USGS Science⌕ Search

USGS · sir20095232

Examination of Direct Discharge Measurement Data and Historic Daily Data for Selected Gages on the Middle Mississippi River, 1861-2008

Abstract

An examination of data from two continuous stage and discharge streamgages and one continuous stage-only gage on the Middle Mississippi River was made to determine stage-discharge relation changes through time and to investigate cause-and-effect mechanisms through evaluation of hydraulic geometry, channel elevation and water-surface elevation data. Data from discrete, direct measurements at the streamgages at St. Louis, Missouri, and Chester, Illinois, during the period of operation by the U.S. Geological Survey from 1933 to 2008 were examined for changes with time. Daily stage values from the streamgages at St. Louis (1861-2008) and Chester (1891-2008) and the stage-only gage at Cape Girardeau, Missouri (1896-2008), throughout the historic period of record also were examined for changes with time. Stage and discharge from measurements and stage-discharge relations at the streamgages at St. Louis and Chester indicate that stage for a given discharge has changed with time at both locations. An apparent increase in stage for a given discharge at increased flows (greater than flood stage) likely is caused by the raising of levees on the flood plains, and a decrease in stage for a given discharge at low flows (less than one-half flood stage) likely is caused by a combination of dikes in the channel that deepen the channel thalweg at the end of the dikes, and reduced sediment flux into the Middle Mississippi River. Since the 1960s at St. Louis, Missouri, the stage-discharge relations indicated no change or a decrease in stage for a given discharge for all discharges, whereas at Chester, Illinois, the stage-discharge relations indicate increasing stage for a given discharge above bankfull because of sediment infilling of the overflow channel. Top width and average velocity from measurements at a given discharge for the streamgage at St. Louis, Missouri, were relatively constant through time, with the only substantial change in top width resulting from the change in measurement location from the Municipal/MacArthur Bridge to the Poplar Street Bridge in 1968. The average bed elevation appeared to be lowering with time at both measurement locations at St. Louis. Flow in the Horse Island Chute overflow channel for the streamgage at Chester, Illinois had an effect on top width and average velocity from measurements, and this effect changed with time as the inflow channel to Horse Island Chute filled with sediment. Top width from measurements at a given discharge was consistent through time at the Chester streamgage when adjusted to remove the part of the flow through Horse Island Chute. Average velocity from measurements at a given discharge appears to be increasing with time, possibly as a result of a series of dikes built or extended in the channel immediately upstream from the Chester streamgage; however, the average bed elevation for all discharges less than bankfull at the Chester streamgage fluctuate around an average value from 1948 to 2000, and the fluctuations appear to be related to the occurrence of moderate and large floods. Daily stage and discharge values available for the streamgage at St. Louis, Missouri, from 1861 to 1932 display distinct, fixed relations that change slightly with time before operation by the U.S. Geological Survey, indicating daily discharge was obtained from the daily stage value during this timeframe. A sudden and substantial reduction of about 24 percent at the upper end of the ratings for discharge at a given stage occurred between 1932 and 1933 when the U.S. Geological Survey began operating the streamgage. This change likely is the result of the change to Price AA current meters from other, less-accurate methods used for discharge measurements before 1933. Based on modeling results for the Middle Mississippi River by the U.S. Army Corps of Engineers and the findings of this study, the accuracy of the historic record before 1933 is questionable, and needs to be examined further. The differ

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 36.5° to 39° latitude; -90.5° to -88.75° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Richard J. Huizinga. 2009. Examination of Direct Discharge Measurement Data and Historic Daily Data for Selected Gages on the Middle Mississippi River, 1861-2008. https://doi.org/10.3133/sir20095232

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Karst hydrologic processes in carbonate fensters of the western Great Smoky Mountains, Tennessee, 2017–18

