modeled and measured water velocities. A selection of derived habitat units was assessed for sensitivity to hydraulic input parameters (drag coefficient and lateral eddy viscosity). Overall, model results were minimally sensitive to varying eddy viscosity; varying lateral eddy viscosity by 20 percent resulted in maximum change in habitat units of 5.4 percent. Shallow-water habitat units were most sensitive to variation in drag coefficient with 42 percent change in unit area resulting from 20 percent change in the parameter value; however, no habitat unit value changed more than 10 percent for a 10 percent variation in drag coefficient. Sensitivity analysis provides guidance for selecting habitat metrics that maximize information content while minimizing model uncertainties. To assess model sensitivities arising from topographic variation from sediment transport on an annual time scale, we constructed separate models from two complete independent surveys in 2006 and 2007. The net topographic change was minimal at each site; the ratio of net topographic change to water volume in the reaches at 95 percent exceedance flow was less than 5 percent, indicating that on a reach-average basis, annual topographic change contributed little to habitat area variation. Net erosion occurred at Yankton (the upstream reach) and because erosion was distributed uniformly, there was little affect on many habitat metrics. Topographic change was spatially nonuniform at Little Sioux and Kenslers Bend reaches. Shallow water habitat units and some reach-scale patch statistics (edge density, patch density, and Simpson’s Diversity Index) were affected by these changes. Erosion dominated at the downstream reach but habitat metrics did not vary substantially from 2006 to 2007. Among habitat metrics that were explored, zones of convergent flow were identified as areas that most closely correspond to spawning habitats of other sturgeon species, as identified in the scientific literature, and that are consistent with sparse data on pallid sturgeon spawning locations in the Lower Missouri River. Areas of convergent zone habitat varied little with discharges that would be associated with spring pulsed flows, and relations with discharge changed negligibly between 2006 and 2007. Other habitat measures show how physical habitat varies with discharge and among the four reaches. Wake habitats defined by velocity gradients seem to correspond with migration pathways of adult pallid sturgeon. Habitats with low Froude-number correspond to low energy areas that may accumulate passively transporting particles, organic matter, and larval fish. Among the modeled reaches, Yankton had substantially longer water residence time for equivalent flow exceedances than the other three modeled reaches. Longer residence times result from greater flow resistance in the relatively wide, shallow channel and may be associated with longer residence times of passively transported particulate materials.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 38° to 44° latitude; -100° to -88° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Robert B. Jacobson, Harold E. Johnson, Benjamin J. Dietsch. 2009. Hydrodynamic simulations of physical aquatic habitat availability for Pallid Sturgeon in the Lower Missouri River, at Yankton, South Dakota, Kenslers Bend, Nebraska, Little Sioux, Iowa, and Miami, Missouri, 2006-07. https://doi.org/10.3133/sir20095058

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Karst hydrologic processes in carbonate fensters of the western Great Smoky Mountains, Tennessee, 2017–18

The geology of the Great Smoky Mountains in Tennessee and North Carolina is dominated by metamorphic strata. Along the western extent of the range, however, several carbonate fensters expose the Ordovician Jonesboro Limestone along the western edge of the Great Smoky Fault. The fensters (Cades Cove, Tuckaleechee Cove, and Wear Cove) create opportunities for allogenic recharge at the contact between the surrounding, relatively insoluble, strata and the underlying soluble formations, resulting in the development of karst systems. Karst environments have a high degree of connectivity between surface streams and groundwater systems; thus, karst aquifers are inherently vulnerable to contamination from surface activities. Karst environments also provide a specific environment for sensitive biota. Protection of the unique resources of karst environments requires an understanding of the behavior of karst aquifers, knowledge of karst recharge areas, and the mapping of groundwater flow paths. A study began in 2017 to characterize the hydrologic behavior of the karst systems in Great Smoky Mountains National Park through hydrologic monitoring, dye tracing, and seepage investigations. Hydrologic monitoring equipment was installed at several karst hydrogeologic features: two in-cave sites, two major springs, Abrams Creek in Cades Cove, and a karst depression wetland. Dye tracing was conducted to determine resurgences for the cave systems, to delineate spring recharge areas, and to estimate karst groundwater velocities. Seepage investigations along Abrams Creek helped determine if streams were sinking into the Jonesboro Limestone, either at the contact with insoluble strata or as streams flowed across the carbonate fenster. Study results indicate considerable differences in groundwater behavior between the conduit-dominated flow systems in Tuckaleechee Cove compared to the lower-gradient, colluvium-covered karst systems in Cades Cove. Study results also indicate that contaminants in the area of Bull sink and Whiteoak Sink could be rapidly transported through karst groundwater towards springs in Tuckaleechee Cove. Karst resources in Cades Cove are most likely to be affected by local events or activities taking place within the cove itself or in upper Abrams Creek upstream of the Great Smoky Fault. This study provides information on the vulnerability and uniqueness of the karst systems in the western Great Smoky Mountains, which are characterized by complex geology, high-gradient subterranean streams, deep caves, and carbonate fensters.

