Effects of climate and land-use change on thermal springs recharge—A system-based coupled surface-water and groundwater-flow model for Hot Springs National Park, Arkansas

Rheannon M. Hart; Scott J. Ikard; Phillip D. Hays; Brian R. Clark

doi:10.3133/sir20215045

Home/Archive/USGS

USGS · sir20215045

Effects of climate and land-use change on thermal springs recharge—A system-based coupled surface-water and groundwater-flow model for Hot Springs National Park, Arkansas

Rheannon M. Hart·Scott J. Ikard·Phillip D. Hays·Brian R. Clark

View original source ↗Read source document ↗Export metadata ↓

Abstract

A three-dimensional hydrogeologic framework of the Hot Springs anticlinorium beneath Hot Springs National Park, Arkansas, was constructed to represent the complex hydrogeology of the park and surrounding areas to depths exceeding 9,000 feet below ground surface. The framework, composed of 6 rock formations and 1 vertical fault emplaced beneath the thermal springs, was discretized into 19 layers, 429 rows, and 576 columns and incorporated into a 3-dimensional steady-state groundwater-flow model constructed in MODFLOW-2005. Historical daily mean thermal spring flows were simulated for one stress period of approximately 34 years (1980–2014), chosen to represent the period of record for historical climate data used in the quantification of the boundary conditions. The groundwater-flow model was manually calibrated to historical daily mean thermal spring flows of 88,000 cubic feet per day observed over a 12-year period of record (1990–1995 and 1998–2005) at the thermal springs collection system. Calibration was achieved by calculating starting heads and general head boundary conditions from the Bernoulli equation and then adjusting the horizontal and vertical hydraulic conductivities of the rock formations and vertical fault and the hydraulic conductance of head-dependent flux boundaries. The groundwater-flow model was coupled to a surface-water model developed in the Precipitation-Runoff Modeling System (PRMS) by using PRMS-simulated gravity drainage as a specified flux recharge boundary condition in the groundwater-flow model. Together, the coupled models were used to (1) locate the areas of groundwater recharge to the thermal springs in the discretized hydrogeologic framework by using forward and reverse particle-tracking capabilities of MODPATH, (2) simulate the effects of variable recharge rates on the spring flows at the thermal springs, and (3) assess possible effects of climate and land-use change on the long-term variability of spring flows at the thermal springs. Forward and backward particle-tracking maps indicated that the most prevalent areas of recharge in the discretized hydrogeologic framework used in this study were within about 0.6–0.9 mile of the thermal springs. Forward particle tracking indicated a recharge area southwest of the thermal springs that corresponded to a location where the predominant lithologies are the Arkansas Novaculite, Hot Springs Sandstone, and Bigfork Chert. Backward particle tracking indicated a second localized area of recharge to the northeast of the thermal springs that corresponded to a location where the dominant lithology is the Bigfork Chert. The groundwater-flow model indicated that the most probable recharge formations are the Arkansas Novaculite, Bigfork Chert, and Hot Springs Sandstone. The simulated effects of climate and land-use changes on the variability of the spring-flow rates at the thermal springs generally resulted in reductions of thermal spring flow attributed to urban development and more extreme climates characterized by elevated mean surface air temperatures. The groundwater-flow model predicted a linear relation between the thermal spring discharge and the cumulative recharge volume applied to the hydrogeologic framework, and the positive slope of the predicted relation between recharge and simulated thermal spring flow indicates that more extreme precipitation events that supply more recharge may in fact increase the thermal spring-flow rates.

