USGS Science⌕ Search

SEARCH · USGS Science

Results for “Wilson Bulletin”

Search indexed USGS publications on groundwater, aquifers, geologic maps, mineral resources and earthquakes. Explore source records by subject and place.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 289 records · Page 16Linked to original sources

New insight into the origin of manganese oxide ore deposits in the Appalachian Valley and Ridge of northeastern Tennessee and northern Virginia, USA

Manganese oxide deposits have long been observed in association with carbonates within the Appalachian Mountains, but their origin has remained enigmatic for well over a century. Ore deposits of Mn oxides from several productive sites located in eastern Tennessee and northern Virginia display morphologies that include botryoidal and branching forms, massive nodules, breccia matrix cements, and fracture fills. The primary ore minerals include hollandite, cryptomelane, and romanèchite. Samples of Mn oxides from multiple localities in these regions were analyzed using electron microscopy, X-ray analysis, Fourier transform infrared spectroscopy, and trace and rare earth element (REE) geochemistry. The samples from eastern Tennessee have biological morphologies, contain residual biopolymers, and exhibit REE signatures that suggest the ore formation was due to supergene enrichment (likely coupled with microbial activity). In contrast, several northern Virginia ores hosted within quartz-sandstone breccias exhibit petrographic relations, mineral morphologies, and REE signatures indicating inorganic precipitation, and a likely hydrothermal origin with supergene overprinting. Nodular accumulations of Mn oxides within weathered alluvial deposits that occur close to breccia-hosted Mn deposits in Virginia show geochemical signatures that are distinct from the breccia matrices and appear to reflect remobilization of earlier-emplaced Mn and concentration within supergene traps. Based on the proximity of all of the productive ore deposits to mapped faults or other zones of deformation, we suggest that the primary source of all of the Mn may have been deep seated, and that Mn oxides with supergene and/or biological characteristics resulted from the local remobilization and concentration of this primary Mn.

Tennessee, Virginia↗

Detection and characterization of pulses in broadband seismometers

Pulsing - caused either by mechanical or electrical glitches, or by microtilt local to a seismometer - can significantly compromise the long‐period noise performance of broadband seismometers. High‐fidelity long‐period recordings are needed for accurate calculation of quantities such as moment tensors, fault‐slip models, and normal‐mode measurements. Such pulses have long been recognized in accelerometers, and methods have been developed to correct these acceleration steps, but considerable work remains to be done in order to detect and correct similar pulses in broadband seismic data. We present a method for detecting and characterizing the pulses using data from a range of broadband sensor types installed in the Global Seismographic Network. The technique relies on accurate instrument response removal and employs a moving‐window approach looking for acceleration baseline shifts. We find that pulses are present at varying levels in all sensor types studied. Pulse‐detection results compared with average daily station noise values are consistent with predicted noise levels of acceleration steps. This indicates that we can calculate maximum pulse amplitude allowed per time window that would be acceptable without compromising long‐period data analysis.

Bulletin of the Seismological Society of America↗

Geologic framework of the Alaska Peninsula, southwest Alaska, and the Alaska Peninsula terrane

