USGS Science⌕ Search

SEARCH · USGS Science

Results for “Stratigraphy”

Search indexed USGS publications on groundwater, aquifers, geologic maps, mineral resources and earthquakes. Explore source records by subject and place.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 541 records · Page 30Linked to original sources
USGS2007

Coal Rank and Stratigraphy of Pennsylvanian Coal and Coaly Shale Samples, Young County, North-Central Texas

Vitrinite reflectance measurements were made to determine the rank of selected subsurface coal and coaly shale samples from Young County, north-central Texas, for the National Coal Resources Database System State Cooperative Program conducted by the Bureau of Economic Geology at The University of Texas at Austin. This research is the continuation of a pilot study that began in adjacent Archer County, and forms part of a larger investigation of the coalbed methane resource potential of Pennsylvanian coals in north-central Texas. A total of 57 samples of coal and coaly shale fragments were hand-picked from drill cuttings from depths of about 2,000 ft in five wells, and Ro determinations were made on an initial 10-sample subset. Electric-log correlation of the sampled wells indicates that the collected samples represent coal and coaly shale layers in the Strawn (Pennsylvanian), Canyon (Pennsylvanian), and Cisco (Pennsylvanian-Permian) Groups. Coal rank in the initial sample subset ranges from lignite (Ro=0.39), in a sample from the Cisco Group at a depth of 310 to 320 ft, to high volatile bituminous A coal (Ro=0.91) in a sample from the lower part of the Canyon Group at a depth of 2,030 to 2,040 ft.

Open-File Report↗
USGS2011

Shallow stratigraphy of the Skagit River Delta, Washington, derived from sediment cores

Sedimentologic analyses of 21 sediment cores, ranging from 0.4 to 9.6 m in length, reveal that the shallow geologic framework of the Skagit River Delta, western Washington, United States, has changed significantly since 1850. The cores collected from elevations of 3.94 to -2.41 m (relative to mean lower low water) along four cross-shore transects between the emergent marsh and delta front show relatively similar environmental changes across an area spanning ~75 km 2 . Offshore of the present North Fork Skagit River and South Fork Skagit River mouths where river discharge is focused by diked channels through the delta, the entire 5–7-km-wide tidal flats are covered with 1–2 m of cross-bedded medium-to-coarse sands. The bottoms of cores, collected in these areas are composed of mud. A sharp transition from mud to a cross-bedded sand unit indicates that the tidal flats changed abruptly from a calm environment to an energetic one. This is in stark contrast to the Martha's Bay tidal flats north of the Skagit Bay jetty that was completed in the 1940s to protect the newly constructed Swinomish Channel from flooding and sedimentation. North of the jetty, mud ranging from 1 to 2 m thick drapes a previously silt- and sand-rich tidal flat. The silty sand is a sediment facies that would be expected there where North Fork Skagit River sedimentation occurred prior to jetty emplacement. This report describes the compositional and textural properties of the sediment cores by using geophysical, photographic, x-radiography, and standard sediment grain-size and carbon-analytical methods. The findings help to characterize benthic habitat structure and sediment transport processes and the environmental changes that have occurred across the nearshore of the Skagit River Delta. The findings will be useful for quantifying changes to nearshore marine resources, including impacts resulting from diking, river-delta channelization, shoreline development, and natural variations in fluvial-sediment inputs. These results also provide important quantitative data on the amount of sediment delivered to the nearshore from the Skagit River for use in calculating sediment budgets for application to watershed planning and wetland and coastal-ecosystem restoration.

Washington↗
USGS2011

Summary of the stratigraphy and structural elements related to plate convergence of the Quetta-Muslim Bagh-Sibi region, Balochistan, west-central Pakistan

Obduction of an ophiolite complex onto the northwestern continental margin of the India plate occurred during the Late Cretaceous to early Paleocene, followed by collision of the ophiolitic complex of the India plate with the Eurasia plate in the Eocene. Lower Eocene marine strata overlie the ophiolitic complex suggesting that suturing was completed by early Eocene time. The Quetta-Muslim Bagh-Sibi region is a structurally complex area within west-central Pakistan characterized by broad and tight folds, and reverse, thrust, and strike-slip faults. In order to understand this complex deformation, we have divided this region into five structural domains which are separated by four major boundary faults formed during four major periods of deformation related to oblique convergence of the India and Eurasia plates. The five structural domains are (1) a foredeep, (2) a foreland fold-and-thrust belt, (3) a major deep trough that formed within the foreland fold-and-thrust belt and filled with collision molasse, (4) a thick flysch deposit, and (5) a subduction-obduction and related igneous rock terrane on the margin of the Eurasia plate (Afghan block). The four major faults that bound the structural terrane are the Frontal (F), Ghazaband-Zhob (GZ), Gwal-Bagh (GB), and Chaman (C) faults. Four major periods of deformation are recognized: (1) emplacement of ophiolitic rocks onto the continental margin of the India plate; (2) convergence of the India-Eurasia plates; (3) deposition of Tertiary-Quaternary molasse units followed by major folding and thrusting, and formation of strike-slip faults; and (4) deposition of Pleistocene molasse units with subsequent folding, thrusting, and strike-slip motion that continues to the present.

