USGS Science⌕ Search
Home/Archive/USGS

USGS · sir20055063

Variability of differences between two approaches for determining ground-water discharge and pumpage, including effects of time trends, Lower Arkansas River Basin, southeastern Colorado, 1998-2002

Brent M. Troutman·Patrick Edelmann·Russell G. Dash
View original source ↗Export metadata ↓

Abstract

In the mid-1990s, the Colorado Division of Water Resources (CDWR) adopted rules governing measurement of tributary ground-water pumpage for the Arkansas River Basin. The rules allowed ground-water pumpage to be determined using one of two approaches?power conversion coefficient (PCC) or totalizing flowmeters (TFM). In addition, the rules allowed a PCC to be applied to the electrical power usage up to 4 years in the future to estimate ground-water pumpage. As a result of concerns about potential errors in applying the PCC approach forward in time, a study was done by the U.S. Geological Survey, in cooperation with CDWR and Colorado Water Conservation Board, to evaluate the variability in differences in pumpage between the two approaches, including the effects of time trends. This report compared measured ground-water pumpage using TFMs to computed ground-water pumpage using PCCs by developing statistical models of relations between explanatory variables, such as site, time, and pumping water level, and dependent variables, which are based on discharge, PCC, and pumpage. When differences in pumpage (diffP) were computed using PCC measurements and power consumption for the same year (1998-2002), the median diffP, depending on the year, ranged from +0.1 to -2.9 percent; the median diffP for the entire period was -1.5 percent. However, when diffP was computed using PCC measurements applied to the next year's power consumption, the median diffP was -0.3 percent; and when PCC measurements were applied 2, 3, or 4 years into the future, median diffPs were +1.8 percent for a 2-year forward lag and +5.3 percent for a 4-year forward lag, indicating that pumpage computed with the PCC approach, as generally applied under the ground-water pumpage measurement rules by CDWR, tended to overestimate pumpage as compared to pumpage using TFMs when PCC measurement was applied to future years of measured power consumption. Analyses were done to better understand the causes of the time trend; an estimate of the overall trend with time (uncorrected for pumping water-level changes) yielded a trend of about 2.2 percent per lag year for diffP. A separate analysis that incorporated a surface-water diversion term in the statistical model rendered the time-trend term insignificant, indicating that the time trend in the models served as a surrogate for other variables, some of which reflect underlying hydrologic conditions. A more precise explanation of the potential causes of the time trend was not obtained with the available data. However, the model results with the surface-water diversion term indicate that much of the trend of 2.2 percent per lag year in diffP resulted from applying a PCC to estimate pumpage under hydrologic conditions different from those under which the PCC was measured. Although there is no evidence to conclude that the upward time trend determined in the data for this 5-year period would hold in the future, historical static ground-water levels in the study area generally have exhibited small variations over multidecadal time scales. Therefore, the approximately 2 percent per lag year trend determined in these data is expected to be a reasonable guideline for estimating potential errors in the PCC approach resulting from temporally varying hydrologic conditions between time of PCC measurement and pumpage estimation. Comparisons also were made between total, or aggregated, pumpage for a network of wells as computed by the PCC approach and the TFM approach. For 100 wells and a lag of 4 years between PCC measurement and pumpage estimation, there was a 95-percent probability that the difference between total network pumpage measured by the PCC approach and that measured using a TFM would be between 5.2 and 14.4 percent. These estimates were based on a bias of 2.2 percent per lag year estimated for the period 1998-2002 during which hydrologic conditions were known to have changed. Using the same assumptions, the estimated d

Explore related subjects

Scientific Investigations ReportReport

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Brent M. Troutman, Patrick Edelmann, Russell G. Dash. 2005. Variability of differences between two approaches for determining ground-water discharge and pumpage, including effects of time trends, Lower Arkansas River Basin, southeastern Colorado, 1998-2002. https://doi.org/10.3133/sir20055063

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Evaluating the number of realizations (train-test splits) necessary to ensure robust estimates of conventional hydrothermal resource favorability using Monte Carlo cross-validation, the Great Basin, Western USA