The Alaska Peninsula is composed of the late Paleozoic to Quaternary sedimentary, igneous, and minor metamorphic rocks that record the history of a number of magmatic arcs. These magmatic arcs include an unnamed Late Triassic(?) and Early Jurassic island arc, the early Cenozoic Meshik arc, and the late Cenozoic Aleutian arc. Also found on the Alaska Peninsula is one of the most complete nonmetamorphosed, fossiliferous, marine Jurassic sedimentary sections known. As much as 8,500 m of section of Mesozoic sedimentary rocks record the growth and erosion of the Early Jurassic island arc. A thinner, but still thick (as much as 5,400 m), sequence of Tertiary sedimentary rocks that are predominantly continental overlies the Mesozoic section. A brief regression in early Tertiary time on the Alaska Peninsula and granodiorite plutonism in the Shumagin, Semidi, and Sanak Islands was followed by deposition of fluvial and minor marine clastic strata. This was followed by deposition of transgressive marine clastic strata and initiation of the Meshik arc, shown by an areally extensive outpouring of volcanic and volcaniclastic rocks and debris between late Eocene and earliest Miocene time. Late Miocene time was marked by another brief transgression and northwest- to southeast-directed compression, followed by renewed volcanism and plutonism which initiated the modern Aleutian magmatic arc. Extensive glacial and glaciomarine deposits of late Pleistocene age create an extensive lowland physiographic province on the northwest side of the Alaska Peninsula and join isolated mountain masses to the Alaska Peninsula on the southwest. Multiple active volcanoes and volcanic peaks dominate the skyline of the Alaska Peninsula and represent the continuation of magmatic activity that has formed the Aleutian arc since late Miocene time. The Alaska Peninsula has had a long and involved history since Paleozoic time. We propose that the Paleozoic and Mesozoic rocks that constitute much of the Alaska Peninsula be called the Alaska Peninsula terrane. Using the concept of subterranes, we divide the terrane into two distinct but tectonically related subterranes: the Chignik and Iliamna subterranes, which share a limited common geologic history. The Iliamna subterrane has served at most times as a source area for the Chignik subterrane; however, some rock units are in common across the subterranes. The Iliamna and Chignik subterranes are in part separated by the Bruin Bay fault system. The Iliamna subterrane is composed of moderately deformed early Mesozoic marine sedimentary and volcanic rocks and schist, gneiss, and marble of Paleozoic(?) and Mesozoic age, and plutonic rocks of the Alaska-Aleutian Range batholith. Characteristic of the Chignik subterrane are little-deformed, shallow-marine to continental clastic sedimentary rocks ranging in age from Permian to latest Cretaceous. However, deep-marine, volcaniclastic, and calcareous rocks form important components of the older rocks in the subterrane. The two subterranes of the Alaska Peninsula terrane are characterized by radically different structural and metamorphic styles. The nonplutonic rocks of the Iliamna subterrane are characterized by metamorphism up to amphibolite-facies grade and intense folding. In the Chignik subterrane, the structural style is dominated by large, open, en echelon anticlinal structures, normal faulting, and thrust and high-angle reverse faults that have minor displacement in a northwest to southeast direction. In the Outer Shumagin and Sanak Islands, rocks assigned to the Chugach terrane are characterized structurally by tight, generally northeast-trending folds. Dips in these rocks tend to be steep, rarely less than 35°, and overturned beds are locally common. The boundaries separating the Alaska Peninsula terrane from other terranes are commonly indistinct or poorly defined. A few boundaries have been defined at major faults, although the extensions of these faults are speculative through some areas. The west side of the Alaska Peninsula terrane is overlapped by Tertiary sedimentary and volcanic rocks and Quaternary deposits.

Alaska↗

Potential for deep basin-centered gas accumulation in Hanna Basin, Wyoming

The potential for a continuous-type basin-centered gas accumulation in the Hanna Basin in Carbon County, Wyoming, is evaluated using geologic and production data including mud-weight, hydrocarbon-show, formation-test, bottom-hole-temperature, and vitrinite reflectance data from 29 exploratory wells. This limited data set supports the presence of a hypothetical basin-centered gas play in the Hanna Basin. Two generalized structural cross sections illustrate our interpretations of possible abnormally pressured compartments. Data indicate that a gas-charged, overpressured interval may occur within the Cretaceous Mowry, Frontier, and Niobrara Formations at depths below 10,000 ft along the southern and western margins of the basin. Overpressuring may also occur near the basin center within the Steele Shale and lower Mesaverde Group section at depths below 18,000 to 20,000 ft. However, the deepest wells drilled to date (12,000 to 15,300 ft) have not encountered over-pressure in the basin center. This overpressured zone is likely to be relatively small (probably 20 to 25 miles in diameter) and is probably depleted of gas near major basement reverse faults and outcrops where gas may have escaped. Water may have invaded reservoirs through outcrops and fracture zones along the basin margins, creating an extensive normally pressured zone. A zone of subnormal pressure also may exist below the water-saturated, normal-pressure zone and above the central zone of overpressure. Subnormal pressures have been interpreted in the center of the Hanna Basin at depths ranging from 10,000 to 25,000 ft based on indirect evidence including lost-circulation zones. Three wells on the south side of the basin, where the top of the subnormally pressured zone is interpreted to cut across stratigraphic boundaries, tested the Niobrara Formation and recovered gas and oil shows with very low shut-in pressures.

Bulletin↗

Effects of thermal variability on broadband seismometers: Controlled experiments, observations, and implications

Isolating seismic instruments from temperature fluctuations is routine practice within the seismological community. However, the necessary degree of thermal stability required in broadband installations to avoid generating noise or compromising the fidelity in the seismic records is largely unknown and likely application dependent. To quantify the temperature sensitivity of seismometers over a broad range of frequencies, we artificially induced local temperature changes on three different models of seismometers to measure the effect of thermal variations on seismometer output. We found that diurnal temperature changes above 0.002°C root mean square (rms) showed significant changes in velocity and acceleration output in comparison to thermally stable reference measurements. We also found that sensor incoherent self‐noise increased with temperature variation; these increases in noise can be modeled as 1 / f "> 1 / f noise (pink noise), and are unlikely to be easily corrected for. These experimental results are compared with the data from Incorporated Research Institutions for Seismology (IRIS) U.S. Geological Survey (USGS) Global Seismographic Network (GSN) station TUC (Tucson, Arizona). This station is well instrumented with temperature sensors and has three different broadband seismometers, each of which uses a different method of thermal isolation. We show that the water bricks and borehole installations give ample temperature attenuation to thermally isolate seismometers from diurnal thermal variability that would compromise seismic data. We find that seismometer installations that provide thermal stability below 0.002°C rms could help to improve long‐period vertical seismic data across the GSN by decreasing temperature‐driven 1 / f "> 1 / f noise.

