USGS Science⌕ Search

USGS · 70014966

Lateral blasts at Mount St. Helens and hazard zonation

Abstract

Lateral blasts at andesitic and dacitic volcanoes can produce a variety of direct hazards, including ballistic projectiles which can be thrown to distances of at least 10 km and pyroclastic density flows which can travel at high speed to distances of more than 30 km. Indirect effect that may accompany such explosions include wind-borne ash, pyroclastic flows formed by the remobilization of rock debris thrown onto sloping ground, and lahars. Two lateral blasts occurred at a lava dome on the north flank of Mount St. Helens about 1200 years ago; the more energetic of these threw rock debris northeastward across a sector of about 30?? to a distance of at least 10 km. The ballistic debris fell onto an area estimated to be 50 km2, and wind-transported ash and lapilli derived from the lateral-blast cloud fell on an additional lobate area of at least 200 km2. In contrast, the vastly larger lateral blast of May 18, 1980, created a devastating pyroclastic density flow that covered a sector of as much as 180??, reached a maximum distance of 28 km, and within a few minutes directly affected an area of about 550 km2. The May 18 lateral blast resulted from the sudden, landslide-induced depressurization of a dacite cryptodome and the hydrothermal system that surrounded it within the volcano. We propose that lateral-blast hazard assessments for lava domes include an adjoining hazard zone with a radius of at least 10 km. Although a lateral blast can occur on any side of a dome, the sector directly affected by any one blast probably will be less than 180??. Nevertheless, a circular hazard zone centered on the dome is suggested because of the difficulty of predicting the direction of a lateral blast. For the purpose of long-term land-use planning, a hazard assessment for lateral blasts caused by explosions of magma bodies or pressurized hydrothermal systems within a symmetrical volcano could designate a circular potential hazard area with a radius of 35 km centered on the volcano. For short-term hazard assessments, if seismicity and deformation indicate that magma is moving toward the flank of a volcano, it should be recognized that a landslide could lead to the sudden unloading of a magmatic or hydrothermal system and thereby cause a catastrophic lateral blast. A hazard assessment should assume that a lateral blast could directly affect an area at least 180?? wide to a distance of 35 km from the site of the explosion, irrespective of topography. ?? 1986 Springer-Verlag.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

D. R. Crandell, R. Hoblitt. 1986. Lateral blasts at Mount St. Helens and hazard zonation. https://doi.org/10.1007/bf01073511

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Geophysical insights into Kīlauea’s eruptive reawakening after its 2018 eruption and caldera collapse

A little more than two years after the destructive 2018 lower East Rift Zone eruption and summit collapse ended, renewed volcanic activity began at Kīlauea volcano, Hawaiʻi. During 2020–2025, activity at the volcano included six eruptions in the summit caldera, one in the Southwest Rift Zone, and one in the middle East Rift Zone, as well as multiple non-eruptive intrusions in all three locations. We categorize the volcano’s activity post-2018 into four phases based on eruption locations and style, as well as patterns of magma storage and migration inferred from geophysical data. In some cases, these observations illuminated parts of the volcano’s magmatic system for the first time since the advent of modern geophysical monitoring—particularly deformation datasets that include tilt, continuous GNSS, and InSAR. Analyses of these geodetic data and complementary seismic, geological, and geochemical observations provide an opportunity to explore summit and rift zone connectivity, rift-zone magma storage conditions, the variable geophysical manifestations of eruption onsets, magma-fault interactions, and other long-standing questions associated with eruptions and intrusions at Kīlauea.

Hawaii↗

An extensive and short-lived episode of mid-Holocene fayalite- bearing high-silica rhyolite eruptions at Mono Craters, California

Having last erupted ~ 700 years ago, the Mono Craters volcanic chain is an active system with a history of explosive and effusive high-silica rhyolite eruptions. Approximately ~ 30 lava domes and flows range from ~ 42 to ~ 0.7 ka, form a ~ 15 km curvilinear trend, and change mineralogy (biotite-, orthopyroxene-, or fayalite-bearing) and crystallinity through time. However, the eruptive chronology of this system is incompletely understood. We report new 238 U- 230 Th isochron ages for nine fayalite-bearing domes from paired zircon and allanite crystal surfaces that reveal a major shift in eruptive frequency and volume over the history of the chain, with extrusion of > 0.45 km 3 of high-silica rhyolite lava between 7.1 and 5.2 ka. This contrasts with older biotite- (~ 42–20 ka) and orthopyroxene-bearing (~ 12–9 ka) domes, each of which erupted smaller volumes over a more protracted period. Whole-rock compositions suggest these older domes tapped separate domains within a shared magmatic system because the former are higher in Sr and Ba whereas the latter are lower in SiO 2 , higher in Zr, and more enriched in light rare-earth elements. Titanomagnetite chemistry and zircon saturation temperatures also reflect changing magma compositions and conditions associated with these domes. Fayalite-bearing domes, in contrast, have uniform whole-rock and titanomagnetite compositions which support rapid extrusion of magma over an interval short enough to prevent Fe-Ti oxides from recording any changes in magmatic conditions. The youngest lavas were also produced in a short-lived episode ~ 700 years ago, showing that multivent, geologically brief eruptive episodes occur repeatedly at Mono Craters.

California↗

Satellite observations, plume dynamics and volcanic lightning from the 2023 eruption of Shishaldin Volcano, Alaska

The 2023 eruption of Shishaldin Volcano, Alaska, provided an unusually well-monitored example of a “dry” (non-hydromagmatic) explosive basaltic eruption with sustained, buoyant plumes, and pyroclastic density currents. Here, we examine the 13 basaltic paroxysms that occurred between July and November 2023 using geostationary satellite observations, plume modeling, and volcanic lightning detection to characterize mass eruption rates and plume dynamics. We show that seven volcanic plumes reached 10–14 km above sea level, sustained for minutes to tens of minutes. Translating plume heights into mass eruption rates, using both empirical scaling and one-dimensional plume modeling, gives peak rates of 10 4 –10 7 kg·s −1 and a total erupted volume of ~ 0.05 km 3 (dense rock equivalent) across the eruption sequence. Despite the moderate intensity of this eruption, automated satellite detection algorithms generally failed to detect volcanic ash. We attribute this persistent challenge to the fines-poor grain size distribution of the eruption. Volcanic lightning provides an additional window into the eruption dynamics. A total of 491 volcanic lightning flashes were detected, concentrated during seven of the most energetic phases. The timing of this electrical activity suggests that lightning only became detectable by the global lightning monitoring network when plumes ascended to atmospheric levels favorable for ice formation. Based on the available data, we infer that the low fine ash content of the plumes, combined with minimal water and ice, led to the overall modest rates of lightning (1–13 flashes per minute) compared to “wet” eruptions of similar intensity. These results show that combining satellite observations, plume modeling, and lightning detection provides a valuable timeline of eruptive intensity, even for “dry” basaltic eruptions in remote locations.

Alaska↗