Flood-inundation maps for the Flatrock River at Columbus, Indiana, 2012

William F. Coon

doi:10.3133/sim3241

Home/Archive/USGS

USGS · sim3241

Flood-inundation maps for the Flatrock River at Columbus, Indiana, 2012

William F. Coon

View original source ↗Read source document ↗Export metadata ↓

Abstract

Digital flood-inundation maps for a 5-mile reach of the Flatrock River on the western side of Columbus, Indiana, from County Road 400N to the river mouth at the confluence with Driftwood River, were created by the U.S. Geological Survey (USGS) in cooperation with the Indiana Department of Transportation. The inundation maps, which can be accessed through the USGS Flood Inundation Mapping Science Web site at http://water.usgs.gov/osw/flood_inundation/ and the Federal Flood Inundation Mapper Web site at http://wim.usgs.gov/FIMI/FloodInundationMapper.html, depict estimates of the areal extent and depth of flooding corresponding to selected water levels (stages) at the USGS streamgage on the Flatrock River at Columbus (station number 03363900). Near-real-time stages at this streamgage may be obtained on the Internet from the USGS National Water Information System at http://waterdata.usgs.gov/ or the National Weather Service (NWS) Advanced Hydrologic Prediction Service, which also presents the USGS data, at http:/water.weather.gov/ahps/. Flood profiles were computed for the stream reach by means of a one-dimensional step-backwater model. The model was calibrated by using the most current stage-discharge relation at the Flatrock River streamgage, high-water marks that were surveyed following the flood of June 7, 2008, and water-surface profiles from the current flood-insurance study for the City of Columbus. The hydraulic model was then used to compute 12 water-surface profiles for flood stages at 1-foot (ft) intervals referenced to the streamgage datum and ranging from 9 ft or near bankfull to 20 ft, which exceeds the stages that correspond to both the estimated 0.2-percent annual exceedance probability flood (500-year recurrence interval flood) and the maximum recorded peak flow. The simulated water-surface profiles were then combined with a Geographic Information System digital elevation model (derived from Light Detection and Ranging (LiDAR) data having a 0.37 ft vertical accuracy and 3.9 ft horizontal resolution) to delineate the area flooded at each water level. The availability of these maps on the USGS Federal Flood Inundation Mapper Web site, along with Internet information regarding current stage from the USGS streamgage, will provide emergency management personnel and residents with information that is critical for flood response activities, such as evacuations and road closures, as well as for post-flood recovery efforts.

Explore related subjects

Scientific Investigations Map Report

Source-reported bounding extent: 39.1206° to 39.2745° latitude; -86.006° to -85.793° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

William F. Coon. 2013. Flood-inundation maps for the Flatrock River at Columbus, Indiana, 2012. https://doi.org/10.3133/sim3241

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Altitude of the potentiometric surface and depth to water in the Mississippi River Valley alluvial aquifer, spring 2024

Potentiometric-surface and depth-to-water maps for spring 2024 were created for the Mississippi River Valley alluvial aquifer using groundwater-altitude data from 1,151 wells completed in the Mississippi River Valley alluvial aquifer and from the altitude of the top of the water surface in area rivers from 160 U.S. Geological Survey and U.S. Army Corps of Engineers streamgages. The potentiometric-surface and depth-to-water maps for 2024 were created to support investigations to characterize the Mississippi River Valley alluvial aquifer as part of the U.S. Geological Survey Water Availability and Use Science Program. Sufficient data were available to map the potentiometric surface and depth to water of the Mississippi River Valley alluvial aquifer for spring 2024 for about 83 percent of the aquifer area. The potentiometric contours ranged from 0 to 330 feet (ft) above the North American Vertical Datum of 1988. The regional direction of the groundwater gradient was generally to the south-southwest, except in areas of groundwater-altitude depressions, where the groundwater gradient direction was into the depression, and near rivers, where the groundwater gradient direction was either from the aquifer to the river or from the river into the aquifer. Groundwater depressions in the potentiometric-surface map are in the lower one-half of the Cache region and in most of the Grand Prairie and Delta regions. Depth to water by well in the Mississippi River Valley alluvial aquifer in spring 2024 ranged from 0.27 ft above land surface to 145.65 ft below land surface.

