USGS Science⌕ Search

USGS · wsp2265

The Spokane aquifer, Washington: its geologic origin and water-bearing and water-quality characteristics

Abstract

The Spokane aquifer is an unconfined aquifer consisting of coarse sand, gravel, cobbles, and boulders deposited during several catastrophic glacial outburst floods--known as the Spokane Floods---of Pleistocene time. The aquifer is one of the most productive in the United States, and, as the only significant source of good-quality water supply in the Spokane Valley, it has been designated as a 'Sole Source Aquifer' by the U.S. Environmental Protection Agency. The Spokane aquifer underlies an area of about 135 square miles in the Spokane Valley and varies in saturated thickness from a few feet to 500 feet or more. The aquifer is recharged by ground-water underflow from the Rathdrum Prairie aquifer in Idaho on the east, by ground-water underflow and surface-water seepage from small drainage areas along the Spokane Valley margins, and by percolation from various sources--from rainfall and snowmelt, from some reaches of the Spokane and Little Spokane Rivers, and from septic-tank drain fields, cesspools, and irrigation water. Discharge from the aquifer occurs by ground-water underflow from the lowermost end of the valley, by leakage to the Spokane and the Little Spokane Rivers, by evapotranspiration, and by ground-water withdrawal by pumping. The transmissivity of the aquifer ranges from less than 0.05 to 70 feet squared per second, and its specific yield ranges from less than 5 to 20 percent of the aquifer volume. Seasonal water-level fluctuations in wells tapping the aquifer are generally less than 10 feet. The annual pumpage from the aquifer in 1977 was about 164,000 acre-feet, of which about 70 percent was for municipal supplies, which included some industrial and commercial supplies. Land use over the aquifer includes predominantly agricultural activities in the eastern one-third of the valley and urban and residential developments in most of the remaining area. Potential sources of contamination of the aquifer include percolation from cesspools, septic-tank drain fields, and municipal and industrial waste-disposal sites. In general, the high rate of ground-water movement through the highly permeable aquifer materials has resulted in the ground-water quality being little affected by the overlying land use activities. Some local degradation of water quality has occurred due to industrial waste-disposal practices, however. During the water-quality study period of May 1977 to May 1978, average specific conductance of the ground water ranged from less than 100 to about 500 micromhos per centimeter at 25 degrees Celsius, average chloride concentration ranged from less than 2 to about 12 milligrams per liter (equivalent to parts per million}, and average nitrate nitrogen concentrations ranged from less than 1 to about 8 milligrams per liter. The streamflow and water quality of the Spokane River, which are related to the flow and quality of water in the Spokane aquifer, indicate that, during the period 1913 to 1978 inclusive, the river at Post Falls, Idaho, had an average annual discharge of 6,307 cubic feet per second, a maximum discharge of 50,100 cubic feet per second, and a minimum discharge of 65 cubic feet per second. The quality of the river water along its course through the study area is affected to some extent by inflows of industrial wastewater and treated municipal sewered water. In the 30-mile reach between the State line and Riverside State Park, during the 1975 to 1978 water years inclusive, concentrations of nearly all the constituents analyzed increased, and concentrations of dissolved oxygen correspondingly decreased from 1968 to 1977 inclusive; coliform bacteria also showed notable increases in the downstream direction.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Dee Molenaar. 1988. The Spokane aquifer, Washington: its geologic origin and water-bearing and water-quality characteristics. https://doi.org/10.3133/wsp2265

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper↗

Use of stable isotopes of carbon, nitrogen, and sulfur to identify sources of nitrogen in surface waters in the lower Susquehanna River basin, Pennsylvania

With the exception of sewage and septic effluents, most nitrogen sources and soils contain larger proportions of organic and reduced forms of carbon, nitrogen, and sulfur than inorganic, oxidized forms. In contrast, most surface water and ground water contains larger proportions of dissolved inorganic carbon, nitrogen, and sulfur forms than organic forms. Data indicate that carbon, nitrogen, and sulfur are extensively processed in soils and streams.

Water Supply Paper↗

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper↗