USGS ScienceSearch

USGS · pp1064B

Composition and properties of the Pierre Shale and equivalent rocks, northern Great Plains region

Abstract

The Pierre Shale and equivalent rocks of Late Cretaceous age consist in the east-central Dakotas of several hundred feet of offshore-marine shale and minor marl; in west-central Montana near the sediment source the equivalents of the Pierre Shale consist of several thousand feet of volcanic-rich and mostly nonmarine sediments; and in the area between, both types of rock are separated by tongues of nearshore-marine siltstone and sandstone that mark three major transgressions of the sea across the area. The major-, minor-, and trace-element composition was determined for 226 samples of these rocks, and the mineralogical composition was determined for 1,350 samples. Slurry pH, Atterberg limits, and grain and bulk densities were determined on some samples. The arithmetic mean, in percent, and standard deviation (in parentheses) of major and minor elements, mostly in shale and siltstone and excluding the 23 chemically analyzed bentonite samples, are as follows: SiO2 60.8 (7.9) Al2O3 14.4 (2.5) Fe2O3 3.4 (1.4) FeO 1.1 (1.2) MgO 2.2 (1.0) CaO 2.7 (0.48) Na2O 1.1 (0.56) K2O 2.4 (0.57) H2O- 3.2 (1.3) H2O+ 4.3 (1.2) TiO2 0.58 (0.12) P2O5 0.14 (0.073) S 0.37 (1.1) F 0.71 (0.15) Cl 0.16 (0.024) CO2 2.1 (7.0) C, organic 0.94 (1.8) The mean and standard deviation of minerals as determined by X-ray methods, excluding bentonite samples, is as follows: clay minerals, 53 (20); quartz, 24 (13); cristobalite, 1 (5); potassium-feldspar, 1 (2); plagioclase, 6 (7); anorthite content from 20 to 40 percent; calcite, 5 (14); dolomite, 4 (7); organic matter, 1 (2); and sparsely scattered gypsum, jarosite, pyrite, zeolites, augite, siderite, and probably minor amounts of hydrated iron-manganese (Fe-Mn) oxides. The mean and standard deviation of the clay-mineral fraction is as follows: mixed-layer illite-smectite, 70 (20); illite, 16 (9); chlorite, 3 (6); and kaolinite, 9 (13). The mixed-layer clay, except in the Montana disturbed belt, is a random interlayering of 20 to 60 percent illite-type layers, about 35 percent beidelite-type layers, and the remainder montmorillonite-type layers; chlorite or vermiculite layers are rare. Most bentonite differs from shale in its small quartz content, rarely more than a few percent, in the more calcic composition and hightemperature thermal state of its plagioclase, and in its rare kaolinite, near absence of chlorite, and lack of illite-either free or mixed layered with smectite. Bentonite commonly consists of more than 90 percent smectite in which montmorillonite is interlayered with a smaller amount of beidellite. The clay-mineral composition of marine rock, including proportions of layers in the dominant illite-smectite, averages about the same as in the nonmarine rock, though in the latter the composition is more variable. The average content of major chemical constituents also is closely similar, partly because the large clay content of fine-grained offshore-marine shale is balanced by the small clay content of nearshore-marine siltstone and sandstone. In addition, the alumina and alkalic elements in an average of 10 percent more clay in marine rock are partly balanced by these constituents in the 5 percent more feldspar in nonmarine rock. Much of the observed regional and stratigraphic variation in maj or constituents is the result of the three major east-west migrations of the depositional sites of nearshore-marine sandstone and siltstone. Dolomite is found almost exclusively in relatively coarse-grained rock, particularly in nearshore-marine siltstone where diagenetic dolomite is expected, but it is found almost as frequently in nonmarine siltstone. Amounts of minor constituents are nearly equal in marine and nonmarine rocks, except that pyrite and consequently sulfur are relatively sparse in nonmarine rock. Average amounts of organic matter found in marine and nonmarine rocks are nearly identical. However, organic matter in nonmarine rock occurs almost entirely in volumetric

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 42.482749° to 49.000912° latitude; -116.049193° to -96.439335° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Leonard Gene Schultz, H. A. Tourtelot, J. R. Gill, J.G. Boerngen. 1980. Composition and properties of the Pierre Shale and equivalent rocks, northern Great Plains region. https://doi.org/10.3133/pp1064b

