Feasibility study of the use of the acoustic velocity meter for measurement of net outflow from the Sacramento-San Joaquin Delta in California

Winchell Smith

doi:10.3133/wsp1877

Home/Archive/USGS

USGS · wsp1877

Feasibility study of the use of the acoustic velocity meter for measurement of net outflow from the Sacramento-San Joaquin Delta in California

Winchell Smith

View original source ↗Read source document ↗Export metadata ↓

Abstract

A reliable measure of the fresh-water outflow from the Sacramento-San Joaquin delta is needed for the operation of the California Water Project and for the evaluation of the interrelated water problems of the delta and San Francisco Bay regions. The Chipps Island channel, immediately downstream from the confluence of the Sacramento and San Joaquin Rivers, is the most promising site for this flow measurement, but the conventional techniques used for evaluating steady flows cannot be employed there because the channel reach is in the tidal zone, and reversals of flow occur during each tidal cycle. Net outflows, which may be as little-as 2,000 cubic feet per second must necessarily be computed as the difference between the large ebbflow and floodflow volumes that move back and forth between the delta region and San Francisco Bay. Discharges during peak periods of the ebb and flood tidal cycles may exceed 300,000 cubic feet per second. In consequence, a very high degree of precision must be maintained in the gross flow measurements if meaningful computations of net outflow are to be made. This report evaluates the probable accuracies that might be achieved by use of an AVM (acoustic velocity meter), a device which measures the stream velocity along a diagonal line across the channel. The study indicates that this line velocity will provide a stable index of the mean velocity in the channel and that such an index could be used as a primary parameter for the computation of discharge. Therefore, net outflows probably could be computed with the required accuracy by the use of such a device. The significant factors controlling the precision of measurement would be the stability of the channel geometry and streamline orientation, the precision with which the current-meter measurements needed for calibration of the system could be made, the instrumental calibration stability of the AVM system, and the length of period over which net outflows were computed. The AVM system developed by the U.S. Geological Survey in cooperation with the California Department of Water Resources and the U.S. Army Corps of Engineers does not have the required instrumental stability for this precise flow measurement. However, other AVM systems now being produced commercially seem to have the desired error characteristics, and a system probably can be procured that will permit computation of the fresh-water outflow from the delta area.

Explore related subjects

Water Supply Paper Report

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Winchell Smith. 1969. Feasibility study of the use of the acoustic velocity meter for measurement of net outflow from the Sacramento-San Joaquin Delta in California. https://doi.org/10.3133/wsp1877

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2004

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper↗

USGS2002

Use of stable isotopes of carbon, nitrogen, and sulfur to identify sources of nitrogen in surface waters in the Lower Susquehanna River Basin, Pennsylvania

Samples of nitrogen-source material, soil, and water were collected from several small, primarily single-source subbasins in the Lower Susquehanna River Basin during 1988–90 to determine the feasibility of using measurements of stable isotope ratios of carbon ( 13 C), nitrogen ( 15 N), and sulfur ( 34 S) to identify sources of nitrogen (N) in stream water. Chemical and isotopic compositions were measured for six N-source types consisting of rain water, forest leaf litter, synthetic fertilizer, farm-animal manure, municipal-sewage effluent and sludge, and septictank effluent and sludge. Compositions of associated, nearby samples of topsoil, subsoil, runoff water, and stream water were measured to evaluate changes in compositions of transported N-containing materials near the N source. Animal manure, human waste (sewage plus septic), and forest-leaf litter can be distinguished on the basis of 13 C; however, most N-sources cannot be distinguished on the basis of 15 N and 34 S, owing to wide ranges and overlap of compositions among different N-source types. Although values of 15 N for soil and runoff-water samples are qualitatively similar to those of the applied N source, values of 13 C and 34 S for runoff-water and stream-water samples appear to reflect the compositions of relatively large reservoirs of the elements in soil organic matter and minerals, respectively, and not the composition of the applied N source. The ratio of organic carbon to total nitrogen (C-org:N), combined with 13 C, is useful for distinguishing agricultural soils, which have characteristically high 13 C and low C-org:N, from forested soils. The C-org:N values of suspended particulates in runoff or stream waters generally are lower than those of nearby soils, however, and indicate that chemical transformations and resultant isotopic fractionation can be important controls on the compositions of N-containing compounds in the soil and water. In aqueous samples including surface water and liquid N-sources, isotopic ratios commonly differ between coexisting dissolved fractions of NO 3- N and NH 3- N and between dissolved and particulate fractions of N or S, probably because of isotopic fractionation during transport or N-source processing. Isotopic measurements provide qualitative information about important reactions that can affect N concentrations in surface waters. However, mass-balance computations generally are not sufficiently accurate to estimate the proportions of multiple sources contributing to the N load in the streams studied because of (1) variations in source chemical and isotopic compositions and (2) nonconservative behavior and fractionation during transport over short distances (hundreds of meters). Uncertainties in mass-balance computations are complicated by the propagation of errors associated with measurements of discharge, chemical concentrations,and isotopic compositions of relatively dilute, small streams.

Pennsylvania↗

USGS2001

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper↗