USGS Science⌕ Search

USGS · sim3486

Bathymetric contour maps, surface area and capacity tables, and bathymetric change maps for selected water-supply lakes in northwestern Missouri, 2019 and 2020

Abstract

Bathymetric data were collected at 12 water-supply lakes in northwestern Missouri by the U.S. Geological Survey, in cooperation with the Missouri Department of Natural Resources and in collaboration with various local agencies, as part of a multiyear effort to establish or update the surface area and capacity tables for the surveyed lakes. Ten of the lakes were surveyed from July to September 2019, one of the original 10 was resurveyed in March 2020, and two lakes of high interest near Maryville were surveyed in June 2020. Six of the lakes had been surveyed by the U.S. Geological Survey before, and the recent surveys were compared to the earlier surveys to document the changes in the bathymetric surface and capacity of the lake and to produce a bathymetric change map. Bathymetric data were collected using a high-resolution multibeam mapping system mounted on a boat. Supplemental depth data were collected in shallow areas with an acoustic Doppler current profiler on a remote-controlled boat. At Hamilton Reservoir, a Global Navigation Satellite System survey receiver was used to collect additional bathymetric data at several points across four transects and around the perimeter of a substantial shallow area filled with aquatic vegetation upstream from a low-clearance bridge on the northern arm. Data points from the various sources were exported at a gridded data resolution appropriate to each lake. Data outside the multibeam echosounder survey extent and greater than the surveyed water-surface elevation generally were obtained from data collected using aerial light detection and ranging point cloud data, 1/9 arc-second National Elevation Dataset data based on aerial light detection and ranging data, or both. A linear enforcement technique was used to add points to the dataset in areas of sparse data (the upper ends of coves where the water was shallow or aquatic vegetation precluded data acquisition) based on surrounding multibeam and upland data values. The various point datasets were used to produce a three-dimensional triangulated irregular network surface of the lake-bottom elevations for each lake. A surface area and capacity table was produced from the three-dimensional surface showing surface area and capacity at specified lake water-surface elevations. Various quality-assurance tests were conducted to ensure quality data were collected with the multibeam, including beam angle checks and patch tests. Additional quality-assurance tests were conducted on the gridded bathymetric data from the survey, the bathymetric surface created from the gridded data, and the contours created from the bathymetric survey. If data from a previous bathymetric survey existed at a given lake, a bathymetric change map was generated from the elevation difference between the previous survey and the 2019 bathymetric survey data points. After applying any vertical elevation changes to the previous survey data to ensure a match to the 2019 survey datum, coincident points between the surveys were found, and a bathymetric change map was generated using the coincident point data. A decrease in capacity was observed at all the lakes for which a previous survey existed. The decrease in capacity at the primary spillway or intake elevation ranged from 0.8 percent at Lake Viking to 21.4 percent at Middle Fork Grand River Reservoir. The mean bathymetric change ranged from 0.33 foot at Willow Brook Lake to 1.18 feet at Middle Fork Grand River Reservoir. The computed sedimentation rate generally ranged from 0.54 to 4.19 acre-feet per year at Maysville Lake and Middle Fork Grand River Reservoir, respectively; however, Lake Viking had the largest sedimentation rate of 14.9 acre-feet per year, despite having the smallest decrease in capacity at the spillway elevation of only 0.8 percent and a mean bathymetric change of only 0.4 foot. Evidence of dredging was observed in the bathymetric surface for Lake Viking. Some changes observed in some bathymetric change maps are hypothesized to result from the difference in data collection equipment and techniques between the previous and present bathymetric surveys. Certain erosional features around the perimeter of certain lakes may be the result of wave action during low-water years.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 39.67337039176558° to 40.59727063442024° latitude; -95.03173828125° to -93.84521484375° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Richard J. Huizinga, Lindi D. Oyler, Benjamin C. Rivers. 2022-04-12. Bathymetric contour maps, surface area and capacity tables, and bathymetric change maps for selected water-supply lakes in northwestern Missouri, 2019 and 2020. https://doi.org/10.3133/sim3486

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Map depicting locations susceptible to landslide hazards triggered by prolonged intense rainfall, Utuado Municipio, Puerto Rico

