USGS ScienceSearch

USGS · pp378A

Geology and ore deposits of the South Silverton mining area, San Juan County, Colorado

Abstract

The South Silverton mining area is immediately southeast of the town of Silverton, San Juan County, in southwestern Colorado (fig. 1). The town of Silverton itself lies in a relatively flat and open reach of the Animas Valley, called Bakers Park, in the western part of the San Juan Mountains. (See figs. 2 and 8.) The roughly circular area of the geologic map map (pl. 1) includes about 18½ square miles of the mountainous country southeast of Silverton. It is bounded on the west and north by the Animas River, on the east by Cunningham Creek, and on the south by Mountaineer Creek and Deer Park Creek. Altitudes range from 9,125 feet above sea level in the canyon of the Animas, at the southwest corner of the area, to 13,451 feet on Kendall Peak, 2¾ miles to the northeast. Within this area nearly a dozen horn-like peaks and sharp ridges separated by deep glacial cirques rise to altitudes of 13,000 feet or more. (See figs. 3, 7, 10, and 24.) Exposures are excellent along the crests and upper flanks of the ridges, but the bedrock along the lower parts of the valley walls and floors of the cirques is largely concealed by accumulations of talus. The timbered slopes along the south side of the Animas Valley are extensively covered with glacial moraine. Several of the high basins within the cirques hold ponds or small lakes; the largest is Silver Lake (fig. 23). Roads skirt the northern and eastern edges of the area but none give good access into the interior. Silverton is adjacent to U.S. Highway 550, which passes over the mountains by way of Red Mountain Pass from Ouray, 24 miles to the north, to Durango, 53 miles to the south. The community is also served by the narrow-gage line of the Denver and Rio Grande Western Railroad that follows the Animas River upstream from Durango. A gravel road, State Highway 110, follows the Animas River upstream, eastward from Silverton. From this highway a side road branches off to Cunningham Gulch as far as the Highland Mary mill, and another goes up Arrastra Gulch for about 2 miles. The higher ridges east of Arrastra Basin are most easily reached by way of the Shenandoah-Dives aerial tram and mine workings. A few trails suitable for horses lead from the main valleys into the larger basins and across the intervening ridges, but much of the area is accessible only on foot. Most of the cirque heads and many of the high cliffs along Cunningham Gulch could not be examined at close range. Timberline is at about 11,500 feet.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 37.64° to 37.96° latitude; -107.97° to -107.46° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

David J. Varnes. 1963. Geology and ore deposits of the South Silverton mining area, San Juan County, Colorado. https://doi.org/10.3133/pp378a

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Resurvey of the Marble Canyon and Bridge Canyon dam sites in Grand Canyon National Park—Changes in sediment storage and evidence supporting the occurrence of bedrock incision through the mid-20th century

The Bureau of Reclamation developed an extensive plan for a network of dams, water tunnels, and hydropower plants in and around Grand Canyon, Arizona, in the 1940s through 1960s. The two largest of these planned dams were the Marble Canyon and Bridge Canyon Dams on the Colorado River. Though these dams were ultimately never built, Reclamation conducted extensive topographic, bathymetric, and subsurface exploration work at the sites proposed for these dams in the 1940s and 1950s. Resurveys of these dam sites were conducted between 1998 and 2021 to determine the changes in sediment storage at these dam sites caused by the upstream construction and operation of Glen Canyon Dam and by the recession of Lake Mead, the reservoir impounded by Hoover Dam. The resurveys of the Marble Canyon dam sites indicate that the post-1950s changes in sediment storage at these dam sites are broadly consistent with flux-based estimates of voluminous sand erosion from Marble Canyon since the 1963 closure of Glen Canyon Dam. These resurveys also suggest that the pre-dam longitudinal variation in sediment thickness over bedrock played a key role in determining the locations of the sand erosion induced by Glen Canyon Dam; more sand eroded from locations where more sand was present in the 1950s. The resurvey of the Bridge Canyon dam sites indicates that the Colorado River’s incision of the Lake Mead delta is regulated both by bed-sediment grain size and downstream hydraulic controls. Finally, analyses of bed-sediment thickness and sedimentological data at the dam sites, and observations of bed scour and gravel transport, suggest that sufficient bedrock was exposed to allow bedrock incision during commonly recurring pre-dam snowmelt floods that entrained small boulders into transport.

Arizona

The eruptive behavior of distributed volcanism forming low shield edifices—A case study of Sentinel-Arlington volcanic field, U.S.A.

Distributed volcanic fields are present in various tectonic settings worldwide, and their characteristics reflect differing influences from magmatic and tectonic processes. In the southwestern United States alone, there are 37 Quaternary distributed volcanic fields. After the primary period of extensional tectonics in the southern Basin and Range 15–5 million years ago, the Sentinel-Arlington volcanic field developed in southwestern Arizona between 4 and 1 million years ago. The Sentinel-Arlington volcanic field consists primarily of low relief shield volcanoes, a type of distributed volcanism with poorly understood temporal evolution. The Sentinel-Arlington volcanic field is less than 200 kilometers (km) from the Colorado Plateau, Gulf of California, and southern San Andreas Fault system. This work identifies and examines controls on the emplacement of the Sentinel-Arlington volcanic field by documenting shallow and surficial structures as well as eruption characteristics and style through time. The Sentinel-Arlington volcanic field consists of 21 volcanoes with a total of 33 vents over an area of about 770 square kilometers (km 2 ). The prominence of low relief shield volcanoes may be explained by ascent of basaltic magmas through thin Basin and Range crust, without much crustal contamination, and low viscosities common to mafic compositions. Typical eruption characteristics involve the construction of low relief shield volcanoes followed by Strombolian fissure eruptions at the summits or near-summit medial areas that produce scoria lapilli, which may weld to form agglomerate. The total lifetime erupted volume of about 4.3 cubic kilometers (km 3 ) represents an average eruptive flux of approximately 2x10 -3 km 3 per thousand years (k.y.). This erupted volume is low relative to Neogene basaltic intraplate distributed volcanic fields worldwide, which typically range from 10 -3 to 1 km 3 k.y. -1 . Sentinel-Arlington volcanic field eruptions were likely triggered by intermittent rejuvenation of transient magmatic zones that exist in thinned crust. Instantaneous flux from point sources feeding the lava flows is estimated to be on the order of 10 -1 to 10 cubic meters per second.

Arizona

Capitalization of positional (Lower/Middle/Upper) and temporal (Early/Middle/Late) adjectives in the names of formal chronostratigraphic and geochronologic units of the Phanerozoic

Many authors are understandably confused about the capitalization of the words “lower,” “middle,” “upper,” “early,” and “late.” Where these words are used simply as descriptive adjectives, they should be in lowercase; where they form the first word of a formal chronostratigraphic or geochronologic unit name, they should be in uppercase.

Professional Paper