Explore related subjects

Scientific Investigations Report Report

Source-reported bounding extent: 34.487881874939866° to 34.57273337081573° latitude; -93.1475830078125° to -92.96012878417969° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Rheannon M. Hart, Scott J. Ikard, Phillip D. Hays, Brian R. Clark. 2021-06-14. Effects of climate and land-use change on thermal springs recharge—A system-based coupled surface-water and groundwater-flow model for Hot Springs National Park, Arkansas. https://doi.org/10.3133/sir20215045

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Slip tendency and dilation tendency of Quaternary faults in the Great Basin region, Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming

This report presents the results of slip tendency and dilation tendency analysis of Quaternary faults in the Great Basin region, in the states of Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming. This effort was undertaken as part of two studies: the U.S. Department of Energy Geothermal Technologies Office-funded Innovative Geothermal Exploration through Novel Investigations of Undiscovered Systems (INGENIOUS) project, which is a multidisciplinary, multi-institution effort to develop new methodologies and best practices to accelerate the discovery of new, commercially viable hydrothermal resources; and the U.S. Geological Survey Geothermal Resources Investigations Project. The goal of this work is to identify faults and fault segments that are appropriately oriented to be stress-loaded for slip or to dilate under the ambient stress conditions. Both conditions may make such faults more likely to host permeability and fluid flow relative to other faults in the region. Slip tendency and dilation tendency were calculated for all fault segments in the study area from the U.S. Geological Survey Quaternary Fault and Fold Database. Results demonstrate that faults with high slip tendency and dilation tendency are common in the Great Basin region. The areas containing many high slip tendency and dilation tendency fault segments are associated with high strain rates. These areas also host a relatively high proportion of the known hydrothermal systems. This indicates that faults with high slip tendency and dilation tendency in areas with high strain-rate are potentially most prospective for hosting hydrothermal systems. The database published in coordination with this report contains the slip tendency and dilation tendency results data, including the fault geometry and stress data used to calculate these quantities, for both the Great Basin study area and the smaller INGENIOUS study area.

Arizona, California, Idaho, Nevada, Oregon, Utah, ↗

USGS2026

A spatial analysis of the groundwater emergence flood hazard in Long Island, New York, and coastal areas surrounding Long Island Sound in New York, Connecticut, and Rhode Island

Long Island, New York, and nearby coastal areas surrounding Long Island Sound are densely populated and, like other coastal areas, are susceptible to flooding from several potential sources, including stormwater from precipitation events, tidal flooding and storm surge, and groundwater emergence flooding. Groundwater emergence fooding refers to the intersection of a rising water table with land surface or critical infrastructure. Many studies of flood drivers either neglect or only briefly discuss how shallow groundwater conditions may contribute to or exacerbate flood conditions. As a part of a comprehensive study of compound flood hazards in the coastal areas of Long Island and Long Island Sound, a spatial analysis was completed by the U.S. Geological Survey, in cooperation with the Environmental Protection Agency’s Long Island Sound Partnership, formerly called the Long Island Sound Study, using available regional datasets to characterize the potential hazard for groundwater emergence flooding. The approximately 3,100 square mile study area was subdivided into 11,407 grid cells that were 900 meters by 900 meters (approximately 3,000 feet by 3,000 feet), for the purpose of integrating the spatial datasets to calculate and map the groundwater emergence flood hazard. The depth to the water table, hydrologic soil groups, and National Land Cover Database were harmonized to the common grid. A groundwater emergence flood hazard score was calculated for each grid cell for current average conditions following a set of rules accounting for the depth to the water table and the percentage of area within each cell with slow infiltrating soils. A scenario with a higher sea-level position was also calculated for the Long Island part of the study area. The calculated groundwater emergence flood hazard score was reviewed in conjunction with the National Land Cover Database to identify developed areas and associated infrastructure that may be at risk of potential groundwater emergence flooding. Study results indicate that the groundwater emergence flood hazard is highest in coastal areas and near surface water where the water table is close to ground surface. Inland areas away from surface waterbodies are not likely to be exposed to groundwater emergence flooding. For Long Island, in the scenario with higher sea-level position, a greater groundwater emergence flood hazard is calculated for some locations closer to the coast and where land is submerged. Away from the coast and surface-water drainage, the groundwater emergence flood hazard is similar between the current average sea-level condition and the higher sea-level position scenario.

