A catalogue of drill core recovered from Kilauea Iki lava lake, from 1967 to 1979

Abstract

The purpose of this report is to serve as a descriptive catalogue for drill core recovered from Kilauea Iki lava lake, from 1967 to 1979. Kilauea Iki lava lake was formed when lavas of the 1959 summit eruption were ponded in Kilauea Iki pit crater, a large pit crater at the extreme upper end of Kilauea's east rift zone (Fig. 1). This eruption is one of the best documented of Kilauean eruptions: Murata and Richter (1966) and Richter and Murata (1966) presented data on the chemistry and petrography of the lavas, respectively, and Richter et al. (1970) described the complex filling of the pit crater in considerable detail. Investigation of the lava lake began a few months after the crust stabilized, with the establishment of two perpendicular lines of levelling stations on the surface of the lake. In 1960-62, four holes were drilled through the upper crust in the center of the lake; the crust was 22-44 feet (6.7-13.4 m) thick at that time. Richter and Moore (1966) presented petrographic, modal, and chemical data on the core recovered from this early drilling. The upper crust of Kilauea Iki was drilled again in 1967 by staff members of the Hawaiian Volcano Observatory, and core was recovered from three holes. In 1975, U.S. Geological Survey workers drilled three more holes, each a few feet away from one of the 1 967 holes. A summary of all work done on Kilauea Iki and other Hawaiian lava lakes through 1975 has been given by Wright et al. (1976). The lake has been redrilled twice since 1975, by workers from Sandia Laboratories, as part of their Magma Energy Research program, in cooperation with the U.S. Geological Survey. In 1976, they drilled two holes near the center of the lake. In 1978-79, they drilled a total of six holes; one, commissioned by the U.S. Geological Survey, went completely through the lava lake near its north edge, into the pre-1959 lavas below.