USGS Science⌕ Search
Home/Archive/USGS

USGS · 70279694

WellSTIC: A cost-effective sensor for performing point dilution tests to measure groundwater velocity in shallow aquifers

Zach Perzan·Thomas Chapin
View original source ↗Export metadata ↓

Abstract

Many individual measurement points are required to characterize groundwater velocity within an aquifer. Groundwater velocity is most commonly measured using a network of >5 cm diameter monitoring wells, which, if not already present at a site, are expensive and labor-intensive to install. Drive-point piezometers—simple, cost-effective wells that can be installed by hand—are a common tool for sampling groundwater in shallow, alluvial aquifers, but most groundwater velocity measurement techniques require equipment that is too large for these narrow (usually <2 cm inside diameter) piezometers. In this technical note, we introduce a low-cost sensor and well packer system (<$90 USD) for performing point dilution tests in narrow piezometers. Field data show that the magnitude of groundwater velocity measured with this technique agrees with velocities computed from natural gradient tracer tests. Additionally, with proper calibration, these sensors can be used to continuously monitor in-well specific conductance, either during inter-well tracer tests with saline tracers or for water quality monitoring. This system is a viable tool for rapid assessment of the magnitude of groundwater velocity in shallow aquifers.

Explore related subjects

Water Resources ResearchArticle

Keep this discovery

BibTeXRIS

Zach Perzan, Thomas Chapin. 2023-01-17. WellSTIC: A cost-effective sensor for performing point dilution tests to measure groundwater velocity in shallow aquifers. https://doi.org/10.1029/2022wr033223

Cite the original work for its findings. Save a collection to share your selection of sources.

Discover connections

Article subjectWater Resources Research subject

Connections use source metadata and explicit phrase matches, not verified experimental comparisons.

KEEP EXPLORING

Related discoveries

USGS2025

Natural source zone depletion of crude oil in the subsurface: Processes controlling mass losses of individual compounds

At many petroleum hydrocarbon spill sites, residual spilled product forms a long-term source of groundwater contamination. The phrase source zone natural depletion is used to refer to the mass loss rates. Overall mass lost under environmental conditions was analyzed using conservative biomarker concentrations for a 1979 oil spill in northern Minnesota, USA. After 40–41 years, an average of 50% of the mass was lost with values ranging from 22% to 57% depending on location. It is also important to understand the composition changes in the source. To understand controls on the losses of individual compounds, concentrations of volatile hydrocarbons in oil samples were compared with aqueous solubilities, and pore-space oil saturations. The results of the comparison show that losses of the oil compounds were controlled by pore-space oil saturations, solubility, and susceptibility to degradation under methanogenic conditions. Compounds that degrade under methanogenic conditions, including toluene, o -xylene, and n -alkanes are more depleted compared to benzene, ethylbenzene, and m - and p -xylene for which losses are dominated by dissolution. These rates and compound-specific behaviors form a foundation for improved modeling approaches and risk analyses.

Minnesota↗
USGS2026

Modeling legacy nitrogen transport under instantaneous, steady-state, and transient groundwater flow conditions

In hydrologic settings where groundwater discharge contributes substantially to surface waters, legacy nitrogen in groundwater can confound surface water nitrogen loads estimated exclusively from current terrestrial sources. Additionally, legacy nitrogen in groundwater can contribute to lagged responses to nitrogen management efforts. Some methods of estimating groundwater contributions to surface water nitrogen loads account for legacy nitrogen, while others do not. The resulting differences are rarely quantified. We used a numerical modeling framework to compare three methods of estimating time-varying annual groundwater nitrogen loads to surface water receptors on eastern Long Island, New York. The instantaneous load method used steady-state contributing areas and includes no temporal groundwater lag. The second method used numerical simulations of nitrogen loads under steady-state flow, which captures groundwater transport lags but omits the annual variability in transient hydrologic stresses. The third method numerically simulated both transient groundwater flow and nitrogen transport to explicitly capture the effects of legacy nitrogen in groundwater. Depending on antecedent nitrogen and hydrologic conditions, historical nitrogen loads estimated from the numerical simulations were sometimes similar (<10% difference) and other times substantially different (±100%) from the instantaneous load estimates. Additionally, simulated future surface water nitrogen loads responded asymptotically over several decades following reductions in terrestrial nitrogen sources, further highlighting the effect of groundwater transport lag times. The comparison of the three methods, quantification of historical interannual variability, and prediction of lagged responses to nitrogen source reductions provide important context for decision makers using estimated groundwater nitrogen loads to help evaluate nitrogen management efficacy.

New York↗
USGS2026

A roadmap for identifying and interpreting physical processes and national water model prediction bias associated with baseflow index regimes across the contiguous United States

Understanding how groundwater–surface water interactions shape streamflow variability is critical for diagnosing low flow behavior and prediction bias in continental scale hydrologic models. We present a process informed framework that links observed baseflow (BF) dynamics, watershed attributes, and National Water Model (NWM) performance across the contiguous United States. Using daily observed streamflow from 797 reference quality streamgages, we developed monthly baseflow index (BFI) signatures using a streamgage specific, calibrated digital filter. Hierarchical clustering of these signatures identified seven distinct BFI regimes capturing regional and seasonal variability. We evaluated NWM v3.0 retrospective streamflow performance within each regime using multiple hydrograph and flow duration curve-based metrics. Model skill varied systematically across regimes: mixed flow systems were simulated most accurately, while predominantly BF dominated and quickflow dominated regimes exhibited substantially poorer performance. Across nearly all regimes, the NWM underestimated observed BFI magnitude and frequently failed to reproduce seasonal BF patterns, indicating systematic biases in simulated low flow contributions. To relate these regimes to potential process controls, we trained a Random Forest classifier using static watershed attributes and applied Shapley Additive Explanations to identify features most strongly associated with each regime. Results highlight regionally varying influences, including the dominant role of snow fraction and seasonal runoff timing in snow dominated basins and the importance of evapotranspiration and aridity in quickflow dominated systems. Collectively, these findings demonstrate how hydrologic signatures combined with interpretable machine learning can diagnose regime specific model biases and generate process-based hypotheses about limitations in large scale hydrologic prediction systems.

contiguous United States↗