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Resurvey of the Marble Canyon and Bridge Canyon dam sites in Grand Canyon National Park—Changes in sediment storage and evidence supporting the occurrence of bedrock incision through the mid-20th century

The Bureau of Reclamation developed an extensive plan for a network of dams, water tunnels, and hydropower plants in and around Grand Canyon, Arizona, in the 1940s through 1960s. The two largest of these planned dams were the Marble Canyon and Bridge Canyon Dams on the Colorado River. Though these dams were ultimately never built, Reclamation conducted extensive topographic, bathymetric, and subsurface exploration work at the sites proposed for these dams in the 1940s and 1950s. Resurveys of these dam sites were conducted between 1998 and 2021 to determine the changes in sediment storage at these dam sites caused by the upstream construction and operation of Glen Canyon Dam and by the recession of Lake Mead, the reservoir impounded by Hoover Dam. The resurveys of the Marble Canyon dam sites indicate that the post-1950s changes in sediment storage at these dam sites are broadly consistent with flux-based estimates of voluminous sand erosion from Marble Canyon since the 1963 closure of Glen Canyon Dam. These resurveys also suggest that the pre-dam longitudinal variation in sediment thickness over bedrock played a key role in determining the locations of the sand erosion induced by Glen Canyon Dam; more sand eroded from locations where more sand was present in the 1950s. The resurvey of the Bridge Canyon dam sites indicates that the Colorado River’s incision of the Lake Mead delta is regulated both by bed-sediment grain size and downstream hydraulic controls. Finally, analyses of bed-sediment thickness and sedimentological data at the dam sites, and observations of bed scour and gravel transport, suggest that sufficient bedrock was exposed to allow bedrock incision during commonly recurring pre-dam snowmelt floods that entrained small boulders into transport.

Arizona

The eruptive behavior of distributed volcanism forming low shield edifices—A case study of Sentinel-Arlington volcanic field, U.S.A.

Distributed volcanic fields are present in various tectonic settings worldwide, and their characteristics reflect differing influences from magmatic and tectonic processes. In the southwestern United States alone, there are 37 Quaternary distributed volcanic fields. After the primary period of extensional tectonics in the southern Basin and Range 15–5 million years ago, the Sentinel-Arlington volcanic field developed in southwestern Arizona between 4 and 1 million years ago. The Sentinel-Arlington volcanic field consists primarily of low relief shield volcanoes, a type of distributed volcanism with poorly understood temporal evolution. The Sentinel-Arlington volcanic field is less than 200 kilometers (km) from the Colorado Plateau, Gulf of California, and southern San Andreas Fault system. This work identifies and examines controls on the emplacement of the Sentinel-Arlington volcanic field by documenting shallow and surficial structures as well as eruption characteristics and style through time. The Sentinel-Arlington volcanic field consists of 21 volcanoes with a total of 33 vents over an area of about 770 square kilometers (km 2 ). The prominence of low relief shield volcanoes may be explained by ascent of basaltic magmas through thin Basin and Range crust, without much crustal contamination, and low viscosities common to mafic compositions. Typical eruption characteristics involve the construction of low relief shield volcanoes followed by Strombolian fissure eruptions at the summits or near-summit medial areas that produce scoria lapilli, which may weld to form agglomerate. The total lifetime erupted volume of about 4.3 cubic kilometers (km 3 ) represents an average eruptive flux of approximately 2x10 -3 km 3 per thousand years (k.y.). This erupted volume is low relative to Neogene basaltic intraplate distributed volcanic fields worldwide, which typically range from 10 -3 to 1 km 3 k.y. -1 . Sentinel-Arlington volcanic field eruptions were likely triggered by intermittent rejuvenation of transient magmatic zones that exist in thinned crust. Instantaneous flux from point sources feeding the lava flows is estimated to be on the order of 10 -1 to 10 cubic meters per second.

Arizona

Capitalization of positional (Lower/Middle/Upper) and temporal (Early/Middle/Late) adjectives in the names of formal chronostratigraphic and geochronologic units of the Phanerozoic

Many authors are understandably confused about the capitalization of the words “lower,” “middle,” “upper,” “early,” and “late.” Where these words are used simply as descriptive adjectives, they should be in lowercase; where they form the first word of a formal chronostratigraphic or geochronologic unit name, they should be in uppercase.

Professional Paper