USGS Science⌕ Search

USGS · ofr8728

Ground water-surface water relations in the Flathead River valley near the proposed Cabin Creek coal mine, British Columbia, Canada

Abstract

The area of the proposed Cabin Creek coal mine was studied to obtain information needed to respond to questions posed by the International Joint Commission advisers concerning water resources near the international border. Specific interest focused on determining the extent and character of surficial material in the Flathead River valley, identifying gaining and losing reaches of the river and major tributaries, and documenting ambient water quality at selected sites. Thickness of the alluvial deposits depends on depth to underlaying Quaternary glacial deposits or Tertiary bedrock. The alluvial deposits in the Flathead River valley thin to a veneer of cobbles near the mouth of Couldrey Creek. Measurements of streamflow at 20 sites in the Flathead River valley indicate that water discharges from the alluvial deposits to most of the tributaries and to the river near the proposed mine. The Flathead River gains 0.87 cu m/sec (31 cu ft/sec) of flow near Howell Creek. The Flathead River and Couldrey Creek gained about 0.81 cu m/sec (28.5 cu ft/sec) of flow near the mouth of Couldrey Creek where bedrock crops out in the streambeds. Bedrock outcrops effectively interrupt the alluvial aquifer system between the proposed mine site and the international border. The Flathead River lost 0.87 cu m/sec (31 cu ft/sec) of flow between the bedrock outcrops and the international border; this streamflow loss enters alluvial deposits and flows across the international border as subsurface flow. Analysis of samples from 18 stream sites and 1 spring site indicates general trends in water quality. In Howell Creek, concentrations of calcium, magnesium, and sulfates increased slightly downstream. Conversely, samples from Sage and Couldrey Creeks indicate downstream increases in concentrations of calcium, magnesium, and alkalinity, but decreases in concentrations of sulfate. Water quality of Cabin Creek was relatively stable through the sampled reach. Decreased concentrations of calcium and alkalinity in the Flathead River reflect the effect of inflow from Couldrey Creek and the groundwater inflow documented by streamflow measurements. (Author 's abstract)

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

J. A. Moreland, Hugh Liebscher, W. A. Van Voast, R.D. Feltis. 1987. Ground water-surface water relations in the Flathead River valley near the proposed Cabin Creek coal mine, British Columbia, Canada. https://doi.org/10.3133/ofr8728

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Floods of June 20–July 6, 2024, in the Big Sioux River, Rock River, Little Sioux River, Ocheyedan River, and Floyd River Basins, northwestern Iowa

Major flooding occurred on June 20–July 6, 2024, in northwestern Iowa affecting the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd River Basins. Heavy rain fell in northwestern Iowa, southwestern Minnesota, and southeastern South Dakota on June 20–22, 2024. Parts of northwestern Iowa recorded 2–6 inches of rainfall and localized amounts exceeding 12 inches. A maximum peak-of-record streamflow of 175,000 cubic feet per second at the U.S. Geological Survey streamgage Big Sioux River at Akron, Iowa (06485500), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at four locations along the Big Sioux River between U.S. Interstate 29 at Sioux City, Iowa, upstream to Iowa Highway 10 north of Hawarden, Iowa, a distance of 75.7 river miles. A maximum peak-of-record streamflow of 157,000 cubic feet per second at the U.S. Geological Survey streamgage Rock River near Rock Valley, Iowa (06483500), was recorded on June 22, 2024, and had an annual exceedance probability of less than 0.2 percent. High-water marks were measured at eight locations along the Rock River between County Road B30 east of Hudson, South Dakota, upstream to Iowa Highway 9 at Rock Rapids, Iowa, a distance of 39.3 river miles. A maximum peak-of-record streamflow of 63,000 cubic feet per second at the U.S. Geological Survey streamgage Little Sioux River at Correctionville, Iowa (06606600), was recorded on June 24, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at 11 locations along the Little Sioux River between Iowa Highway 31 west of Correctionville, Iowa, upstream to U.S. Highway 18 north of Spencer, Iowa, a distance of 134.8 river miles. A maximum streamflow of 24,500 cubic feet per second at the U.S. Geological Survey streamgage Ocheyedan River near Spencer, Iowa (06605000), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at three locations along the Ocheyedan River between County Road M38 west of Spencer, Iowa, upstream to U.S. Highway 18 west of Everly, Iowa, a distance of 12.8 river miles. A maximum streamflow of 41,000 cubic feet per second at the U.S. Geological Survey streamgage Floyd River at Alton, Iowa (06600100), was recorded on June 22, 2024, and had an annual exceedance probability range of 1–1.99 percent. High-water marks were measured at six locations along the Floyd River between Iowa Highway 3 at Le Mars, Iowa, upstream to Iowa Highway 10 at Alton, Iowa, a distance of 27.5 river miles. The high-water marks were used to develop flood profiles for the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd Rivers.

Iowa, Minnesota, South Dakota↗

Special Contributing Area Loading Program user’s manual

Information on the Special Contributing Area Loading Program execution and functions are presented in this user’s manual. An appendix presents a potential improvement for the user to consider. The hydrologic routing simulation method to model flow through multiple reservoirs, or sewer system components, is described. The use of Special Contributing Areas is described to run a successful simulation, which includes user input of hydrologic time series of flow components and the necessary formats. Upon completion of a successful Special Contributing Area Loading Program simulation, the program outputs hydrologic time series and a descriptive text file containing the model results for each defined sub-unit, or Special Contributing Area. The output time series contain flows through, and overflows from, the three reservoirs in the series, and the text file contains input and output path locations.

Open-File Report↗

Estimating aftershock risk for entry into earthquake-damaged buildings

We present a simple method to estimate the risk of experiencing strong shaking from aftershocks during entry into earthquake-damaged buildings. We compute wait times until the probability of strong ground shaking from aftershocks reaches a predefined risk threshold; for example, a 0.4 percent probability of experiencing Modified Mercalli Intensity 7 or greater shaking during the planned building entry. We also develop a relation between aftershock probability and the probability of strong shaking, so that users can reference the U.S. Geological Survey aftershock forecast during an ongoing aftershock sequence to determine if the risk threshold has been met. We apply our method to active continental regions (for example, the Western United States), stable continental regions (for example, the Central and Eastern United States), and subduction zones (for example, Cascadia or Alaska).

Open-File Report↗