USGS ScienceSearch

USGS · 70277754

The impact of 3D structure on coseismic coastal land-level change and tsunami generation in the Cascadia Subduction Zone

Abstract

Estimates of coseismic vertical displacements from past and potential future subduction zone earthquakes provide critical constraints on regional seismic and tsunami hazard. Many studies use elastic homogeneous half-space models to calculate vertical displacements from a specified earthquake slip distribution, neglecting complexities of 3D structure in subduction zone settings. Here, we use 3D ground motion simulations of potential Cascadia Subduction Zone earthquakes to investigate the impact of realistic 3D Earth structure on estimated vertical displacements. We show that offshore uplift increases when including 3D structure due to high fault slip in low-rigidity accretionary wedge sediments and coastal subsidence decreases due to higher rigidity material at depth. These larger offshore uplifts cause increased tsunami maximum wave heights, and coastal subsidence at paleoseismic sites decreases on average by ∼17 cm, or ∼60%, which can have important implications for the amplitude and extent of slip in earthquake scenarios developed based on paleoseismic data constraints.

Explore related subjects

Keep this discovery

BibTeXRIS

Audrey M. Dunham, Jeonghyeop Kim, Erin A. Wirth, David A. Schmidt, Randy J. LeVeque, Yong Wei, Loyce M. Adams, Frederick Pollitz. 2025-12-23. The impact of 3D structure on coseismic coastal land-level change and tsunami generation in the Cascadia Subduction Zone. https://doi.org/10.1029/2025gl117783

Cite the original work for its findings. Save a collection to share your selection of sources.

Discover connections

Connections use source metadata and explicit phrase matches, not verified experimental comparisons.

KEEP EXPLORING

Related discoveries

Subsurface vertical connectivity shapes solute transport to montane streams: Insights from watershed-scale geophysics-informed modeling

Headwater catchments provide essential water and nutrients to downstream ecosystems. The timing and evolution of their transport is shaped in part by the “invisible” subsurface structure but have been largely unexplored at the watershed scale. This raises a fundamental question: how and to what extent does subsurface structure influence streamflow and solute transport in montane watersheds? Here, we test controls of three-dimensionally resolved subsurface structure on solute transport, which reflects source waters and water residence time. We integrate the geophysically mapped architecture of Coal Creek, a headwater catchment in the Colorado River Basin, into numerical flow-transport models. Our results reveal greater vertical connectivity elongates flow paths and enhances deep groundwater contributions to streams, therefore substantially influencing the timing and magnitude of solute transport. In contrast, watershed-integrated outlet discharge can be predicted without high-resolution subsurface information. These findings demonstrate incorporating subsurface architecture is critical for predicting ecosystem health and contaminant transport.

Colorado

Mechanics and statistics of postseismic shaking

Analysis of two weeks of continuous post-seismic shaking after the 2019 M7.1 Ridgecrest, CA earthquake sequence using 4 nearby borehole seismometers reveals that continuous ground motions decay as Omori’s law in time and follow the Gutenberg-Richter distribution in logarithmic amplitude. The measured temporal decay in amplitudes agrees with predictions of the rate-and-state framework and indicates shaking amplitudes are proportional to the velocity of afterslip. Our ground motion-based statistical framework provides a basis to forecast shaking intensity in the minutes to hours after a large earthquake.

California

S/P amplitude ratios with Distributed Acoustic Sensing and application to earthquake focal mechanisms

Distributed acoustic sensing (DAS), which transforms a fiber optic cable into an array of high frequency strainmeters, has the potential to help us characterize earthquakes with a dense sampling of measurements. While earthquake focal mechanisms are frequently determined using P -wave polarities and S / P amplitude ratios with inertial seismometers, the dense sampling of DAS over potentially large portions of the focal sphere can aid our solutions. Here, we consider ∼200 regional earthquakes and thousands of S / P measurements on a DAS cable colocated with a network of inertial seismometers near Arcata, California. We demonstrate the S / P ratio measurements made on DAS are similar to those made on the inertial seismometers and can be used to constrain focal mechanism solutions.

California