USGS Science⌕ Search

USGS · ofr6345

Preliminary interpretation of an aeromagnetic survey in north-central Iowa

Abstract

Publication of Lyons' gravity map of the United States in 1950 focused attention on a spectacular geophysical feature now generally referred to as the "midcontinent gravity high." This feature, the largest gravity maximum in North America, was discovered and later detailed by geophysicists at the University of Wisconsin (Woollard, 1943, 1951) and Thiel (1956). Their work reveals an essentially continuous large positive gravity anomaly extending southwestward for 800 miles from Lake Superior to the Salina Basin in Kansas. The midcontinent gravity high reaches its maximum intensity in central Iowa where the Bouguer anomaly ranges from -100 to 60 milligals. In September-October 1961, the U. S. Geological Survey made a 5,000 square mile aeromagnetic survey in north-central Iowa in cooperation with the Iowa Geological Survey. Objectives of the investigation were to prepare and interpret a detailed aeromagnetic contour map for part of the midcontinent gravity high in Iowa. Analysis of the magnetic data could be expected to yield estimates of local thickness of the Paleozoic-Mesozoic sedimentary section and provide a basis for informed speculation about the character, configuration, and distribution of the Precambrian rocks. Such information would have obvious scientific and possible economic value in an area covered by glacial till and for which little deep subsurface knowledge was available. Interpretation of the Indiana aeromagnetic survey (Henderson and Zietz, 1958) had previously demonstrated that aeromagnetic data from the central stable region of North America would provide a significant amount of geologic information. The 5,000 square mile area surveyed in 1961 has been combined with a previously unpublished 600 square mile aeromagnetic survey made in 1953, centered on Manson, Pocahontas Co., Iowa. The combined area is shown as the patterned area in figure 1. The unpatterned area outlined on this same figure is the additional 10,000 square mile cooperative aeromagnetic survey made in the summer of 1962 to complete coverage of the midcontinent gravity high in Iowa. The primary purpose of this report is to make the 1953 and 1961 aeromagnetic data available to the public in advance of more formal publication. Only salient magnetic features are discussed in this preliminary presentation and in a second report on results obtained during the 1962 flying. A more complete interpretation of the entire aeromagnetic survey will be prepared.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 42.333° to 43.5° latitude; -95° to -92.5° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

John Richard Henderson, Walter S. White, Isidore Zietz. 1963. Preliminary interpretation of an aeromagnetic survey in north-central Iowa. https://doi.org/10.3133/ofr6345

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Floods of June 20–July 6, 2024, in the Big Sioux River, Rock River, Little Sioux River, Ocheyedan River, and Floyd River Basins, northwestern Iowa

Major flooding occurred on June 20–July 6, 2024, in northwestern Iowa affecting the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd River Basins. Heavy rain fell in northwestern Iowa, southwestern Minnesota, and southeastern South Dakota on June 20–22, 2024. Parts of northwestern Iowa recorded 2–6 inches of rainfall and localized amounts exceeding 12 inches. A maximum peak-of-record streamflow of 175,000 cubic feet per second at the U.S. Geological Survey streamgage Big Sioux River at Akron, Iowa (06485500), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at four locations along the Big Sioux River between U.S. Interstate 29 at Sioux City, Iowa, upstream to Iowa Highway 10 north of Hawarden, Iowa, a distance of 75.7 river miles. A maximum peak-of-record streamflow of 157,000 cubic feet per second at the U.S. Geological Survey streamgage Rock River near Rock Valley, Iowa (06483500), was recorded on June 22, 2024, and had an annual exceedance probability of less than 0.2 percent. High-water marks were measured at eight locations along the Rock River between County Road B30 east of Hudson, South Dakota, upstream to Iowa Highway 9 at Rock Rapids, Iowa, a distance of 39.3 river miles. A maximum peak-of-record streamflow of 63,000 cubic feet per second at the U.S. Geological Survey streamgage Little Sioux River at Correctionville, Iowa (06606600), was recorded on June 24, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at 11 locations along the Little Sioux River between Iowa Highway 31 west of Correctionville, Iowa, upstream to U.S. Highway 18 north of Spencer, Iowa, a distance of 134.8 river miles. A maximum streamflow of 24,500 cubic feet per second at the U.S. Geological Survey streamgage Ocheyedan River near Spencer, Iowa (06605000), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at three locations along the Ocheyedan River between County Road M38 west of Spencer, Iowa, upstream to U.S. Highway 18 west of Everly, Iowa, a distance of 12.8 river miles. A maximum streamflow of 41,000 cubic feet per second at the U.S. Geological Survey streamgage Floyd River at Alton, Iowa (06600100), was recorded on June 22, 2024, and had an annual exceedance probability range of 1–1.99 percent. High-water marks were measured at six locations along the Floyd River between Iowa Highway 3 at Le Mars, Iowa, upstream to Iowa Highway 10 at Alton, Iowa, a distance of 27.5 river miles. The high-water marks were used to develop flood profiles for the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd Rivers.

Iowa, Minnesota, South Dakota↗

Special Contributing Area Loading Program user’s manual

Information on the Special Contributing Area Loading Program execution and functions are presented in this user’s manual. An appendix presents a potential improvement for the user to consider. The hydrologic routing simulation method to model flow through multiple reservoirs, or sewer system components, is described. The use of Special Contributing Areas is described to run a successful simulation, which includes user input of hydrologic time series of flow components and the necessary formats. Upon completion of a successful Special Contributing Area Loading Program simulation, the program outputs hydrologic time series and a descriptive text file containing the model results for each defined sub-unit, or Special Contributing Area. The output time series contain flows through, and overflows from, the three reservoirs in the series, and the text file contains input and output path locations.

Open-File Report↗

Estimating aftershock risk for entry into earthquake-damaged buildings

We present a simple method to estimate the risk of experiencing strong shaking from aftershocks during entry into earthquake-damaged buildings. We compute wait times until the probability of strong ground shaking from aftershocks reaches a predefined risk threshold; for example, a 0.4 percent probability of experiencing Modified Mercalli Intensity 7 or greater shaking during the planned building entry. We also develop a relation between aftershock probability and the probability of strong shaking, so that users can reference the U.S. Geological Survey aftershock forecast during an ongoing aftershock sequence to determine if the risk threshold has been met. We apply our method to active continental regions (for example, the Western United States), stable continental regions (for example, the Central and Eastern United States), and subduction zones (for example, Cascadia or Alaska).

Open-File Report↗