USGS ScienceSearch

USGS · wsp1487

Geology and ground-water resources of the lower Little Bighorn River Valley, Big Horn County, Montana, with special reference to the drainage of waterlogged lands

Abstract

The lower Little Bighorn River valley, Montana, is in the unglaciated part of the Missouri Plateau section of the Great Plains physiographic province. The river and its principal tributaries rise in the Bighorn Mountains, and the confluence of this northward-flowing stream with the Bighorn River is near the east edge of Hardin, Mont. The normal annual precipitation ranges from about 12 inches in the northern part of the area to 15 inches in the southern part. The economy of the area is founded principally on farming, much of the low-lying land adjacent to the river being irrigated. The irrigated land is within the Crow Indian Reservation, although a part is privately owned. The bedrock formations exposed in the area are of Cretaceous age and include the Parkman sandstone, Claggett shale, Eagle sandstone, Telegraph Creek shale, and Cody shale. The Cloverly formation, Tensleep sandstone, and Madison limestone, which underlie but are not exposed in the area, and the Parkman sandstone in the southern half of the area appear to be the principal bedrock aquifers. All except the Parkman lie at depths ranging from a few feet to several thousand feet, and all appear to be capable of yielding water in commercial quantities. Some of the other formations arc capable of yielding enough water for domestic and stock needs. The river alluvium of Recent age and the Pleistocene terrace deposits are the principal unconsolidated formations in the area with respect to water supply and drainage. Wells yielding as much as 100 gallons per minute may be developed in favorable areas. Pumping tests reveal that the transmissibility of the coarser unconsolidated materials probably ranges from about 15,000 to 30,000 gallons per day per foot. Two tests of the Parkman sandstone showed transmissibilities of 6,000 and 20,000 gallons per day per foot. Although a test of the Cloverly formation showed a transmissibility of only 3,000 gallons per day per foot, the high artesian pressure--80 pounds per square inch at the land surface--in the Cloverly caused the tested well to yield about 200 gallons per minute by natural flow; this is greater than the yield of any other single well in the area. Textural properties were compared with the hydraulic properties determined by laboratory tests to show the relation between different types of waterbearing materials. Materials classified as heavy soils-normally somewhat dense and impervious-had an average permeability of 7.2 gallons per day per square foot, which was more than expected. One sample of very coarse alluvial material had a permeability of 6,000 gallons per day per square foot. The depth to water beneath irrigation units was mapped, thus showing the waterlogged areas. Waterlogging is not a serious problem where the water table is more than 6 feet below the land surface. For the drainage studies the unconsolidated deposits are classified in two zones-coarse-grained sediments resting on the relatively impermeable bedrock floor and overlying fine-grained sediments which extend to the land surface. The transmissibility of the coarse-sediment zone generally is many times greater than that of the fine-sediment zone. Because in many places drains could not be economically dug deep enough to enter the coarse zone, the study of the effectiveness of drainage completed in the fine zone received much attention. The studies showed that, despite a considerable thickness of fine-grained sediments between the bottom of the drain and the top of the coarse zone, drainage ditches frequently were effective in relieving waterlogging of fields nearby. Pilot relief wells installed in existing drains showed that the effectiveness of some drains could be increased appreciably by installing a series of relief wells. Records of fluctuations of water levels in 196 observation wells and water-level contour maps were studied to show the principal areas of recharge and discharge in the irrigable areas.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 45.266° to 45.72° latitude; -107.529° to -107.338° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

E. A. Moulder, M. F. Klug, D. A. Morris, F. A. Swenson, R. A. Krieger. 1960. Geology and ground-water resources of the lower Little Bighorn River Valley, Big Horn County, Montana, with special reference to the drainage of waterlogged lands. https://doi.org/10.3133/wsp1487

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper

Sediment-quality assessment of Franklin D. Roosevelt Lake and the upstream reach of the Columbia River, Washington, 1992

Elevated concentrations of trace elements were found in bed sediment of Lake Roosevelt and the Columbia River, its principal source of inflow. Trace-element concentrations in whole water samples did not exceed criteria for freshwater organisms. Bed sediments of Lake Roosevelt were analyzed for organic compounds associated with wood-pulp waste. Dioxins and furans were found in suspended sediment and water of the Columbia River. Abundance and diversity of benthic invertebrate communities were analyzed.

Water Supply Paper