Arkansas, Illinois, Kentucky, Louisiana, Mississip↗

USGS2026

Color-Shaded Relief Bathymetry of Lake Chelan, Washington

In 2023, the U.S. Geological Survey (USGS) completed a 3-week field operation in Lake Chelan, Washington, the third deepest lake in the conterminous United States, to acquire sediment cores, high-resolution bathymetry data, and chirp sub-bottom profiles. The high-resolution bathymetry displayed in this map publication was collected using a Norbit Winghead i67-curved array multibeam system; raw data were cleaned and gridded (3 by 3 meters [m]) in the Teledyne CARIS software. In some locations where the slopes of Lake Chelan are near-vertical, multibeam returns were sparse, resulting in artifacts resembling holes that appear as grey dots within the color-shaded bathymetric relief. Although the 2023 bathymetric mapping of Lake Chelan resulted in similar morphometric characteristics to previous hydrographic campaigns (table 1; Kendra and Singleton, 1987; Pelletier and others, 1989), these new data provide a much more detailed understanding of the two physiographic basins that comprise Lake Chelan: the deeper (as deep as 445.8 m [fig. 1]; previously reported as 453 m) and narrower (1–2 kilometers [km] wide) Lucerne Basin to the north, and the shallower (as deep as 127.8 m [fig. 1]), and wider (2–3 km wide) Wapato Basin to the south. With this detailed imaging of Lake Chelan, we find pervasive morphological evidence of slope failure and mass-transport deposits (MTDs) in at least 89 locations within the lake and 63 subaqueous deltas (fig. 2). The deeper Lucerne Basin is dominated by steep slopes and numerous subaqueous deltas fed by steep fluvial catchments, whereas the Wapato Basin contains numerous landslide scarps, scars, and debris aprons along the more gently sloping lake margins, and abundant relict kettle structures from the Pleistocene deglaciation. Lake Chelan’s geomorphic, geophysical, and sediment data contain important records of glacial retreat and advance, regional volcanic eruptions, and earthquakes that generate ground motions severe enough to induce landslides recorded in the sediment as MTDs. The epicenter of the 1872 Washington State Earthquake (M 6.5–7.2; Bakun and others, 2002; Brocher and others, 2017; Sherrod and others, 2021) is along the Spencer Canyon Fault, near the southern end of Lake Chelan. Shaking from this earthquake was strong enough to affect local aquifers, induce liquefaction of unconsolidated sediments, produce large seiches (Brocher and others, 2018), and likely cause landslides within Lake Chelan.

Washington↗

USGS2026

Spectral characteristics and mapping of lithium-rich playas in the Basin and Range Province, western United States

This report presents a comprehensive set of prospectivity maps for lithium in brines located within the playas of the Basin and Range Province of western United States. The prospectivity assessment is based on criteria established in the descriptive deposit model outlined in a previous U.S. Geological Survey report, with a focus on regional remote sensing methodologies. The playas within the study area have been systematically ranked according to several key factors, including size, the presence and abundance of source rocks, vegetation as an indicator of water availability, documented prospects, and data products derived from the Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) sensor. Notably, the deposits in the playa of Clayton Valley make it stand out as the sole lithium brine-producing playa in the United States. The ASTER sensor provides optimal regional coverage, characterized by a 60-kilometer swath width and unique multispectral capabilities that are not available with other remote sensing instruments. This report and the accompanying maps are intended to serve as resources for further multidisciplinary assessments of lithium or other elements or commodities where prospectivity can be inferred from the presence of proxies such as alteration minerals.

Arizona, Baja California, California, Chihuahua, I↗