USGS Science⌕ Search

USGS · ofr5898

Origin of manganese deposits of Busuanga Island, Philippines

Abstract

The manganese deposits of Busuanga Island, Palawan, are tabular and broadly lenticular bodies which lie conformably within a thick sequence of deformed abort beds. The purpose of this study is to determine the probable mode of origin of the deposits. Similar deposits in other parts of the world have been described by others as products of several different genetic processes. Field and laboratory methods of research were employed in the course of the investigation. Detailed geologic mapping was done on the surface and underground, and many samples of rocks and ores were obtained. Later, intensive study of samples from four typical deposits and from the rooks in the surrounding areas was undertaken, using a variety of laboratory techniques. Microscopic study of thin sections and polished surfaces was supplemented by X-ray and chemical work. More than one hundred X-ray diffraction powder photographs were made to identify minerals, and qualitative chemical studies were made of a number of aamples by use of the X-ray spectrograph. In addition, quantitative chemical analyses were made of certain samples. Finally, published accounts of the occurrence and geological behavior of manganese and silica were consulted to aid in interpretation of the data at hand. Oherty layers in the manganese deposits are lithologically similar to the chart wallrooks and country rook beds. Radiolarian fossils are common in the chart and are also found in some ore specimens. Manganese content of the wallrocks and the country rock beds, however, in essentially nil. The manganese deposits contain mostly psilomelane-type oxides in their near-surface parts, and in the deepest mines this ore grades downward into siliceous protore. In three of the deposits studied, the protore consists mainly of braanite and quartz; in the fourth deposit, hausmannite and the silicate alleghatvite make up the milk of the protore. Some of the protoro is massive, but cherty stones are commonly well layered parallel to the wall rock structure. Grain size is very small, but, like the silica in the chert beds, becomes relatively coarse where the rocks are much deformed. No evidence of large-scale replacement or cross-cutting veins is found in the protores. It is concluded that the original manganiferous deposits were largely non-clastic or oolloidal marine sediments laid down in a reducing environment. The protorea were developed from these beds by processes of diagenesis and low-grade regional metamorphism. The protores were in turn altered to black oxide ore by near-surface agencies during the present erosion cycle. Particular interest is attached to the occurrence of alleghanyite and traces of pyroxmangite and hubnerite(?) in the protorea.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 11.95469290365025° to 12.35475861486504° latitude; 119.80178833007811° to 120.37307739257812° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Ronald Keith Sorem. 1958. Origin of manganese deposits of Busuanga Island, Philippines. https://doi.org/10.3133/ofr5898

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

ECCOE Landsat quarterly calibration and validation report—Quarter 2, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 2 (April–June), 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov.

Open-File Report↗

ECCOE Landsat quarterly calibration and validation report—Quarter 1, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 1 (January–March) of 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov . One specific activity that the ECCOE Landsat Cal/Val Team closely monitored was a Landsat 8 Thermal Infrared Sensor encoder alerts anomaly. On March 18, 2026, the Thermal Infrared Sensor instrument’s mechanism control electronics board reset, driving several parameters to default power-on values. Subsequent telemetry and analysis determined that no persistent hardware misconfiguration was present and no radiometric or geometric degradation was observed.

Open-File Report↗

Floods of June 20–July 6, 2024, in the Big Sioux River, Rock River, Little Sioux River, Ocheyedan River, and Floyd River Basins, northwestern Iowa

Major flooding occurred on June 20–July 6, 2024, in northwestern Iowa affecting the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd River Basins. Heavy rain fell in northwestern Iowa, southwestern Minnesota, and southeastern South Dakota on June 20–22, 2024. Parts of northwestern Iowa recorded 2–6 inches of rainfall and localized amounts exceeding 12 inches. A maximum peak-of-record streamflow of 175,000 cubic feet per second at the U.S. Geological Survey streamgage Big Sioux River at Akron, Iowa (06485500), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at four locations along the Big Sioux River between U.S. Interstate 29 at Sioux City, Iowa, upstream to Iowa Highway 10 north of Hawarden, Iowa, a distance of 75.7 river miles. A maximum peak-of-record streamflow of 157,000 cubic feet per second at the U.S. Geological Survey streamgage Rock River near Rock Valley, Iowa (06483500), was recorded on June 22, 2024, and had an annual exceedance probability of less than 0.2 percent. High-water marks were measured at eight locations along the Rock River between County Road B30 east of Hudson, South Dakota, upstream to Iowa Highway 9 at Rock Rapids, Iowa, a distance of 39.3 river miles. A maximum peak-of-record streamflow of 63,000 cubic feet per second at the U.S. Geological Survey streamgage Little Sioux River at Correctionville, Iowa (06606600), was recorded on June 24, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at 11 locations along the Little Sioux River between Iowa Highway 31 west of Correctionville, Iowa, upstream to U.S. Highway 18 north of Spencer, Iowa, a distance of 134.8 river miles. A maximum streamflow of 24,500 cubic feet per second at the U.S. Geological Survey streamgage Ocheyedan River near Spencer, Iowa (06605000), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at three locations along the Ocheyedan River between County Road M38 west of Spencer, Iowa, upstream to U.S. Highway 18 west of Everly, Iowa, a distance of 12.8 river miles. A maximum streamflow of 41,000 cubic feet per second at the U.S. Geological Survey streamgage Floyd River at Alton, Iowa (06600100), was recorded on June 22, 2024, and had an annual exceedance probability range of 1–1.99 percent. High-water marks were measured at six locations along the Floyd River between Iowa Highway 3 at Le Mars, Iowa, upstream to Iowa Highway 10 at Alton, Iowa, a distance of 27.5 river miles. The high-water marks were used to develop flood profiles for the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd Rivers.

Iowa, Minnesota, South Dakota↗