Open-File Report↗
USGS2012

Preliminary physical stratigraphy, biostratigraphy, and geophysical data of the USGS South Dover Bridge Core, Talbot County, Maryland

The South Dover Bridge (SDB) corehole was drilled in October 2007 in Talbot County, Maryland. The main purpose for drilling this corehole was to characterize the Upper Cretaceous and Paleogene lithostratigraphy and biostratigraphy of the aquifers and confining units of this region. The data obtained from this core also will be used as a guide to geologic mapping and to help interpret well data from the eastern part of the Washington East 1:100,000-scale map near the town of Easton, Md. Core drilling was conducted to a depth of 700 feet (ft). The Cretaceous section was not penetrated due to technical problems during drilling. This project was funded by the U.S. Geological Survey’s (USGS) Eastern Geology and Paleoclimate Science Center (EGPSC) as part of the Geology of the Atlantic Watersheds Project; this project was carried out in cooperation with the Maryland Geological Survey (MGS) through partnerships with the Aquifer Characterization Program of the USGS’s Maryland-Delaware-District of Columbia Water Science Center and the National Cooperative Geologic Mapping Program. The SDB corehole was drilled by the USGS drilling crew in the northeastern corner of the Trappe 7.5-minute quadrangle, near the type locality of the Boston Cliffs member of the Choptank Formation. Geophysical logs (gamma ray, single point resistance, and 16-inch and 64-inch normal resistivity) were run to a depth of 527.5 ft; the total depth of 700.0 ft could not be reached because of the collapse of the lower part of the hole. Of the 700.0 ft drilled, 531.8 ft of core were recovered, representing a 76 percent core recovery. The elevation of the top of the corehole is approximately 12 ft above mean sea level; its coordinates are lat 38°44′49.34″N. and long 76°00′25.09″W. (38.74704N., 76.00697W. in decimal degrees). A groundwater monitoring well was not installed at this site. The South Dover Bridge corehole was the first corehole that will be used to better understand the geology and hydrology of the Maryland Eastern Shore.

Maryl↗
USGS2014

A field trip guidebook to the type localities of Marland Billings' 1935 Paleozoic bedrock stratigraphy near Littleton, New Hampshire

Marland Billings' classic paper published in 1937 in the Geological Society of America Bulletin established a succession of six stratigraphic units in rocks of low metamorphic grade near Littleton, New Hampshire. The two youngest units are fossiliferous in the area, with ages established at the time as “middle” Silurian and Early Devonian. Billings and students mapped the same stratigraphic section in adjacent areas of progressively higher regional metamorphic grade. This work laid the foundation upon which a major part of subsequent work in New England has been directly or indirectly built. This guidebook was written for a field trip held in March 2013 to visit roadcuts that are as close as possible in March to the type localities or areas of Billings’ six-fold stratigraphic succession. Ten stops are in rocks of chlorite grade of Acadian(?) metamorphism; the final stop visits amphibolite of the Ammonoosuc Volcanics. Fieldwork by the authors over the past 20 years confirms Billings’ broad conclusions.

New Hampshire↗
USGS2014

The shallow stratigraphy and sand resources offshore from Cat Island, Mississippi

In collaboration with the U.S. Army Corps of Engineers, scientists from the U.S. Geological Survey (USGS) St. Petersburg Coastal and Marine Science Center collected over 487 line kilometers (> 300 miles) of high-resolution geophysical data around Cat Island, Mississippi, to improve understanding of the island's geologic evolution and identify potential sand resources for coastal restoration. In addition, 40 vibracores were collected on and around the island, generating more than 350 samples for grain-size analysis. The results indicate that the geologic evolution of Cat Island has been influenced by deltaic, lagoonal/estuarine, tidal, and oceanographic processes, resulting in a stratigraphic record that is quite complex. The region north of the island is dominated by lagoonal/estuarine deposition, whereas the region south of the island is dominated by deltaic and tidal deposition. In general, the veneer of modern sediment surrounding the island is composed of newly deposited sediment and highly reworked relict sediments. The region east of the island shows the interplay of antecedent barrier-island change with delta development despite a significant ravinement of sediments. The data show from little to no modern sediment east of the island, exposing relict sediments at the seafloor. Finally, the data reveal four subaqueous sand units around the island. Two of the units are northwest of the modern island and one is southwest. Given the dominant, westward, longshore transport along the Mississippi and Alabama barrier islands, the geographic location of these three units suggests that they do not contribute to the modern sediment budget of Cat Island. The last unit is directly east of the island and represents the antecedent island platform that has supplied sand over geologic time for creation of the spits that form the eastern shoreline. Because of its location east of the island, the antecedent island unit may still supply sediment to the island today.

