Assessing water quality from highway runoff at selected sites in North Carolina with the Stochastic Empirical Loading and Dilution Model (SELDM)

J. Curtis Weaver; Gregory E. Granato; Sharon A. Fitzgerald

doi:10.3133/sir20195031

Home/Archive/USGS

USGS · sir20195031

Assessing water quality from highway runoff at selected sites in North Carolina with the Stochastic Empirical Loading and Dilution Model (SELDM)

J. Curtis Weaver·Gregory E. Granato·Sharon A. Fitzgerald

View original source ↗Read source document ↗Export metadata ↓

Abstract

In 2015, the U.S. Geological Survey (USGS) entered into a cooperative agreement with the North Carolina Department of Transportation (NCDOT) to develop a North Carolina-enhanced variation of the national Stochastic Empirical Loading and Dilution Model (SELDM) with available North Carolina-specific streamflow and water-quality data and to demonstrate use of the model by documenting selected simulation scenarios. The USGS developed the national SELDM in cooperation with the Federal Highway Administration (FHWA) to provide the tools and techniques necessary for performing stormwater-quality simulations. SELDM uses a stochastic mass-balance approach to estimate combinations of flows, concentrations, and loads of stormwater constituents from the site of interest (often a highway catchment; nonhighway areas, such as a large impervious area at a shopping center complex, also can be used) and the basin upstream from the stormwater outfall to assess the risk for adverse effects of runoff. SELDM also can be used to simulate the effectiveness of volume reduction, hydrograph extension, and water-quality concentration reductions by stormwater best management practices (BMPs), which are designed to help mitigate the effects of runoff on receiving water bodies. Some of the statistical inputs needed for the North Carolina-enhanced SELDM were either calculated or augmented using local or regional data from North Carolina. Streamflow statistics used by SELDM were determined for 266 streamgages across North Carolina on the basis of data available through the 2015 water year. Recession ratio statistics used for triangular hydrographs were also developed for 30 streamgages across the State. The NCDOT identified previous research reports on highway-runoff and BMP studies in North Carolina for review of potential data addition to the national FHWA Highway-Runoff Database (HRDB). Following USGS review of these data, a total of 25,087 event mean concentration values and 1,140 storm events for 39 highway-runoff sites and 195 analytes were uploaded to the national HRDB from six North Carolina highway-runoff research reports and a recent USGS bridge deck runoff study. Using data for 27 streamgages in North Carolina, a total of 57 water-quality transport curves were developed for seven constituents for use in simulating water-quality conditions in the upstream basin. Performance data for three BMPs (bioretention, grass strip or swale, and wetland channel) from NCDOT research data were incorporated into the North Carolina-enhanced SELDM for volume-reduction statistics, including the effectiveness of treating four water-quality constituents (total suspended solids, total nitrogen, total phosphorus, nitrate plus nitrite) and turbidity. Simulations using the North Carolina-enhanced SELDM are presented for two hypothetical upstream basins in the Piedmont ecoregion and one hypothetical highway site to demonstrate how simulations can be used to provide risk-based information about potential effects of stormwater runoff on downstream water quality and the potential for mitigating those risks by using BMPs. The first group of simulations explores the stochastic variability in dilution factors (the ratio of the highway runoff to the total downstream stormflow) for a hypothetical Piedmont rural creek having drainage areas ranging from 1 to 100 square miles. The second group of simulations examines dilution factors based on variations in precipitation, streamflow, and recession ratios for two hypothetical Piedmont upstream basins (rural and urban) where the drainage area was held constant at 25 square miles. These simulations indicate the sensitivity of results to variations in each of the three variables. The third group of simulations examines the effects of varied concentrations in the upstream basin on water-quality conditions downstream from the highway crossing. Variations in upstream water-quality conditions for three constituents (suspended sediment concentration, total nitrogen, and total phosphorus) are based on water-quality transport curves selected from among the 57 curves developed as part of this study to represent low-, medium-, and high-concentration statistics. Simulations completed for this third group also examine the potential effects of grass swale and bioretention BMP treatment on total nitrogen and total phosphorus concentrations in highway runoff. The BMP performance data from the NCDOT research reports were applied in this group of simulations. The stochastic mass-balance approach used in SELDM analyses and simulations provides a strong tool for engineers and water-resource managers to use in exploring a wide range of possible hydrologic and water-quality inputs and their effects on downstream water quality. The results of this study can not only aid engineers and managers in planning for potential adverse effects of runoff at site-specific locations, they can also help the USGS and other Federal and State agencies with oversight responsibilities in stormwater-quality issues to continue gathering data on potential water-quality effects in receiving streams.