Introduction Landslides commonly occur in Puerto Rico during or soon after rainstorms with prolonged intense rainfall. Rainfall-triggered landslides present significant hazards to the built environment and human safety (for example, Jibson, 1986; Larsen and Torres Sanchez, 1992; Bessette-Kirton and others, 2019a). These hazards were illustrated during September 2017 (Hughes and others, 2019) when Hurricane María triggered more than 70,000 landslides across Puerto Rico (fig. 1), causing loss of life and widespread destruction (figs. 2–4). In Utuado Municipio, about 18,000 landslides were observed after Hurricane María (Hughes and others, 2019). Most intense rainfall-triggered landslides in Puerto Rico occur in soil overlying bedrock and travel downslope from where they initiate (for example, Jibson, 1986; Bessette-Kirton and others, 2019a, 2020). Hazards to human life and infrastructure can differ substantially between where landslides initiate and where they travel. At landslide initiation locations, the ground breaks up (fails) as it moves downslope, removing support for buildings, roadways, and other structures located upon the landslides (fig. 3A, B). This ground failure often causes structures to collapse and suffer severe damage or complete destruction, rendering building occupants at extreme risk. Roadways and other vital infrastructure, such as water, power, and communication lines, are often severed. During intense rainfall events, landslide initiation and movement downslope can occur in seconds to hours. Downslope from where they initiate, landslides in Puerto Rico often move very rapidly (faster than a person can walk or run) and can impact and destroy or fill structures with mud and debris (fig. 4) as well as bury roadways (fig. 3A, C). Moving landslides present extreme hazards to human safety; some fatalities during Hurricane María resulted from mud and debris that flowed through windows and doors of a home and buried occupants. Many landslides in Puerto Rico become fast-moving liquefied masses (debris flows), which are especially common in channels where they can quickly travel kilometers downstream. Multiple debris flows may occur in a channel during a single rainstorm (some channels experienced more than 50 debris flows during Hurricane María; Bessette-Kirton and others [2020] ). This hazard map separately depicts locations and the relative likelihood of where landslides may initiate, where they may move downslope, and where channelized debris flows may travel during or soon after intense rainfall like that during Hurricane María. An estimated average of 399 millimeters of rainfall fell across Utuado during September 19–21, 2017 (Ramos-Scharrón and Arima, 2019). Lower rainfall amounts, durations, and intensities also trigger landsliding in Puerto Rico, although landslides and debris flows become more numerous as rainfall intensities, durations, and cumulative amounts increase. The map does not show potential landslide locations in the karst terrain of northern Utuado (Bawiec, 1999) because Hurricane María-induced landslides were very sparse in this region (Hughes and others, 2019; Baxstrom and others, 2021a), even though rainfall amounts were similar to those in other parts of Utuado. Based on data from Hughes and others (2019), landslides were about 10 times more likely to occur outside of the karst terrane than within it, and our preliminary analyses indicated relatively low susceptibility to rainfall-induced landslide hazards within the karst. Landslide-prone soils appear to be poorly developed on the very steep slopes present in the karst region, where weathering by dissolution appears to dominate.

Puerto Rico, Utuado Municipio↗

Map depicting locations susceptible to landslide hazards triggered by prolonged intense rainfall, Naranjito Municipio, Puerto Rico

Introduction Landslides commonly occur in Puerto Rico during or soon after rainstorms with prolonged intense rainfall. Rainfall-triggered landslides present significant hazards to the built environment and human safety (for example, Jibson, 1986; Larsen and Torres Sanchez, 1992; Bessette-Kirton and others, 2019a). These hazards were illustrated during September 2017 (Hughes and others, 2019), when Hurricane María triggered more than 70,000 landslides across Puerto Rico (fig. 1), causing loss of life and widespread destruction (figs. 2–4). In Naranjito Municipio, about 2,000 landslides were observed after Hurricane María (Hughes and others, 2019). Most intense-rainfall-triggered landslides in Puerto Rico occur in soil overlying bedrock and travel downslope from where they initiated (for example, Jibson, 1986; Bessette-Kirton and others, 2019a; 2020). Hazards to human life and infrastructure can differ substantially between where landslides initiate and where they travel. At landslide initiation locations, the ground breaks up (fails) as it moves downslope, removing support for buildings, roadways, and other structures located upon the landslides (figs. 3B, 4A, B). This ground failure often causes structures to collapse and suffer severe damage or complete destruction, rendering building occupants at extreme risk. Roadways and other vital infrastructure, such as water, power, and communication lines are often severed. During intense rainfall events, landslide initiation and movement downslope can occur in seconds to hours. Downslope from where they initiate, landslides in Puerto Rico often move, or runout, very rapidly (faster than a person can walk or run) and can impact and destroy or fill structures with mud and debris (figs. 3A, 4A, C) as well as bury roadways (fig. 4A). Moving landslides present extreme hazards to human safety; some fatalities during Hurricane María resulted from mud and debris that flowed through windows and doors of a home and buried occupants. Many landslides in Puerto Rico become fast-moving debris flows, which are especially common in channels where they can quickly travel kilometers downstream. Multiple debris flows may occur in a channel during a single rainstorm (some channels experienced more than 50 debris flows during Hurricane María; Bessette-Kirton and others, 2020). This map separately depicts locations and the relative likelihood of where landslides may initiate, where they may move downslope, and where channelized debris flows may travel during or soon after intense rainfall like that during Hurricane María. An estimated average of 529 millimeters of rainfall fell across Naranjito during September 19–21, 2017 (Ramos-Scharrón and Arima, 2019). Lower rainfall amounts, durations, and intensities also trigger landsliding in Puerto Rico, although landslides and debris flows become more numerous as rainfall intensities, durations, and cumulative amounts increase.

