USGS ScienceSearch

USGS · 70270953

Favorability mapping for hydrothermal power resource assessments of the Great Basin, USA

Abstract

The U.S. Geological Survey (USGS) is updating the 2008 assessment of conventional hydrothermal resources for the Great Basin in the western United States. As part of this work, the workflow for hydrothermal resource favorability maps is being modified to integrate modern data-driven machine learning (ML) methods. Improvements include: [1] using new and refined evidence layers (features); [2] using an order of magnitude more training sites (labeled examples); [3] utilizing simple but non-linear supervised ML algorithms; [4] representing positive training sites (wells with measured heat flow) with their ordinal value proportional to the magnitude of convective upflow (i.e., low, high, or very high convective signals instead of past strategies using positive-negative labels); [5] supplementing training sites with additional sites with low convective signals to represent diverse under-sampled areas where hydrothermal systems are unlikely to exist; [6] comparing with competing approaches; and [7] utilizing Monte Carlo cross-validation to estimate and evaluate prediction uncertainty. For the new favorability map, over half of the power-producing systems (i.e., 15 of 28) are predicted in the 99th percentile of most favorable locations (i.e., the highest 1 % of favorability, corresponding to 1 % of the map area), exceeding the performance of past models that have explicitly used power plants as training sites. Previous favorability maps predicted approximately half of the power-producing hydrothermal systems above the 80th percentile (i.e., 20 % of the map area). For the new favorability map, 93 % of power-producing systems (i.e., 26 of 28) are above the 80th percentile. The power-producing systems for which the new model does not perform well are either comparatively small, low-temperature systems or systems also not predicted well by prior modeling approaches, suggesting that these few systems are unusual when compared with most power-producing systems. Focusing research on these known, seemingly different systems may yield new insights and subsequent discovery of new prospects.

Explore related subjects

Keep this discovery

BibTeXRIS

Stanley Paul Mordensky, Erick R. Burns, John Lipor, Jacob DeAngelo. 2025. Favorability mapping for hydrothermal power resource assessments of the Great Basin, USA. https://doi.org/10.1016/j.geothermics.2025.103450

Cite the original work for its findings. Save a collection to share your selection of sources.

Discover connections

Connections use source metadata and explicit phrase matches, not verified experimental comparisons.

KEEP EXPLORING

Related discoveries

Prioritizing resource protection and understanding potential susceptibility of springs to surficial changes in a low-temperature geothermal system

Geothermal systems are vulnerable to changes in water budget and composition, requiring science-based management. This study uses a dataset of spring water temperatures, time series of groundwater residence time tracers (tritium and carbon-14), and stable isotopes of water to understand geothermal flow in a low-temperature geothermal system in north west Colorado, United States (Steamboat Springs). The geothermal system is bisected by the Yampa River, necessitating a stream mass balance approach to quantify total discharge. Time series analysis of water temperature data provides a ranked list of features more susceptible to surficial changes, which is corroborated using time series of tritium which indicate spatially distinct patterns of mixing between modern and pre-modern groundwater. All springs contain a portion of pre-modern groundwater that is thousands to tens of thousands of years old, a period coinciding with melting of extensive Pleistocene glaciers that was likely one of the recharge sources to the geothermal system. Stream mass balance indicates that greater than 80% of the total geothermal discharge is derived from diffuse or small springs, highlighting the extensive nature of the geothermal outflow zone and the association with local geologic structures. This study provides baseline data to support management of the Steamboat Springs geothermal system and indicates the utility of these approaches in developing science-based geothermal management.

Colorado

Open-source gravity reduction workflows for geothermal resource assessment

Potential-field geophysical data such as gravity can enhance understanding of geothermal resources at all stages of the resource life cycle, including assessment, exploration, development, and monitoring, and at multiple scales, from the reservoir scale to regional scale. However, to make gravity data useful for geothermal resource characterization, several processing steps are required to isolate the effects of density variations in the Earth’s crust to enable the identification of structural features associated with geothermal resources. Although this process is well-established, standard computational implementations for processing gravity data that are FAIR (Findable, Accessible, Interoperable, and Reproduceable) are still lacking. This paper details ongoing efforts at the U.S. Geological Survey (USGS) to develop a standard set of open-source Python tools for gravity data reduction that align with the FAIR principles. This workflow makes use of existing open-source tools for geophysical data processing with the goal of maximizing opportunities for rapid improvements, interoperability, and adaptability to other types of geophysical data.

Conference Paper

Stepovers and beyond: Structural control of The Geysers geothermal system and the broader Clear Lake region

Fault geometry exerts a first-order control on geothermal systems by governing stress localization, fracture development, and permeability, yet in complex fault networks or broader shear zones, the relative influence of individual geometric features is often difficult to resolve. In the northern California Coast Ranges, The Geysers geothermal field is commonly interpreted to occur within a releasing stepover, although no single, clearly defined stepover is identified in published studies. To investigate the structural controls on The Geysers and the broader Clear Lake region, a two-dimensional elastic boundary element model is developed to evaluate spatial patterns of dilational strain associated with progressively more complete fault geometries. Model results show that dilation in the region is not controlled by a single structure but instead reflects the combined effects of multiple interacting fault elements. Three primary controls are identified: (1) opposing bends in the regional strike-slip fault system, including a releasing bend along the Maacama fault; (2) the southern fault tip of the Collayomi fault, which generates a prominent dilational lobe beneath the southern Geysers; and (3) a releasing stepover between the Collayomi fault and the Geyser Peak–Mercuryville–Big Sulphur Creek fault system, inferred to collectively behave as a right-lateral shear zone bounding the western margin of The Geysers. Predicted dilational strain magnitudes are sufficient to localize permeability between faults. These results highlight that incorporating complete fault networks and bedrock geological mapping can enhance geothermal assessments and provide a transferable framework for evaluating structurally controlled permeability in tectonically active regions.

California