Geomorphic characteristics of Tenmile Creek, Montgomery County, Maryland, 2014–16

Edward J. Doheny; S. Matthew Baker

doi:10.3133/sir20185098

Home/Archive/USGS

USGS · sir20185098

Geomorphic characteristics of Tenmile Creek, Montgomery County, Maryland, 2014–16

Edward J. Doheny·S. Matthew Baker

View original source ↗Read source document ↗Export metadata ↓

Abstract

Data collected from April 2014 through September 2016 were used to assess geomorphic characteristics and geomorphic changes over time in a selected reach of Tenmile Creek, a small rural watershed near Clarksburg, Maryland. Longitudinal profiles of the channel bed, water surface, and bank features were developed from field surveys. Changes in cross-section geometry between field surveys were documented. Grain-size distributions for the channel bed were developed from pebble counts. Continuous-record streamflow and precipitation data were also collected in the Tenmile Creek watershed and used to supplement the geomorphic analyses. The Rosgen system of stream classification was used to classify the stream channel according to morphological measurements of slope, entrenchment ratio, width-to-depth ratio, sinuosity, and median particle diameter of the channel materials. Boundary shear stress near the U.S. Geological Survey (USGS) streamflow-gaging station was assessed by using hydraulic variables computed from the cross-section surveys and slope measurements derived from crest-stage gages and temporary data loggers installed along the study reach. Analysis of the longitudinal profiles indicated relatively small changes in the percentage and distribution of riffles, pools, and runs in the study reach between April 2014 and March 2015. More noticeable changes were observed during surveys conducted in March 2016 and September 2016. The channel-bed slope showed a net reduction over time from 0.0072 to 0.0040 feet per foot (ft/ft). The low-flow water-surface slope also showed a net reduction over time from 0.0065 to 0.0045 ft/ft. Net aggradation in the lower section of the study reach combined with net degradation in the upper section of the study reach contributed to the net reduction in channel-bed and water-surface slope. The large storm and resulting flood on July 30, 2016 was a major factor in observed changes in the longitudinal profiles between the March 2016 and September 2016 surveys. Comparison of data from the cross-sectional surveys indicated vertical changes in all cross sections, with more extreme changes observed between surveys in the lower section of the study reach due in part to alternating periods of net storage and transport of sand. Lateral erosion was not a major factor in the study reach, with the exception of cross section Dd, where considerable lateral erosion was documented during the study period. The flood that resulted from the large storm on July 30, 2016 was a major factor in some of the vertical changes observed in the channel bed of the study reach cross sections. Particle-size analyses of the channel bed from pebble counts indicated median particle diameters ranging from 15.5 millimeters (mm) to 23.1 mm, which is characterized as medium to coarse gravel. Sand percentages ranging from 3.4 percent to 16.4 percent of the total counts were observed over time. Net increases in storage of fine sediment in the reach were observed between April 2014 and March 2016, and a considerable reduction in storage was observed between March 2016 and September 2016. The Tenmile Creek stream channel was classified as a C4 channel, based on morphological descriptions from the Rosgen system of stream classification. The C4 classification describes a single-thread channel with a slight entrenchment ratio; a moderate to high width-to-depth ratio; moderate to high sinuosity; a water-surface slope of less than 2 percent; and a median particle diameter in the gravel range of 2 to 64 mm. The analysis of boundary shear stress indicated a range of 0.35 to 1.18 pounds per square foot for instantaneous streamflow ranging from 79 to 2,860 cubic feet per second during the study period. The relation between discharge and boundary shear stress for Tenmile Creek was compared to similar relations that were previously developed for Minebank Run, a small, urban watershed in the eastern section of the Piedmont Physiographic Province in Baltimore County, Md. that was physically restored during 2004–05. The comparison indicated a much flatter slope in the relation for Minebank Run in both its unrestored and restored conditions. This difference in the relations indicates that the erosive power in the urban watershed of Minebank Run is much more sensitive to increases in discharge magnitude than in the non-urban watershed of Tenmile Creek.

Explore related subjects

Scientific Investigations Report Report

Source-reported bounding extent: 39.2075° to 39.2492° latitude; -77.3356° to -77.2786° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Edward J. Doheny, S. Matthew Baker. 2018-10-22. Geomorphic characteristics of Tenmile Creek, Montgomery County, Maryland, 2014–16. https://doi.org/10.3133/sir20185098

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Karst hydrologic processes in carbonate fensters of the western Great Smoky Mountains, Tennessee, 2017–18

