USGS Science⌕ Search

USGS · sir20215082

Factors affecting uncertainty of public supply, self-supplied domestic, irrigation, and thermoelectric water-use data, 1985–2015—Evaluation of information sources, estimation methods, and data variability

Abstract

The U.S. Geological Survey (USGS) Water-Use Program is responsible for compiling and disseminating the Nation's water-use data. Working in cooperation with local, State, and Federal agencies, the USGS has collected and published national water-use estimates every 5 years, beginning in 1950. These water-use data may vary because of actual changes in water use, because of changes in estimation methods, or because of errors. Comparison and interpretation of these data is difficult without first determining the factors that contribute to data variability. This report describes factors that may affect data quality and documents ways to investigate the variability of public supply, self-supplied domestic, irrigation, and thermoelectric water-use data for the 1985–2015 compilations. The USGS produces national water-use estimates for various categories of water use for every county in the United States. Knowledge about the sources of data for county estimates is important because factors such as estimation methodology and reporting affect data uncertainty Determination of meaningful patterns and trends in the data are contingent on the use of consistent methodology throughout the period of interest. With the many ways that water-use data have been collected, assembled, and estimated, multiple factors likely contribute to data uncertainty, Data used to produce these estimates may be furnished from agencies that collect information from entities who report water use; gaps in reported data are typically estimated to achieve a comprehensive county estimate. For example, public supply and thermoelectric category data are based primarily on furnished site-specific data; whereas crop irrigation is often furnished or estimated at the county scale. Public supply deliveries for domestic use and self-supplied domestic withdrawals are most often estimated by USGS personnel using per capita use rate coefficients. Irrigation may be estimated using crop water requirements, application rates, or other soil water balance methods when furnished reported data are not available. Rates, percentages, medians, and interquartile ranges were used to investigate variability in the water-use data among States, regions, and years. The purposes of these evaluations were to (1) identify extreme values that may reflect changes in information sources, estimation methods, or errors; (2) indicate areas of variable or consistent values that are unexpected; and (3) indicate areas where values change because of local climate or other factors. Where factors are identified that contribute to data variability, such as a change in methodology, additional work could determine uncertainty because of these factors. These evaluations identified the availability of information that is needed to address data limitations. Factors such as estimation methodology affect data quality. Some updates to method codes assigned in 2015 and assignment of method codes to earlier compilation datasets for all categories would provide much needed metadata for users of the data. Improvements in data documentation describing sources of information and estimation methods and additional metadata information from agencies and entities that furnish water-use data, would enable a more complete understanding and depiction of water-use patterns and trends. Additional metadata are needed for users of the data to better understand the water-use data and interpret changes in water use across the United States and with time.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 17.916022703877665° to 71.35706654962706° latitude; -178.2421875° to -65.2587890625° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Carol L. Luukkonen, Kenneth Belitz, Samantha L. Sullivan, Pierre Sargent. 2021-11-15. Factors affecting uncertainty of public supply, self-supplied domestic, irrigation, and thermoelectric water-use data, 1985–2015—Evaluation of information sources, estimation methods, and data variability. https://doi.org/10.3133/sir20215082

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Karst hydrologic processes in carbonate fensters of the western Great Smoky Mountains, Tennessee, 2017–18