Bulletin of the Seismological Society of America↗

Optimizing surveys of fall-staging geese using aerial imagery and automated counting

Ocular aerial surveys allow efficient coverage of large areas and can be used to monitor abundance and distribution of wild populations. However, uncertainty around resulting population estimates can be large due to difficulty in visually identifying and counting animals from aircraft, as well as logistical challenges in estimating detection probabilities. Photographic aerial surveys can mitigate these challenges and can allow flight at higher altitudes to minimize disturbance of birds and improve safety for surveyors. We evaluated a photographic aerial survey that incorporated a systematic sampling design with automated photo capture and processing for fall-staging geese at Izembek Lagoon, Alaska, in 2017–2019. Ocular aerial surveys have been completed at Izembek Lagoon for >40 years. For the new photo survey, we used a commercial system to automatically trigger cameras at preset points. We then applied a machine-learning algorithm trained to automatically identify and count geese in our photos, manually corrected those counts, and quantified the algorithm's accuracy. We translated corrected counts into density and extrapolated mean density across the entire lagoon to estimate total population size for Pacific brant ( Branta bernicla ) and cackling geese ( B. hutchinsii ). The automated algorithm undercounted geese, but successfully identified the small subset of photos containing geese. Manual correction was therefore needed only for photos automatically identified as containing geese, allowing substantial reduction of workload. Manually-corrected, photo-based estimates of Pacific brant and cackling goose population sizes were larger and more precise than ocular estimates in all 3 years. To reduce costs with little penalty for variance around population estimates, the photographic survey design could be optimized by reducing the number of transects to ~67% of the current number while still manually correcting all photos in which the automated algorithm detected geese. Further years of both ocular and photo surveys would be needed to calibrate the photo estimates against the >40-year timeseries of the ocular survey, after which the photo series could successfully guide management of Pacific brant. As technologies continue to advance, we expect photographic surveys with automated counting to be easily implemented and advantageous to many monitoring programs.

Alaska↗

Avian response to conservation buffers in agricultural landscapes during winter

Native herbaceous vegetation cover along row‐crop field edges (i.e., field buffers) increases breeding densities of many bird species. However, the effect of field buffers on bird species during the non‐breeding season is less understood. We compared density, avian richness, and avian conservation value on row‐crop fields containing buffers strategically designed for wildlife versus fields without buffers in 3 southeastern U.S. states during winter 2007 and 2008. Fields with buffers were enrolled in U.S. Department of Agriculture, Conservation Reserve Program practice Habitat Buffers for Upland Birds (CP33), which targets restoration of northern bobwhite ( Colinus virginianus ) and other upland bird species. Overall species richness did not differ on fields with buffers versus fields without buffers in 2007, but was 29% greater on fields with buffers in 2008. Swamp sparrows ( Melospiza georgiana ), song sparrows ( M. melodia ), field sparrows ( Spizella pusilla ), and red‐bellied woodpeckers ( Melanerpes carolinus ) had greater densities on fields with buffers compared with fields without buffers. Increasing field‐buffer width did not result in greater bird densities. Our results suggest a small change in primary land use (≈7%) produced a disproportionate population response by some grassland‐dependent and woodland bird species during winter. Because field buffers provide a direct source of winter food and cover resources, they may be a pragmatic means to provide critical non‐breeding habitat with little alteration of existing agricultural systems.

Arkansas, Kentucky, Mississippi↗

Paleohydrogeology of the San Joaquin basin, California

Mass transport can have a significant effect on chemical diagenetic processes in sedimentary basins. This paper presents results from the first part of a study that was designed to explore the role of an evolving hydrodynamic system in driving mass transport and chemical diagenesis, using the San Joaquin basin of California as a field area. We use coupled hydrogeologic models to establish the paleohydrogeology, thermal history, and behavior of nonreactive solutes in the basin. These models rely on extensive geological information and account for variable-density fluid flow, heat transport, solute transport, tectonic uplift, sediment compaction, and clay dehydration.

California↗