Geology topics

Research about St. Paul, Minnesota

Source-linked reports with geographic coverage including St. Paul, Minnesota.

3 recordsLinked to original sources

USGS2013

Perfluorinated compound concentrations in great blue heron eggs near St. Paul, Minnesota, USA, in 1993 and 2010-2011

A great blue heron (Ardea herodias) colony on Pig's Eye Island on the Mississippi River near St. Paul, Minnesota, USA, is located near several potential perfluorinated compound (PFC) sources. The PFC concentrations in great blue heron eggs reported from a 1993 collection from the Pig's Eye colony were among the highest measured in bird eggs worldwide. The objective of this investigation was to determine whether PFC concentrations in great blue heron eggs at the Pig's Eye colony have changed since 1993. Total PFC concentrations in great blue heron eggs collected at the Pig's Eye colony in 2010 and 2011 (geometric mean = 340 and 492 ng/g wet wt) were 60% lower than the 1993 collection (1,015 ng/g wet wt). Among PFCs, perfluoroalkyl sulfonate concentrations were lower and perfluoroalkyl carboxylate concentrations were higher in the 2010 and 2011 collections. Two of 20 (10%) of the eggs analyzed from Pig's Eye in 2010 and 2011 were >1,000 ng PFCs/g wet weight and the maximum PFC value (2,506 ng PFCs/g wet wt) measured in 2010 and 2011 was among the highest PFC concentration reported in bird eggs. These high concentrations are at levels associated with physiological and neurological effects in birds.

Minnesota↗

USGS2002

Cyclic injection, storage, and withdrawal of heated water in a sandstone aquifer at St. Paul, Minnesota--Analysis of thermal data and nonisothermal modeling of short-term test cycles

In May 1980, the University of Minnesota began a project to evaluate the feasibility of storing heated water (150 degrees Celsius) in the Franconia-Ironton Galesville aquifer (183 to 245 meters below land surface) and later recovering it for space heating. The University's steam-generation facilities supplied high-temperature water for injection. The Aquifer Thermal-Energy Storage system is a doublet-well design in which the injection-withdrawal wells are spaced approximately 250 meters apart. Water was pumped from one of the wells through a heat exchanger, where heat was added or removed. This water was then injected back into the aquifer through the other well. Four short-term test cycles were completed. Each cycle consisted of approximately equal durations of injection and withdrawal ranging from 5.25 to 8.01 days. Equal rates of injection and withdrawal, ranging from 17.4 to 18.6 liters per second, were maintained for each short-term test cycle. Average injection temperatures ranged from 88.5 to 117.9 degrees Celsius. Temperature graphs for selected depths at individual observation wells indicate that the Ironton and Galesville Sandstones received and stored more thermal energy than the upper part of the Franconia Formation. Clogging of the Ironton Sandstone was possibly due to precipitation of calcium carbonate or movement of fine-grain material or both. Vertical-profile plots indicate that the effects of buoyancy flow were small within the aquifer. A three-dimensional, anisotropic, nonisothermal, ground-water-flow, and thermal-energy-transport model was constructed to simulate the four short-term test cycles. The model was used to simulate the entire short-term testing period of approximately 400 days. The only model properties varied during model calibration were longitudinal and transverse thermal dispersivities, which, for final calibration, were simulated as 3.3 and 0.33 meters, respectively. The model was calibrated by comparing model-computed results to (1) measured temperatures at selected altitudes in four observation wells, (2) measured temperatures at the production well, and (3) calculated thermal efficiencies of the aquifer. Model-computed withdrawal-water temperatures were within an average of about 3 percent of measured values and model-computed aquifer-thermal efficiencies were within an average of about 5 percent of calculated values for the short-term test cycles. These data indicate that the model accurately simulated thermal-energy storage within the Franconia-Ironton-Galesville aquifer.

Minnesota↗

USGS1989

Cyclic injection, storage, and withdrawal of heated water in a sandstone aquifer at St. Paul, Minnesota: Field observations, preliminary model analysis, and aquifer thermal efficiency

In May 1980, the University of Minnesota began a project to evaluate the feasibility of storing heated (150 °C (degree Celsius)) water in the deep (180 to 240 m (meters)) Franconia-Ironton-Galesville aquifer and later recovering it for space heating. The Aquifer Thermal-Energy Storage (ATES) system was doublet-well design in which the injection/withdrawal wells were spaced approximately 250 m apart. High-temperature water from the University's steam-generation facilities supplied heat for injection. Water was pumped from one of the wells through a heat exchanger, where heat was added or removed. Water then was injected back into the aquifer through the other well. The experimental plan for testing the ATES system consisted of a series of short-term hot-water injection, storage, and withdrawal cycles. Each cycle was 24-days long, and each injection, storage, and withdrawal step of the cycle was 8 days. The Franconia-Ironton-Galesville aquifer is a consolidated sandstone, approximately 60 m thick, the top of which is approximately 180 m below the land surface. It is confined above by the St. Lawrence Formation--a dolomitic sandstone 8-m thick--and below by the Eau Claire Formation--a shale 30-m thick. Initial hydraulic testing with inflatable packers indicated that the aquifer has four hydraulic zones with distinctly different values of relative horizontal hydraulic conductivity. The thickness of each zone was determined by correlating data from geophysical logs, core samples, and the inflatablepacker tests.

Minnesota↗