Explore related subjects

Scientific Investigations Report Report

Source-reported bounding extent: 33.844517° to 36.588117° latitude; -84.321869° to -75.458659° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

J. Curtis Weaver, Gregory E. Granato, Sharon A. Fitzgerald. 2019-05-20. Assessing water quality from highway runoff at selected sites in North Carolina with the Stochastic Empirical Loading and Dilution Model (SELDM). https://doi.org/10.3133/sir20195031

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Slip tendency and dilation tendency of Quaternary faults in the Great Basin region, Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming

This report presents the results of slip tendency and dilation tendency analysis of Quaternary faults in the Great Basin region, in the states of Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming. This effort was undertaken as part of two studies: the U.S. Department of Energy Geothermal Technologies Office-funded Innovative Geothermal Exploration through Novel Investigations of Undiscovered Systems (INGENIOUS) project, which is a multidisciplinary, multi-institution effort to develop new methodologies and best practices to accelerate the discovery of new, commercially viable hydrothermal resources; and the U.S. Geological Survey Geothermal Resources Investigations Project. The goal of this work is to identify faults and fault segments that are appropriately oriented to be stress-loaded for slip or to dilate under the ambient stress conditions. Both conditions may make such faults more likely to host permeability and fluid flow relative to other faults in the region. Slip tendency and dilation tendency were calculated for all fault segments in the study area from the U.S. Geological Survey Quaternary Fault and Fold Database. Results demonstrate that faults with high slip tendency and dilation tendency are common in the Great Basin region. The areas containing many high slip tendency and dilation tendency fault segments are associated with high strain rates. These areas also host a relatively high proportion of the known hydrothermal systems. This indicates that faults with high slip tendency and dilation tendency in areas with high strain-rate are potentially most prospective for hosting hydrothermal systems. The database published in coordination with this report contains the slip tendency and dilation tendency results data, including the fault geometry and stress data used to calculate these quantities, for both the Great Basin study area and the smaller INGENIOUS study area.

Arizona, California, Idaho, Nevada, Oregon, Utah, ↗

USGS2026

A spatial analysis of the groundwater emergence flood hazard in Long Island, New York, and coastal areas surrounding Long Island Sound in New York, Connecticut, and Rhode Island

Long Island, New York, and nearby coastal areas surrounding Long Island Sound are densely populated and, like other coastal areas, are susceptible to flooding from several potential sources, including stormwater from precipitation events, tidal flooding and storm surge, and groundwater emergence flooding. Groundwater emergence fooding refers to the intersection of a rising water table with land surface or critical infrastructure. Many studies of flood drivers either neglect or only briefly discuss how shallow groundwater conditions may contribute to or exacerbate flood conditions. As a part of a comprehensive study of compound flood hazards in the coastal areas of Long Island and Long Island Sound, a spatial analysis was completed by the U.S. Geological Survey, in cooperation with the Environmental Protection Agency’s Long Island Sound Partnership, formerly called the Long Island Sound Study, using available regional datasets to characterize the potential hazard for groundwater emergence flooding. The approximately 3,100 square mile study area was subdivided into 11,407 grid cells that were 900 meters by 900 meters (approximately 3,000 feet by 3,000 feet), for the purpose of integrating the spatial datasets to calculate and map the groundwater emergence flood hazard. The depth to the water table, hydrologic soil groups, and National Land Cover Database were harmonized to the common grid. A groundwater emergence flood hazard score was calculated for each grid cell for current average conditions following a set of rules accounting for the depth to the water table and the percentage of area within each cell with slow infiltrating soils. A scenario with a higher sea-level position was also calculated for the Long Island part of the study area. The calculated groundwater emergence flood hazard score was reviewed in conjunction with the National Land Cover Database to identify developed areas and associated infrastructure that may be at risk of potential groundwater emergence flooding. Study results indicate that the groundwater emergence flood hazard is highest in coastal areas and near surface water where the water table is close to ground surface. Inland areas away from surface waterbodies are not likely to be exposed to groundwater emergence flooding. For Long Island, in the scenario with higher sea-level position, a greater groundwater emergence flood hazard is calculated for some locations closer to the coast and where land is submerged. Away from the coast and surface-water drainage, the groundwater emergence flood hazard is similar between the current average sea-level condition and the higher sea-level position scenario.