Tennessee↗

Analysis of groundwater geochemistry in the Lansing, Michigan, area

Groundwater resources in the Lansing, Michigan, area are protected by a wellhead protection plan, but previous studies have indicated that groundwater in this area may be susceptible to surface contamination. The U.S. Geological Survey, in cooperation with the Lansing Board of Water & Light, analyzed geochemical and aquifer characteristics to assess the potential for contamination of groundwater resources. Recharge age categories were determined from tritium concentrations for some wells, and by using ternary diagrams and principal component analysis for other wells. These age classifications, combined with hydrogeologic and geochemical data, were analyzed by using statistical methods to identify trends that may indicate areas of increased groundwater susceptibility. Wells with modern recharge tended to have higher sodium, chloride, and chloride:bromide ratios than did wells with mixed recharge, suggesting greater surface connectivity and potential influence from anthropogenic sources such as road salt. In contrast, wells in the mixed age category exhibited more stable geochemistry and lower constituent concentrations. Classification and regression tree models identified aquifer geometry—particularly the thickness of the uppermost bedrock unit and presence of confining layers—as key predictors of recharge age and geochemical indicators. The trends identified from these analyses could help to reveal locations in the Lansing area that are among the most susceptible to contamination.

Michigan↗

Evaluating the number of realizations (train-test splits) necessary to ensure robust estimates of conventional hydrothermal resource favorability using Monte Carlo cross-validation, the Great Basin, Western USA

Supervised machine learning approaches used to produce favorability maps in resource assessments commonly partition an input dataset into training and testing subsets (that is, through train-test splits). However, if a single split is not representative of underlying resource conditions, the resulting favorability map may be biased, particularly with sparse or heterogeneous datasets. To mitigate the potential for unrepresentative favorability maps, recent works by U.S. Geological Survey researchers have used Monte Carlo cross-validation to implement a large number ( n) of randomized train-test splits to produce n realizations. The realizations are then aggregated using cell-wise median predictions to produce the resulting final favorability map, recognizing that the median will remove extreme values that might have been estimated from a comparatively few unrepresentative realizations. Theoretically, the median prediction at every cell converges to a single estimate as n approaches infinity, and the question addressed herein is: How many realizations are necessary to get a robust estimate (that is, an estimate unaffected by additional realizations)? Therefore, convergence metrics are described to identify the number of train-test splits and realizations needed to make a reliable map using the data and supervised machine learning workflow for conventional hydrothermal resource assessment of the Great Basin of the Western United States. For this study, robust prediction occurs with n approximately equal to 600 realizations, and smaller ensembles (for example, n is approximately equal to 200 or even 100) may be suitable during preliminary or exploratory analyses. Although the resulting threshold numbers will vary depending on the data and modeling approach used, the convergence metrics proposed and applied herein are applicable to other supervised machine learning studies that use Monte Carlo cross-validation.

California, Idaho, Nevada, Oregon, Utah↗