The geology of the Great Smoky Mountains in Tennessee and North Carolina is dominated by metamorphic strata. Along the western extent of the range, however, several carbonate fensters expose the Ordovician Jonesboro Limestone along the western edge of the Great Smoky Fault. The fensters (Cades Cove, Tuckaleechee Cove, and Wear Cove) create opportunities for allogenic recharge at the contact between the surrounding, relatively insoluble, strata and the underlying soluble formations, resulting in the development of karst systems. Karst environments have a high degree of connectivity between surface streams and groundwater systems; thus, karst aquifers are inherently vulnerable to contamination from surface activities. Karst environments also provide a specific environment for sensitive biota. Protection of the unique resources of karst environments requires an understanding of the behavior of karst aquifers, knowledge of karst recharge areas, and the mapping of groundwater flow paths. A study began in 2017 to characterize the hydrologic behavior of the karst systems in Great Smoky Mountains National Park through hydrologic monitoring, dye tracing, and seepage investigations. Hydrologic monitoring equipment was installed at several karst hydrogeologic features: two in-cave sites, two major springs, Abrams Creek in Cades Cove, and a karst depression wetland. Dye tracing was conducted to determine resurgences for the cave systems, to delineate spring recharge areas, and to estimate karst groundwater velocities. Seepage investigations along Abrams Creek helped determine if streams were sinking into the Jonesboro Limestone, either at the contact with insoluble strata or as streams flowed across the carbonate fenster. Study results indicate considerable differences in groundwater behavior between the conduit-dominated flow systems in Tuckaleechee Cove compared to the lower-gradient, colluvium-covered karst systems in Cades Cove. Study results also indicate that contaminants in the area of Bull sink and Whiteoak Sink could be rapidly transported through karst groundwater towards springs in Tuckaleechee Cove. Karst resources in Cades Cove are most likely to be affected by local events or activities taking place within the cove itself or in upper Abrams Creek upstream of the Great Smoky Fault. This study provides information on the vulnerability and uniqueness of the karst systems in the western Great Smoky Mountains, which are characterized by complex geology, high-gradient subterranean streams, deep caves, and carbonate fensters.

Tennessee↗

Analysis of groundwater geochemistry in the Lansing, Michigan, area

Groundwater resources in the Lansing, Michigan, area are protected by a wellhead protection plan, but previous studies have indicated that groundwater in this area may be susceptible to surface contamination. The U.S. Geological Survey, in cooperation with the Lansing Board of Water & Light, analyzed geochemical and aquifer characteristics to assess the potential for contamination of groundwater resources. Recharge age categories were determined from tritium concentrations for some wells, and by using ternary diagrams and principal component analysis for other wells. These age classifications, combined with hydrogeologic and geochemical data, were analyzed by using statistical methods to identify trends that may indicate areas of increased groundwater susceptibility. Wells with modern recharge tended to have higher sodium, chloride, and chloride:bromide ratios than did wells with mixed recharge, suggesting greater surface connectivity and potential influence from anthropogenic sources such as road salt. In contrast, wells in the mixed age category exhibited more stable geochemistry and lower constituent concentrations. Classification and regression tree models identified aquifer geometry—particularly the thickness of the uppermost bedrock unit and presence of confining layers—as key predictors of recharge age and geochemical indicators. The trends identified from these analyses could help to reveal locations in the Lansing area that are among the most susceptible to contamination.

Michigan↗

Evaluating the number of realizations (train-test splits) necessary to ensure robust estimates of conventional hydrothermal resource favorability using Monte Carlo cross-validation, the Great Basin, Western USA

Supervised machine learning approaches used to produce favorability maps in resource assessments commonly partition an input dataset into training and testing subsets (that is, through train-test splits). However, if a single split is not representative of underlying resource conditions, the resulting favorability map may be biased, particularly with sparse or heterogeneous datasets. To mitigate the potential for unrepresentative favorability maps, recent works by U.S. Geological Survey researchers have used Monte Carlo cross-validation to implement a large number ( n) of randomized train-test splits to produce n realizations. The realizations are then aggregated using cell-wise median predictions to produce the resulting final favorability map, recognizing that the median will remove extreme values that might have been estimated from a comparatively few unrepresentative realizations. Theoretically, the median prediction at every cell converges to a single estimate as n approaches infinity, and the question addressed herein is: How many realizations are necessary to get a robust estimate (that is, an estimate unaffected by additional realizations)? Therefore, convergence metrics are described to identify the number of train-test splits and realizations needed to make a reliable map using the data and supervised machine learning workflow for conventional hydrothermal resource assessment of the Great Basin of the Western United States. For this study, robust prediction occurs with n approximately equal to 600 realizations, and smaller ensembles (for example, n is approximately equal to 200 or even 100) may be suitable during preliminary or exploratory analyses. Although the resulting threshold numbers will vary depending on the data and modeling approach used, the convergence metrics proposed and applied herein are applicable to other supervised machine learning studies that use Monte Carlo cross-validation.

California, Idaho, Nevada, Oregon, Utah↗