Connecticut, New York, Rhode Island↗

USGS2026

Streamflow assessment of Birch Creek, southern boundary of the Blackfeet Indian Reservation, Pondera County, northwestern Montana—Synoptic and continuous streamflow measurements through 2022

The U.S. Geological Survey, in cooperation with the Blackfeet Water Department, performed this study to assist water-resource managers in understanding and quantifying irrigation diversions, instream flows, and the spatial and temporal streamflow dynamics of Birch Creek in northwestern Montana. Birch Creek forms the southernmost boundary of the Blackfeet Indian Reservation and is highly valued culturally as an aquatic life and wildlife resource and as a principal source of water for irrigation. The study area included Birch Creek from Swift Dam to 53.3 miles downstream just above its confluence with the Two Medicine River. The study period was calendar year 2022, but selected historical information was also included in the study. Birch Creek streamflow originates through releases from Swift Reservoir, with the largest releases typically occurring during the irrigation season (May–October) to primarily meet the needs of downstream irrigators. This study included the compilation and collection of (1) continuous streamflow measured at streamgages installed for this study, (2) instantaneous streamflow measurements made during four synoptic events, and (3) reported daily values of Swift Reservoir outflow and irrigation diversions. Continuous streamflow data were available from two U.S. Geological Survey streamgages: Birch Creek below Heart Butte Road, near Heart Butte, Montana (upper streamgage; station 06094900), at river mile 12.9 and Birch Creek at Bullhead Bridge near Valier, Mont. (lower streamgage; station 06098120), at river mile 53.3. The upper streamgage (station 06094900) was primarily affected by the regulated releases from Swift Dam with daily mean streamflow typically slightly higher than the reported Swift Reservoir outflows. Daily mean streamflow ranged from 9.87 cubic feet per second (ft 3 /s) (November 18, 2022) to 640 ft 3 /s (June 22, 2022) during September 16, 2021–December 31, 2022. The mean annual streamflow was 122 ft 3 /s in water year 2022 (a water year is the 12-month period from October 1 to September 30 and is designated by the year in which it ends), about 13 percent greater than the mean annual reported Swift Reservoir outflows. The lower streamgage (station 06098120) was downstream from all major tributaries and diversions within the Birch Creek drainage basin. Daily mean streamflow ranged from 6.02 ft 3 /s (September 8, 2022) to 95.0 ft 3 /s (June 5, 2021) during August 26, 2020–December 31, 2022. Mean annual streamflow was 27.8 ft 3 /s for water year 2022. Flows at the lower streamgage (station 06098120) were typically lower than at the upper streamgage (station 06094900) from late April to early October, whereas flows from early October to late spring were similar to or greater than those at the upper streamgage. The upper streamgage had a total streamflow volume of 87,960 acre-feet (acre-ft) for water year 2022, whereas the lower streamgage had a total streamflow of 20,357 acre-ft. A net volume of about 67,603 acre-ft was removed from Birch Creek through diversions, losses to groundwater, and evapotranspiration along that reach during water year 2022. Most of the changes in main-stem streamflow could be accounted for by the tributary inflows or diversion outflows. The most dynamic streamflow gains and losses occurred along the upper few miles of Birch Creek. Streamflow was consistently lost to the groundwater system immediately below Swift Dam and then returned to levels that slightly exceeded the outflow at the dam near river mile 11.0. The overall net gains for the entire 53.3-mile study reach ranged from 15.5 to 42.6 ft 3 /s among the synoptic events. On several occasions, streamflow fell below minimum instream flow conditions specified in the Blackfeet Compact (water rights compact among the Blackfeet Tribe, State of Montana, and United States), which are subject to a 15-year deferral period (until June 12, 2033). Notably, a section of Birch Creek immediately downstream from Swift Dam was completely dry during the October 18, 2022, synoptic event.

Montana↗