Supervised machine learning approaches used to produce favorability maps in resource assessments commonly partition an input dataset into training and testing subsets (that is, through train-test splits). However, if a single split is not representative of underlying resource conditions, the resulting favorability map may be biased, particularly with sparse or heterogeneous datasets. To mitigate the potential for unrepresentative favorability maps, recent works by U.S. Geological Survey researchers have used Monte Carlo cross-validation to implement a large number ( n) of randomized train-test splits to produce n realizations. The realizations are then aggregated using cell-wise median predictions to produce the resulting final favorability map, recognizing that the median will remove extreme values that might have been estimated from a comparatively few unrepresentative realizations. Theoretically, the median prediction at every cell converges to a single estimate as n approaches infinity, and the question addressed herein is: How many realizations are necessary to get a robust estimate (that is, an estimate unaffected by additional realizations)? Therefore, convergence metrics are described to identify the number of train-test splits and realizations needed to make a reliable map using the data and supervised machine learning workflow for conventional hydrothermal resource assessment of the Great Basin of the Western United States. For this study, robust prediction occurs with n approximately equal to 600 realizations, and smaller ensembles (for example, n is approximately equal to 200 or even 100) may be suitable during preliminary or exploratory analyses. Although the resulting threshold numbers will vary depending on the data and modeling approach used, the convergence metrics proposed and applied herein are applicable to other supervised machine learning studies that use Monte Carlo cross-validation.

Scientific Investigations Report↗
USGS2026

Groundwater budget for the Portneuf River Basin, southeastern Idaho

The U.S. Geological Survey, in cooperation with the Idaho Department of Water Resources, developed the first groundwater budget for the upper Portneuf River Basin in southeastern Idaho, a tributary of the Snake River. A groundwater budget for the Portneuf River Basin supports water resource and administrative management decisions within the basin and for downstream users of the eastern Snake River Plain aquifer. The analysis quantifies inflows, outflows, and residuals for an aquifer system defined by the Idaho Department of Water Resources under three recent precipitation conditions: an average year (2016), a dry year (2021), and a wet year (2023). The budget was calculated for the basin and for two subbasins delineated by the U.S. Geological Survey streamgage Portneuf River at Topaz, Idaho (13073000): the above Topaz subbasin, which includes the Portneuf-Gem valley, and the below Topaz subbasin, which includes Marsh Valley. Aquifer inflows include mountain-front recharge; areal recharge; recharge from applied water, including recharge from irrigation, canal seepage, and effluent returns; groundwater flow into the basin; and reservoir seepage. Outflows include groundwater pumping for agricultural, municipal, and domestic uses; subsurface outflow through the Portneuf gap; and discharge to streams as base flow. Estimated annual inflows for the full basin ranged from 116,880 acre-feet in 2021 to 154,880 acre-feet in 2023, and outflows ranged from 132,190 acre-feet in 2016 to 158,490 acre-feet in 2023. Basinwide residuals, the change in storage plus uncertainty, were −2,410 acre-feet in 2016, −18,410 acre-feet in 2021, and −3,610 acre-feet in 2023, and each subbasin had a mixture of negative and positive residuals. These basinwide results, interpreted as change in storage plus water-budget uncertainty, indicate minor net losses that increase with dry conditions, consistent with well depth-to-water measurements indicating gradual multi-decadal declines. Patterns in subbasin residuals are driven by irrigation practices and surface-water management; for example, the above Topaz subbasin relies more on groundwater for irrigation, resulting in more negative residuals during dry years. In contrast, the below Topaz subbasin depends more on surface water, producing positive residuals during dry years because of irrigation losses and canal seepage. The analyses for both subbasins indicate decades-long groundwater declines, which agree with the overall negative residuals calculated. The largest sources of uncertainty include climate inputs (precipitation and evapotranspiration) and poorly constrained components such as groundwater inflow and tributary stream infiltration. These findings provide insight into how climatic variables and irrigation practices affect groundwater inflows and outflows within the Portneuf River Basin.

Idaho↗
USGS2026

World minerals outlook—Antimony, copper, graphite, niobium, potash, silicon, silver, and tungsten through 2030

Demand for mineral commodities continues to increase owing to rapid technological advancements and global economic growth. To support this increase in demand, information about current and near-term supplies of these mineral commodities is essential. Such data help evaluate the health and stability of global supply chains and protect against potential supply risks. Current production and production capacity data coupled with information regarding near-term expected changes (such as facility closures, planned expansions, or the completion of new mineral production projects) can provide insight into expected future market developments and expected available supply of mineral commodities. This report within the “World Minerals Outlook” series analyzes data for antimony, copper, natural graphite, niobium, potash, silicon metal, silver, and tungsten—eight mineral commodities listed in the 2025 List of Critical Minerals. World production data from 2019 through 2025, as well as estimated world capacity data from 2023 through 2025 were analyzed. Using these data, near-term (2026–2030) expected world capacities were estimated. For antimony, copper, niobium, silicon metal, silver, and tungsten, modest increases in production capacity of 4 to 10 percent were expected between 2025 and 2030, whereas capacities for natural graphite and potash were expected to increase by about 18 to 20 percent.

Scientific Investigations Report↗