Connecticut, New York, Rhode Island↗

USGS2026

Streamflow assessment of Birch Creek, southern boundary of the Blackfeet Indian Reservation, Pondera County, northwestern Montana—Synoptic and continuous streamflow measurements through 2022

The U.S. Geological Survey, in cooperation with the Blackfeet Water Department, performed this study to assist water-resource managers in understanding and quantifying irrigation diversions, instream flows, and the spatial and temporal streamflow dynamics of Birch Creek in northwestern Montana. Birch Creek forms the southernmost boundary of the Blackfeet Indian Reservation and is highly valued culturally as an aquatic life and wildlife resource and as a principal source of water for irrigation. The study area included Birch Creek from Swift Dam to 53.3 miles downstream just above its confluence with the Two Medicine River. The study period was calendar year 2022, but selected historical information was also included in the study. Birch Creek streamflow originates through releases from Swift Reservoir, with the largest releases typically occurring during the irrigation season (May–October) to primarily meet the needs of downstream irrigators. This study included the compilation and collection of (1) continuous streamflow measured at streamgages installed for this study, (2) instantaneous streamflow measurements made during four synoptic events, and (3) reported daily values of Swift Reservoir outflow and irrigation diversions. Continuous streamflow data were available from two U.S. Geological Survey streamgages: Birch Creek below Heart Butte Road, near Heart Butte, Montana (upper streamgage; station 06094900), at river mile 12.9 and Birch Creek at Bullhead Bridge near Valier, Mont. (lower streamgage; station 06098120), at river mile 53.3. The upper streamgage (station 06094900) was primarily affected by the regulated releases from Swift Dam with daily mean streamflow typically slightly higher than the reported Swift Reservoir outflows. Daily mean streamflow ranged from 9.87 cubic feet per second (ft 3 /s) (November 18, 2022) to 640 ft 3 /s (June 22, 2022) during September 16, 2021–December 31, 2022. The mean annual streamflow was 122 ft 3 /s in water year 2022 (a water year is the 12-month period from October 1 to September 30 and is designated by the year in which it ends), about 13 percent greater than the mean annual reported Swift Reservoir outflows. The lower streamgage (station 06098120) was downstream from all major tributaries and diversions within the Birch Creek drainage basin. Daily mean streamflow ranged from 6.02 ft 3 /s (September 8, 2022) to 95.0 ft 3 /s (June 5, 2021) during August 26, 2020–December 31, 2022. Mean annual streamflow was 27.8 ft 3 /s for water year 2022. Flows at the lower streamgage (station 06098120) were typically lower than at the upper streamgage (station 06094900) from late April to early October, whereas flows from early October to late spring were similar to or greater than those at the upper streamgage. The upper streamgage had a total streamflow volume of 87,960 acre-feet (acre-ft) for water year 2022, whereas the lower streamgage had a total streamflow of 20,357 acre-ft. A net volume of about 67,603 acre-ft was removed from Birch Creek through diversions, losses to groundwater, and evapotranspiration along that reach during water year 2022. Most of the changes in main-stem streamflow could be accounted for by the tributary inflows or diversion outflows. The most dynamic streamflow gains and losses occurred along the upper few miles of Birch Creek. Streamflow was consistently lost to the groundwater system immediately below Swift Dam and then returned to levels that slightly exceeded the outflow at the dam near river mile 11.0. The overall net gains for the entire 53.3-mile study reach ranged from 15.5 to 42.6 ft 3 /s among the synoptic events. On several occasions, streamflow fell below minimum instream flow conditions specified in the Blackfeet Compact (water rights compact among the Blackfeet Tribe, State of Montana, and United States), which are subject to a 15-year deferral period (until June 12, 2033). Notably, a section of Birch Creek immediately downstream from Swift Dam was completely dry during the October 18, 2022, synoptic event.

Montana↗