USGS Science⌕ Search

USGS · sir20155036

Analysis of storm-tide impacts from Hurricane Sandy in New York

Abstract

The hybrid cyclone-nor’easter known as Hurricane Sandy affected the mid-Atlantic and northeastern United States during October 28-30, 2012, causing extensive coastal flooding. Prior to storm landfall, the U.S. Geological Survey (USGS) deployed a temporary monitoring network from Virginia to Maine to record the storm tide and coastal flooding generated by Hurricane Sandy. This sensor network augmented USGS and National Oceanic and Atmospheric Administration (NOAA) networks of permanent monitoring sites that also documented storm surge. Continuous data from these networks were supplemented by an extensive post-storm high-water-mark (HWM) flagging and surveying campaign. The sensor deployment and HWM campaign were conducted under a directed mission assignment by the Federal Emergency Management Agency (FEMA). The need for hydrologic interpretation of monitoring data to assist in flood-damage analysis and future flood mitigation prompted the current analysis of Hurricane Sandy by the USGS under this FEMA mission assignment. The analysis of storm-tide impacts focused on three distinct but related aspects of coastal flooding from Hurricane Sandy, including flooding inland along the tidal reach of the Hudson River. These aspects are (1) comparisons of peak storm-tide elevations to those of historical storms and to annual exceedance probabilities, (2) assessments of storm-surge characteristics, and (3) comparisons of maps of inundation extent that were derived from differing amounts of available storm-tide data. Most peak storm-tide elevations from Hurricane Sandy were greater than about 9.5 feet (ft) above North American Vertical Datum of 1988. Peak storm-tide elevations from Hurricane Sandy were compared with data for the intense nor’easter of December 11–13, 1992, and Hurricane Irene (August 27–28, 2011), which weakened to a tropical storm before arriving in New York. Peak storm-tide elevations from Hurricane Sandy were higher than those from the December 1992 nor’easter at 24 of 27 sites; most differences were greater than about 0.7 ft or 9 percent (above the historical storm tide). Peak storm-tide elevations from Hurricane Sandy were higher than those from Tropical Storm Irene at all sites; most differences were greater than about 2.5 ft or 48 percent. Data from permanent and temporary monitoring sites and HWM sites were compared with corresponding FEMA flood elevations for the 10-, 2-, 1-, and 0.2-percent annual exceedance probabilities in New York. Peak storm-tide elevations from Hurricane Sandy had annual exceedance probabilities less than or equal to 1 percent and (or) greater than 0.2 percent at a plurality of sites—184 of 413. Peak storm-tide elevations greater than or equal to the 0.2-percent flood elevation accounted for 81 of 413 sites. Peak storm-tide elevations less than the 10-percent flood elevation accounted for only 10 of 413 sites. Data from selected permanent monitoring sites in the USGS and NOAA networks were used to assess storm-surge magnitude associated with the peak storm tide, and magnitude and timing of the peak storm surge. Most magnitudes of the peak storm surge were greater than about 8.3 ft, and most magnitudes of the storm surge component of the peak storm tide were greater than about 7.8 ft. Timing of peak storm surge arrival with respect to local phase of tide controlled where the most extreme peak storm-tide levels and coastal flooding occurred. This finding has bearing not only for locations impacted by the highest storm tides from Hurricane Sandy, but also for those that had the greatest storm surges yet were spared the worst flooding because of fortuitous timing during this storm. Results of FEMA Hazus Program (HAZUS) flood loss analyses performed for New York counties were compared for extents of storm-tide inundation from Hurricane Sandy mapped (1) pre-storm, (2) on November 11, 2012, and (3) on February 14, 2013. The resulting depictions of estimated total building stock losses document how differing amounts of available USGS data affect the resolution and accuracy of storm-tide inundation extents. Using the most accurate results from the final (February 14, 2013) inundation extent, estimated losses range from $380 million to $5.9 billion for individual New York counties; total estimated aggregate losses are about $23 billion for all New York counties. Quality of the inundation extents used in HAZUS analyses has a substantial effect on final results. These findings can be used to inform future post-storm reconstruction planning and estimation of insurance claims.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 40.371658891506094° to 42.827638636242284° latitude; -74.805908203125° to -71.5869140625° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Christopher Schubert, Ronald Busciolano, Paul P. Hearn, Ami N. Rahav, Riley Behrens, Jason S. Finkelstein, Jack Monti, Amy E. Simonson. 2015-07-21. Analysis of storm-tide impacts from Hurricane Sandy in New York. https://doi.org/10.3133/sir20155036

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Evaluating the number of realizations (train-test splits) necessary to ensure robust estimates of conventional hydrothermal resource favorability using Monte Carlo cross-validation, the Great Basin, Western USA

