USGS ScienceSearch

USGS · wsp915

Major winter and nonwinter floods in selected basins in New York and Pennsylvania

Abstract

The scientific design of flood-control works is based on an evaluation of the hydrologic factors basic to flood events, particularly how rainfall and snow runoff, soil conditions, and channel influences can combine to produce greater or lesser floods. For this purpose an analysis of the pertinent hydrologic data is needed. The methods of analysis adopted should conform as closely as possible to those already in use and must be adapted to the quality of the available information. Maximum floods in 8 basins in New York and Pennsylvania during the winter and nonwinter months were studied, a total of 21 floods. The most outstanding winter flood of record in the North Atlantic region was that of March 1936. Rainfall plus snow melt in the basins studied ranged between 3.04 and 6.87 inches, and associated volumes of direct runoff from 1.88 to 5.63 inches. Winter floods have a common characteristic in their relation to freezing temperature. The antecedent periods, representing a period of snow accumulation and frost penetration, are below freezing, and the flood itself is contemporaneous with a period of above-freezing temperatures, usually associated with rain, during which the previously accumulated snow is melted. A second common characteristic of major winter floods is their tendency to be associated with widespread causal meteorologic conditions. There was a more complete conversion of rainfall and snow melt into runoff during the winter storms studied than during the wettest nonwinter flood. Snow melt during winter floods ranged from 0.04 to 0.07 inch per degree-day above 32° F. The depth of mean areal rainfall produced by the nonwinter storms studied ranged from 3.05 to 4.96 inches. The maximum 24-hour quantity at single stations was 14 inches, which was measured during the storm of July 1935 in New York. The volume of direct runoff ranged between 1.39 and 3.41 inches. The portion of rainfall that was converted into runoff varied in accordance with the rate of antecedent base flow, expressed in second-feet per square mile, and emphasized the influence of antecedent conditions. The average volume of direct runoff during winter floods was 4.24 inches, and the average during nonwinter floods was 2.44 inches. The latter, however, were more concentrated as to time, tending to compensate for large volume of runoff in winter, so that the crest rates of direct runoff averaged 0.056 inches per hour during the winter and 0.051 inches during the nonwinter period.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 39.75° to 43.681° latitude; -78.75° to -74° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Walter Basil Langbein. 1947. Major winter and nonwinter floods in selected basins in New York and Pennsylvania. https://doi.org/10.3133/wsp915

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper

Sediment-quality assessment of Franklin D. Roosevelt Lake and the upstream reach of the Columbia River, Washington, 1992

Elevated concentrations of trace elements were found in bed sediment of Lake Roosevelt and the Columbia River, its principal source of inflow. Trace-element concentrations in whole water samples did not exceed criteria for freshwater organisms. Bed sediments of Lake Roosevelt were analyzed for organic compounds associated with wood-pulp waste. Dioxins and furans were found in suspended sediment and water of the Columbia River. Abundance and diversity of benthic invertebrate communities were analyzed.

Water Supply Paper