The geology of the Great Smoky Mountains in Tennessee and North Carolina is dominated by metamorphic strata. Along the western extent of the range, however, several carbonate fensters expose the Ordovician Jonesboro Limestone along the western edge of the Great Smoky Fault. The fensters (Cades Cove, Tuckaleechee Cove, and Wear Cove) create opportunities for allogenic recharge at the contact between the surrounding, relatively insoluble, strata and the underlying soluble formations, resulting in the development of karst systems. Karst environments have a high degree of connectivity between surface streams and groundwater systems; thus, karst aquifers are inherently vulnerable to contamination from surface activities. Karst environments also provide a specific environment for sensitive biota. Protection of the unique resources of karst environments requires an understanding of the behavior of karst aquifers, knowledge of karst recharge areas, and the mapping of groundwater flow paths. A study began in 2017 to characterize the hydrologic behavior of the karst systems in Great Smoky Mountains National Park through hydrologic monitoring, dye tracing, and seepage investigations. Hydrologic monitoring equipment was installed at several karst hydrogeologic features: two in-cave sites, two major springs, Abrams Creek in Cades Cove, and a karst depression wetland. Dye tracing was conducted to determine resurgences for the cave systems, to delineate spring recharge areas, and to estimate karst groundwater velocities. Seepage investigations along Abrams Creek helped determine if streams were sinking into the Jonesboro Limestone, either at the contact with insoluble strata or as streams flowed across the carbonate fenster. Study results indicate considerable differences in groundwater behavior between the conduit-dominated flow systems in Tuckaleechee Cove compared to the lower-gradient, colluvium-covered karst systems in Cades Cove. Study results also indicate that contaminants in the area of Bull sink and Whiteoak Sink could be rapidly transported through karst groundwater towards springs in Tuckaleechee Cove. Karst resources in Cades Cove are most likely to be affected by local events or activities taking place within the cove itself or in upper Abrams Creek upstream of the Great Smoky Fault. This study provides information on the vulnerability and uniqueness of the karst systems in the western Great Smoky Mountains, which are characterized by complex geology, high-gradient subterranean streams, deep caves, and carbonate fensters.

Tennessee↗

Analysis of groundwater geochemistry in the Lansing, Michigan, area

Groundwater resources in the Lansing, Michigan, area are protected by a wellhead protection plan, but previous studies have indicated that groundwater in this area may be susceptible to surface contamination. The U.S. Geological Survey, in cooperation with the Lansing Board of Water & Light, analyzed geochemical and aquifer characteristics to assess the potential for contamination of groundwater resources. Recharge age categories were determined from tritium concentrations for some wells, and by using ternary diagrams and principal component analysis for other wells. These age classifications, combined with hydrogeologic and geochemical data, were analyzed by using statistical methods to identify trends that may indicate areas of increased groundwater susceptibility. Wells with modern recharge tended to have higher sodium, chloride, and chloride:bromide ratios than did wells with mixed recharge, suggesting greater surface connectivity and potential influence from anthropogenic sources such as road salt. In contrast, wells in the mixed age category exhibited more stable geochemistry and lower constituent concentrations. Classification and regression tree models identified aquifer geometry—particularly the thickness of the uppermost bedrock unit and presence of confining layers—as key predictors of recharge age and geochemical indicators. The trends identified from these analyses could help to reveal locations in the Lansing area that are among the most susceptible to contamination.

Michigan↗

Evaluating the number of realizations (train-test splits) necessary to ensure robust estimates of conventional hydrothermal resource favorability using Monte Carlo cross-validation, the Great Basin, Western USA

Supervised machine learning approaches used to produce favorability maps in resource assessments commonly partition an input dataset into training and testing subsets (that is, through train-test splits). However, if a single split is not representative of underlying resource conditions, the resulting favorability map may be biased, particularly with sparse or heterogeneous datasets. To mitigate the potential for unrepresentative favorability maps, recent works by U.S. Geological Survey researchers have used Monte Carlo cross-validation to implement a large number ( n) of randomized train-test splits to produce n realizations. The realizations are then aggregated using cell-wise median predictions to produce the resulting final favorability map, recognizing that the median will remove extreme values that might have been estimated from a comparatively few unrepresentative realizations. Theoretically, the median prediction at every cell converges to a single estimate as n approaches infinity, and the question addressed herein is: How many realizations are necessary to get a robust estimate (that is, an estimate unaffected by additional realizations)? Therefore, convergence metrics are described to identify the number of train-test splits and realizations needed to make a reliable map using the data and supervised machine learning workflow for conventional hydrothermal resource assessment of the Great Basin of the Western United States. For this study, robust prediction occurs with n approximately equal to 600 realizations, and smaller ensembles (for example, n is approximately equal to 200 or even 100) may be suitable during preliminary or exploratory analyses. Although the resulting threshold numbers will vary depending on the data and modeling approach used, the convergence metrics proposed and applied herein are applicable to other supervised machine learning studies that use Monte Carlo cross-validation.

California, Idaho, Nevada, Oregon, Utah↗