Supervised machine learning approaches used to produce favorability maps in resource assessments commonly partition an input dataset into training and testing subsets (that is, through train-test splits). However, if a single split is not representative of underlying resource conditions, the resulting favorability map may be biased, particularly with sparse or heterogeneous datasets. To mitigate the potential for unrepresentative favorability maps, recent works by U.S. Geological Survey researchers have used Monte Carlo cross-validation to implement a large number ( n) of randomized train-test splits to produce n realizations. The realizations are then aggregated using cell-wise median predictions to produce the resulting final favorability map, recognizing that the median will remove extreme values that might have been estimated from a comparatively few unrepresentative realizations. Theoretically, the median prediction at every cell converges to a single estimate as n approaches infinity, and the question addressed herein is: How many realizations are necessary to get a robust estimate (that is, an estimate unaffected by additional realizations)? Therefore, convergence metrics are described to identify the number of train-test splits and realizations needed to make a reliable map using the data and supervised machine learning workflow for conventional hydrothermal resource assessment of the Great Basin of the Western United States. For this study, robust prediction occurs with n approximately equal to 600 realizations, and smaller ensembles (for example, n is approximately equal to 200 or even 100) may be suitable during preliminary or exploratory analyses. Although the resulting threshold numbers will vary depending on the data and modeling approach used, the convergence metrics proposed and applied herein are applicable to other supervised machine learning studies that use Monte Carlo cross-validation.

Scientific Investigations Report↗

Groundwater budget for the Portneuf River Basin, southeastern Idaho

The U.S. Geological Survey, in cooperation with the Idaho Department of Water Resources, developed the first groundwater budget for the upper Portneuf River Basin in southeastern Idaho, a tributary of the Snake River. A groundwater budget for the Portneuf River Basin supports water resource and administrative management decisions within the basin and for downstream users of the eastern Snake River Plain aquifer. The analysis quantifies inflows, outflows, and residuals for an aquifer system defined by the Idaho Department of Water Resources under three recent precipitation conditions: an average year (2016), a dry year (2021), and a wet year (2023). The budget was calculated for the basin and for two subbasins delineated by the U.S. Geological Survey streamgage Portneuf River at Topaz, Idaho (13073000): the above Topaz subbasin, which includes the Portneuf-Gem valley, and the below Topaz subbasin, which includes Marsh Valley. Aquifer inflows include mountain-front recharge; areal recharge; recharge from applied water, including recharge from irrigation, canal seepage, and effluent returns; groundwater flow into the basin; and reservoir seepage. Outflows include groundwater pumping for agricultural, municipal, and domestic uses; subsurface outflow through the Portneuf gap; and discharge to streams as base flow. Estimated annual inflows for the full basin ranged from 116,880 acre-feet in 2021 to 154,880 acre-feet in 2023, and outflows ranged from 132,190 acre-feet in 2016 to 158,490 acre-feet in 2023. Basinwide residuals, the change in storage plus uncertainty, were −2,410 acre-feet in 2016, −18,410 acre-feet in 2021, and −3,610 acre-feet in 2023, and each subbasin had a mixture of negative and positive residuals. These basinwide results, interpreted as change in storage plus water-budget uncertainty, indicate minor net losses that increase with dry conditions, consistent with well depth-to-water measurements indicating gradual multi-decadal declines. Patterns in subbasin residuals are driven by irrigation practices and surface-water management; for example, the above Topaz subbasin relies more on groundwater for irrigation, resulting in more negative residuals during dry years. In contrast, the below Topaz subbasin depends more on surface water, producing positive residuals during dry years because of irrigation losses and canal seepage. The analyses for both subbasins indicate decades-long groundwater declines, which agree with the overall negative residuals calculated. The largest sources of uncertainty include climate inputs (precipitation and evapotranspiration) and poorly constrained components such as groundwater inflow and tributary stream infiltration. These findings provide insight into how climatic variables and irrigation practices affect groundwater inflows and outflows within the Portneuf River Basin.

Idaho↗

World minerals outlook—Antimony, copper, graphite, niobium, potash, silicon, silver, and tungsten through 2030

Demand for mineral commodities continues to increase owing to rapid technological advancements and global economic growth. To support this increase in demand, information about current and near-term supplies of these mineral commodities is essential. Such data help evaluate the health and stability of global supply chains and protect against potential supply risks. Current production and production capacity data coupled with information regarding near-term expected changes (such as facility closures, planned expansions, or the completion of new mineral production projects) can provide insight into expected future market developments and expected available supply of mineral commodities. This report within the “World Minerals Outlook” series analyzes data for antimony, copper, natural graphite, niobium, potash, silicon metal, silver, and tungsten—eight mineral commodities listed in the 2025 List of Critical Minerals. World production data from 2019 through 2025, as well as estimated world capacity data from 2023 through 2025 were analyzed. Using these data, near-term (2026–2030) expected world capacities were estimated. For antimony, copper, niobium, silicon metal, silver, and tungsten, modest increases in production capacity of 4 to 10 percent were expected between 2025 and 2030, whereas capacities for natural graphite and potash were expected to increase by about 18 to 20 percent.

Scientific Investigations Report↗