EXPLORE THE ARCHIVE

Frederick Pollitz

Publications and source records attributed to Frederick Pollitz.

5 recordsLinked to original sources

USGS2026

New constraints on northeast Seattle basin structure from converted seismic waves

The Seattle basin is a deep sedimentary basin in the Seattle–Bellevue, Washington metropolitan area within the Puget Lowland of Washington State. We determine the structure of a portion of the basin and the underlying basement using analysis of P waves converted from direct S incident from below. A deep local crustal event beneath Monroe, about 35 km northeast of Seattle, was recorded by a 100‐station nodal array deployed in 2019. The event produced a variety of coherent seismic phases, including converted waves from the sediment—basement boundary, internal structure within the basin, and additional crustal discontinuities. Using observed Sp converted waves, we apply an adjoint‐based full waveform inversion (FWI) method to determine the amplitude and extent of seismic discontinuities at depth. We find the strongest source of converted waves for this event lies ∼6 to 7 km depth below northern Lake Washington, interpreted to be the local depth to basement rock. The newly imaged shallow basement structure may be part of a deformation zone associated with the Siletzia eastern boundary. Our results highlight the utility of converted seismic waves recorded by a dense array, combined with an FWI method, to illuminate crustal structure.

Washington↗

USGS2025

The impact of 3D structure on coseismic coastal land-level change and tsunami generation in the Cascadia Subduction Zone

Estimates of coseismic vertical displacements from past and potential future subduction zone earthquakes provide critical constraints on regional seismic and tsunami hazard. Many studies use elastic homogeneous half-space models to calculate vertical displacements from a specified earthquake slip distribution, neglecting complexities of 3D structure in subduction zone settings. Here, we use 3D ground motion simulations of potential Cascadia Subduction Zone earthquakes to investigate the impact of realistic 3D Earth structure on estimated vertical displacements. We show that offshore uplift increases when including 3D structure due to high fault slip in low-rigidity accretionary wedge sediments and coastal subsidence decreases due to higher rigidity material at depth. These larger offshore uplifts cause increased tsunami maximum wave heights, and coastal subsidence at paleoseismic sites decreases on average by ∼17 cm, or ∼60%, which can have important implications for the amplitude and extent of slip in earthquake scenarios developed based on paleoseismic data constraints.

California, Oregon, Washington↗

USGS2025

3D Converted wave reverse time migration imaging

We describe a newly developed method for recovering high-resolution images of seismic discontinuities, such as subducting slabs, in 3D. Our method makes use of converted S → P or P → S waves observed by dense arrays of seismometers to infer the locations and relative strengths of seismic discontinuities at depth in a target region. Observed direct and converted waves are backpropagated to their times of origin. The time-reversed wavefield is then separated into its constituent P and S components via the Helmholtz decomposition, and those separated wavefields are used to compute imaging functions that characterize the locations and relative strengths of seismic discontinuities. Imaging functions may be designed to use either S → P or P → S waves, so that users can target those arrivals expected to be most dominant in a given dataset. We have previously demonstrated the efficacy of our method in two dimensions, and we now present a 3D implementation of our technique which addresses the significant computational challenges posed by the size of volumetric wavefield data in three dimensions. Through a series of synthetic examples, we demonstrate that our method is capable of recovering the fine scale structure of a subducting slab given realistic station coverage and earthquake sources. We investigate optimal seismic station geometries for our technique and explore image interpretability in regions with poor data coverage. We find that linear station geometries yield more optimal, interpretable imaging functions than collections of small arrays can. We also show that our method can successfully recover bothS → P or P → S images when realistic shear earthquake sources are used, and we explore the additional computational challenges presented by the high frequency content of S waves. Our results demonstrate the potential for our technique to recover high-resolution information about subducting slabs in real-world regions, given that relatively sparse seismic arrays with only approximately 100 stations are capable of recovering interpretable imaging functions from just a few realistic earthquake sources for multiple discontinuities at significant depth in an area of approximately 400~sq~km.

Seismica↗

USGS2025

A scientific vision and roadmap for earthquake rupture forecast developments, a USGS perspective

We articulate a scientific vision and roadmap for the development of improved Earthquake Rupture Forecast models, which are one of the two main modeling components used in modern seismic hazard and risk analysis. One primary future objective is to provide fully time-dependent models that include both elastic rebound and spatiotemporal clustering nationwide, which is particularly important for shorter-term hazard and risk considerations (e.g., earthquake insurance products). We also discuss the importance and perennial challenges associated with quantifying epistemic uncertainties, including those associated with deformation-model slip rates, un-quantified sampling errors with respect to off-fault seismicity, and any spatial covariances. The need for more physics-based approaches is also emphasized, as is the benefit of adding model valuation (quantifying usefulness) to our verification and validation protocols. Given the multidisciplinary and system-level nature of this activity, modular design is critical. Future updates will also draw from best-available science by both the United States Geological Survey and the external community. The primary goal of this paper is to highlight plans that guide research and facilitate community engagement with model development, especially with respect to lowering the entry barrier for early career scientists and engineers. The paper is written so readers can focus on the sections that interest them most (see table of contents), with the Introduction and Discussion providing a stand-alone overview and summary.

Bulletin of the Seismological Society of America↗

USGS2025

Rupture process of the Mw7.0 December 5, 2024 Offshore Cape Mendocino earthquake

The Mw7.0 December 5, 2024 Offshore Cape Mendocino earthquake ruptured a km long portion of the east-west trending Mendocino fault zone (MFZ). In order to clarify the rupture process, we assemble three-component seismograms from regional seismic stations, horizontal coseismic displacement vectors derived from Global Navigation Satellite System (GNSS) time series, and a Sentinel-1 ascending interferogram. These data are interpreted with a model of slip distributed on two vertical fault planes representative of the eastern MFZ and spanning the ~70 km length of the aftershock zone. Assuming right-lateral strike slip, we find that the rupture initiates in the oceanic mantle at 20-30 km depth and proceeds unilaterally updip and toward the east. Early aftershocks locate adjacent to the peak slip areas, tracking the coseismic rupture propagation from oceanic mantle to shallower depth and implying a significant role of static stress transfer in driving aftershocks in an ocean plate environment.

California↗