The geology of the Great Smoky Mountains in Tennessee and North Carolina is dominated by metamorphic strata. Along the western extent of the range, however, several carbonate fensters expose the Ordovician Jonesboro Limestone along the western edge of the Great Smoky Fault. The fensters (Cades Cove, Tuckaleechee Cove, and Wear Cove) create opportunities for allogenic recharge at the contact between the surrounding, relatively insoluble, strata and the underlying soluble formations, resulting in the development of karst systems. Karst environments have a high degree of connectivity between surface streams and groundwater systems; thus, karst aquifers are inherently vulnerable to contamination from surface activities. Karst environments also provide a specific environment for sensitive biota. Protection of the unique resources of karst environments requires an understanding of the behavior of karst aquifers, knowledge of karst recharge areas, and the mapping of groundwater flow paths. A study began in 2017 to characterize the hydrologic behavior of the karst systems in Great Smoky Mountains National Park through hydrologic monitoring, dye tracing, and seepage investigations. Hydrologic monitoring equipment was installed at several karst hydrogeologic features: two in-cave sites, two major springs, Abrams Creek in Cades Cove, and a karst depression wetland. Dye tracing was conducted to determine resurgences for the cave systems, to delineate spring recharge areas, and to estimate karst groundwater velocities. Seepage investigations along Abrams Creek helped determine if streams were sinking into the Jonesboro Limestone, either at the contact with insoluble strata or as streams flowed across the carbonate fenster. Study results indicate considerable differences in groundwater behavior between the conduit-dominated flow systems in Tuckaleechee Cove compared to the lower-gradient, colluvium-covered karst systems in Cades Cove. Study results also indicate that contaminants in the area of Bull sink and Whiteoak Sink could be rapidly transported through karst groundwater towards springs in Tuckaleechee Cove. Karst resources in Cades Cove are most likely to be affected by local events or activities taking place within the cove itself or in upper Abrams Creek upstream of the Great Smoky Fault. This study provides information on the vulnerability and uniqueness of the karst systems in the western Great Smoky Mountains, which are characterized by complex geology, high-gradient subterranean streams, deep caves, and carbonate fensters.

Tennessee↗

USGS2026

Analysis of groundwater geochemistry in the Lansing, Michigan, area

Groundwater resources in the Lansing, Michigan, area are protected by a wellhead protection plan, but previous studies have indicated that groundwater in this area may be susceptible to surface contamination. The U.S. Geological Survey, in cooperation with the Lansing Board of Water & Light, analyzed geochemical and aquifer characteristics to assess the potential for contamination of groundwater resources. Recharge age categories were determined from tritium concentrations for some wells, and by using ternary diagrams and principal component analysis for other wells. These age classifications, combined with hydrogeologic and geochemical data, were analyzed by using statistical methods to identify trends that may indicate areas of increased groundwater susceptibility. Wells with modern recharge tended to have higher sodium, chloride, and chloride:bromide ratios than did wells with mixed recharge, suggesting greater surface connectivity and potential influence from anthropogenic sources such as road salt. In contrast, wells in the mixed age category exhibited more stable geochemistry and lower constituent concentrations. Classification and regression tree models identified aquifer geometry—particularly the thickness of the uppermost bedrock unit and presence of confining layers—as key predictors of recharge age and geochemical indicators. The trends identified from these analyses could help to reveal locations in the Lansing area that are among the most susceptible to contamination.

Michigan↗

USGS2026

Evaluating the number of realizations (train-test splits) necessary to ensure robust estimates of conventional hydrothermal resource favorability using Monte Carlo cross-validation, the Great Basin, Western USA

Supervised machine learning approaches used to produce favorability maps in resource assessments commonly partition an input dataset into training and testing subsets (that is, through train-test splits). However, if a single split is not representative of underlying resource conditions, the resulting favorability map may be biased, particularly with sparse or heterogeneous datasets. To mitigate the potential for unrepresentative favorability maps, recent works by U.S. Geological Survey researchers have used Monte Carlo cross-validation to implement a large number ( n) of randomized train-test splits to produce n realizations. The realizations are then aggregated using cell-wise median predictions to produce the resulting final favorability map, recognizing that the median will remove extreme values that might have been estimated from a comparatively few unrepresentative realizations. Theoretically, the median prediction at every cell converges to a single estimate as n approaches infinity, and the question addressed herein is: How many realizations are necessary to get a robust estimate (that is, an estimate unaffected by additional realizations)? Therefore, convergence metrics are described to identify the number of train-test splits and realizations needed to make a reliable map using the data and supervised machine learning workflow for conventional hydrothermal resource assessment of the Great Basin of the Western United States. For this study, robust prediction occurs with n approximately equal to 600 realizations, and smaller ensembles (for example, n is approximately equal to 200 or even 100) may be suitable during preliminary or exploratory analyses. Although the resulting threshold numbers will vary depending on the data and modeling approach used, the convergence metrics proposed and applied herein are applicable to other supervised machine learning studies that use Monte Carlo cross-validation.

California, Idaho, Nevada, Oregon, Utah↗