Naranjito Municipio, Puerto Rico↗

Map depicting locations susceptible to landslide hazards triggered by prolonged intense rainfall, Lares Municipio, Puerto Rico

Introduction Landslides commonly occur in Puerto Rico during or soon after rainstorms with prolonged intense rainfall. Rainfall-triggered landslides present significant hazards to the built environment and human safety (for example, Jibson, 1986; Larsen and Torres Sanchez, 1992; Bessette-Kirton and others, 2019a). These hazards were illustrated during September 2017 (Hughes and others, 2019), when Hurricane María triggered more than 70,000 landslides across Puerto Rico (fig. 1), causing loss of life and widespread destruction (figs. 2 and 3). In Lares Municipio, about 3,500 landslides were observed after Hurricane María (Hughes and others, 2019). Most intense-rainfall-triggered landslides in Puerto Rico occur in soil overlying bedrock and travel downslope from where they initiated (for example, Jibson, 1986; Bessette-Kirton and others, 2019a; 2020). Hazards to human life and infrastructure can differ substantially between where landslides initiate and where they travel. At landslide initiation locations, the ground breaks up (fails) as it moves downslope, removing support for buildings, roadways, and other structures located upon the landslides (figs. 2, 3A, B). This ground failure often causes structures to collapse and suffer severe damage or complete destruction, rendering building occupants at extreme risk. Roadways and other vital infrastructure, such as water, power, and communication lines are often severed. During intense rainfall events, landslide initiation and movement downslope can occur in seconds to hours. Downslope from where they initiate, landslides in Puerto Rico often move, or runout, very rapidly (faster than a person can walk or run) and can impact and destroy or fill structures with mud and debris (figs. 3A, C) as well as bury roadways (fig. 3A). Moving landslides present extreme hazards to human safety; some fatalities during Hurricane María resulted from mud and debris that flowed through windows and doors of a home and buried occupants. Many landslides in Puerto Rico become fast-moving debris flows, which are especially common in channels where they can quickly travel kilometers downstream. Multiple debris flows may occur in a channel during a single rainstorm (some channels experienced more than 50 debris flows during Hurricane María; Bessette-Kirton and others, 2020). This map separately depicts locations and the relative likelihood of where landslides may initiate, where they may move downslope, and where channelized debris flows may travel during or soon after intense rainfall like that during Hurricane María. An estimated average of 256 millimeters of rainfall fell across Lares during September 19–21, 2017 (Ramos-Scharrón and Arima, 2019). Lower rainfall amounts, durations, and intensities also trigger landsliding in Puerto Rico, although landslides and debris flows become more numerous as rainfall intensities, durations, and cumulative amounts increase. The map does not show potential landslide locations in the karst terrain of northern Lares (Bawiec, 1999) because Hurricane María-induced landslides were very sparse in this region (Hughes and others, 2019; Baxstrom and others, 2021a), even though rainfall amounts were similar to those in other parts of Lares. Based on data from Hughes and others (2019), landslides were about ten times more likely to occur outside of the karst terrane than within it, and our preliminary analyses indicate relatively low susceptibility to rainfall-induced landslide hazards within the karst. Landslide-prone soils appear to be poorly developed on the very steep slopes present in the karst region, where weathering by dissolution appears to dominate.

Lares Municipio, Puerto Rico↗