Mississippi↗
USGS2014

Characterization of subsurface stratigraphy along the lower American River floodplain using electrical resistivity, Sacramento, California, 2011

In July 2011, the U.S. Geological Survey, in cooperation with the U.S. Army Corps of Engineers, completed a geophysical survey using electrical resistivity along an approximately 6-mile reach of the lower American River in Sacramento, California, to map near-surface lithological variations. This survey is a part of a manifold and comprehensive study of river-flow dynamics and geologic boundary-property knowledge necessary to estimate scour potential and levee erosion risk. Data were acquired on the left (south or west) bank between river mile 5 and 10.7 as well as a short section on the right bank from river mile 5.4 to 6. Thirteen direct-current resistivity profiles and approximately 8.3 miles of capacitively coupled resisistivity data were acquired along accessible areas of the floodplain between the levee and river bank. Capacitively coupled resistivity was used as a reconnaissance tool, because it allowed for greater spatial coverage of data but with lower resolution and depth of investigation than the DC resistivity method. The study area contains Pleistocene-age alluvial deposits, dominated by gravels, sands, silts, and clays, that vary in both lateral extent and depth. Several generations of lithologic logs were used to help interpret resistivity variations observed in the resistivity models.

California↗
USGS2021

Stratigraphy and age of a prominent paleosol in a late Pleistocene sedimentary sequence, Mason Neck, Virginia

The High Point paleosol is 2.28-meters-thick aggradational soil developed in fining upward estuarine-alluvial sand and loess. The paleosol is exposed in a few shoreline cliff faces of Mason Neck, Virginia. Although a former A horizon is missing, the E, Bw, Bt, and C horizon sequence seen in the sediments indicates subaerial pedogenesis. Pedogenesis began with initial estuarine-alluvial floodplain emergence as sea level was lowering in late marine isotope stage 5 (MIS5) and MIS4, continued during eolian silt deposition accompanied by incorporation of the silt into the estuarine-alluvial sand, and ended with a period of loess and eolian sand deposition, erosion, and development of periglacial(?) features. Six optically stimulated luminescence ages provide an age range from 86 to 56 ka (thousand years ago) for sedimentary units below and above the paleosol. These ages indicate a 10,000- to 30,000-year interval in late MIS5 and MIS4 for these events to have occurred.

Virginia↗
USGS1953

Stratigraphy and structure of the Miners Mountain area, Wayne County, Utah

The Miners Mountain area includes about 85 square miles in Wayne County, south-central Utah. The area is semiarid and characterized by cliffs and deep canyons. Formations range in age from Permian to Upper Jurassic and have an aggregate thickness of about 3,500 feet. Permian formations are the buff Coconino sandstone and the overlying white, limy, shert-containing Kaibab limestone. Unconformably overlying the Kaihab is the lower Triassic Moenkopi formation of reddish-brown and yellow mudstone, siltstone, and sandstone; it contains the Sinbad limestone member (?) in the lower part. Thin, lenticular Shinarump conglomerate unconformably overlies the Moenkopi, but grades upward into the Upper Triassic Chinle formation of variegated mudstone with some interbedded sandstone and limestone lenses. Uncomformably overlying the Chinle are the Wingate sandstone, Kayenta formation, and Navajo sandstone of the Jurassic (?) Glen Canyon group, which consist of red to white sandstone. Only the lower part of the Carmel formation of the Upper Jurassic San Rafael group is exposed in the area; it consists of variegated siltstone, sandstone, limestone, and gypsum. The conspicuous structural feature in the area is the Teasdale anticline which trends northwest, is about 14 miles long, and is asymmetric with a steeper west flank. Bounding the anticline on the northeast and east is the Capitol Reef monocline, the northern part of the Waterpocket Fold. Strata in the area are broken by steeply-dipping normal faults with small displacements, except for the Teasdale fault which has a maximum displacement of over 1,000 feet. Jointing is prominent in some formations. The major orogenic movement in the area is believed to be late Upper Cretaceous to early Tertiary. Epeirogenic uplift occurred intermittently throughout Tertiary and perhaps Quaternary time.

Open-File Report↗