USGS Science⌕ Search

SEARCH · USGS Science

Results for “Geologic Investigation”

Search indexed USGS publications on groundwater, aquifers, geologic maps, mineral resources and earthquakes. Explore source records by subject and place.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5Linked to original sources
USGS1979

Preliminary geologic investigation of the West Glendive lignite deposits, Dawson County, Montana

Four major lignite beds, all in the Fort Union Formation (Paleocene), occur in the West Glendive area, Dawson County, Montana. The Newton Ranch and Poverty Flats beds are in the Lebo Member and the Peuse and Kolberg Ranch beds are in the Tongue River Member. Correlation of the lignite beds across the area shows that the Peuse bed is the thickest and most extensive. Field mapping and drill-hole data indicate that folding and faulting are more common than previously reported.

Open-File Report↗
USGS1982

Preliminary geological investigation of the Bir Hayzan diatomite deposit, Kingdom of Saudi Arabia, with a section on selected physical properties and implications for future geophysical exploration

A 2.2-m-thick lake bed composed entirely of diatomite was found in the southwestern arm of the Nafud sand sea, about 67 km east of Tayma in northwestern Saudi Arabia. Its stratigraphic position above eolian sand and below a large barchanoid dune indicates deposition during an exceptional period of pluvial climate in an otherwise arid sand desert. Radiocarbon-dated carbonate lake beds found in similar stratigraphic settings in other parts of the Nafud suggest that the diatomite was deposited in the late Pleistocene epoch sometime between 32,000 and 20,000 years ago. Diatomite of the same pluvial episode has also been found in the Afar region of Ethiopia. Four samples of the diatomite were analyzed for major chemical components and 32 minor and trace elements. Two of the samples appeared to be representative of the lake bed. These samples contained about 85 percent SiO2, 2.34 percent Fe2O3, 1 4 percent Al2O3, and 8.27 percent ignition loss, with only traces of CaO, P2O5, MgO, Na2O, and TiO2. The high content of silica and low contents of alumina, iron oxide, lime, and other constituents indicate low contamination. Analyses of samples from the two atypical units indicate a small amount of contamination, probably clay or mica, in the basal unit and addition of iron oxide and carbonate by ground water in an isolated green-colored unit. Chemically the Bi'r Hayzan diatomite compares favorably with commercial deposits from other parts of the world. Low bulk densities of 0.64 g/cm3 (30-40 lbs/ft3) and an average porosity of 63 percent for five samples also suggest the deposit is of industrial grade. Further studies are recommended to determine: (1) the size and extent of the deposit and (2) the suitability of the diatomite for commercial applications. As means to these ends, electrical-resistivity surveys following winter rains are suggested to determine both the extent and thickness of the lake bed beneath the overlying sand dunes. A complete species identification of the diatom association and further laboratory testing of physical properties of the diatomite also should be made. Further exploration in the Nafud is recommended to locate other possible diatomite deposits.

Open-File Report↗
USGS1982

Progress report on lithium-related geologic investigations in Bolivia

The September 1, 1981, Samoa Islands Region earthquake occurred at the extreme northern end of the Tonga arc in a region where the Pacific plate may be disjointed along a hinge fault. In the last 50 years, magnitude 7 or greater earthquakes have occurred in this region on the average of once every six years, but four 7+ events have now occurred within the last six years. The mainshock was preceded about two hours earlier by a foreshock that was used as a calibration event for the Joint Epicenter Determination relocation of the mainshock and nearby seismicity occurring within a period seven months prior to and one week after the mainshock. The foreshock, better-located events of the prior seismicity, and most aftershocks are concentrated in a group near the mainshock epicenter, but several more distant aftershocks suggest that the aftershock zone may have been as large as 125 km in length and trended about S35?E. Identification of depth phases from a full suite of broadband records gives source depths of 25-3km for the mainshock and 29.5?3 km for the foreshock using a JB earth model. Source parameters were determined for the mainshock utilizing WWSSN analog and GDSN digital data. The preferred fault plane solution based on P-wave first motion data is a south by southwesterly steeply dipping normal fault, remarkably similar to the mechanism reported by Johnson and Molnar (1972) for the nearby earthquake of April 20, 196B. A waveform inversion technique described by Sipkin (1982), when applied to long-period P waveforms, gives an 'average' point source solution for a purely deviatoric moment rate tensor at a preferred source depth of 22 km. Very similar results were obtained from long-period GDSN body-wave and mantle-wave data using a centroid-moment tensor inversion technique described in Dziewonski, and others (1981). Both techniques provide solutions very close to a double couple source with a south by southwesterly shallow-dipping normal fault mechanism. To obtain the scalar mantle wave moment, GDSN vertical and transverse records 20,000 see in length were processed as described by Buland and Taggart (1981). Averaging all the data from Rayleigh and Love waves yields an estimate of 3.8 x 10^27 dyne-cm (as compared to about 1.9 x 10^27 from body-wave moment tensor inversions) or a moment magnitude (Mr) of 7.6. For the portion of the waveform analysed (50-5B sec), the body-wave inversion performed by Sipkin gives a source time function of duration approximately 28 sec with two peaks in activity. Simultaneous analysis of short-period records, and broadband ground displacements and velocities, a method described by Harvey and Choy (1982) and Choy and Boatwright (1981) revealed a complex rupture consisting of two subevents, of about the same moment, separated in time by about 25 sec, and with durations of about 25 sec each. The two peaks in activity resolved by the body-wave moment tensor inversion correspond to the first of these subevents.

Open-File Report↗