USGS ScienceSearch

USGS · 70252668

Timing and source of recharge to the Columbia River Basalt groundwater system in northeastern Oregon

Abstract

Recharge to and flow within the Columbia River Basalt Group (CRBG) groundwater flow system of northeastern Oregon were characterized using isotopic, gas, and age-tracer samples from wells completed in basalt, springs, and stream base flow. Most groundwater samples were late-Pleistocene to early-Holocene; median age of well samples was 11,100 years. The relation between mean groundwater age and completed well depth across the eastern portion of the study area was similar despite differences in precipitation, topographic position, incision, thickness of the sedimentary overburden, and CRBG geologic unit. However, the lateral continuity in groundwater age was disrupted across large regional fault zones indicating these structures are substantial impediments to groundwater flow from the high-precipitation uplands to adjacent lower-precipitation and lower-elevation portions of the study area. Recharge rates calculated from the age-depth relations were <3 mm/yr and independent of the modern precipitation gradient across the study area. The age-constrained recharge rates to the CRBG groundwater system are considerably smaller than previously published estimates and highlight the uncertainty of prevailing models used to estimate recharge to the CRBG groundwater system across the Columbia Plateau in Oregon and Washington. Age tracer and isotopic evidence indicate recharge to the CRBG groundwater system is an exceedingly slow and localized process.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 45.15° to 45.6° latitude; -119.3° to -118° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Henry M. Johnson, Kate E. Ely, Anna-Turi Maher. 2024-03-30. Timing and source of recharge to the Columbia River Basalt groundwater system in northeastern Oregon. https://doi.org/10.1111/gwat.13404

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Computing flow-field distortion coefficients from well-construction and formation properties

Direct measurements of groundwater velocity made with borehole flowmeters in screened wells must be compensated for the effects of flow-field distortion (also known as borehole acceleration). A theoretical equation developed by Drost et al. (1968) and simple inputs describing hydraulic properties of well construction and geologic formation were programmed into an Excel workbook to facilitate computation by groundwater-flowmeter users. Tables describing the physical and hydraulic properties for well constructions and gravel pack media are provided with an example to facilitate use of the workbook. Groundwater flowlines converge or diverge as they pass from a geologic formation, through a gravel pack and well screen. The extent of flowline convergence or divergence and the value of the flow-field distortion coefficient is related to the relative changes in hydraulic conductivity of the well screen, gravel pack, and geologic formation. Convergence or divergence is accompanied by acceleration or deceleration of groundwater. Direct measurements of groundwater velocity at the center of the monitoring well can be adjusted to provide a more accurate estimate of velocity in the formation by applying a correction for flow-field distortion. Variables required to compute the flow-field distortion coefficient include the hydraulic conductivity of the gravel pack, well screen, and the geologic formation surrounding the well screen; the borehole radius, and the inside radius and outside radius of the well screen.

Groundwater

Deep groundwater total dissolved solids mapping in the Dakota Group, Williston Basin, USA

Growing concern about the quantity of available freshwater around the world has led to interest in surveying groundwater total dissolved solids (TDS) below water well depths. Deep TDS has not been systematically mapped, and there is much to learn about the distribution and controls on deeper groundwater. In sedimentary basins across the United States, groundwater resources often overlie hydrocarbon resources, providing an opportunity to use borehole geophysical data collected for hydrocarbons to characterize groundwater and pore space resources. This study adapts a recently developed subsurface geostatistical and geophysical modeling approach to continuously map groundwater TDS, porosity, and temperature in the Dakota Group of the Williston Basin—an undercharacterized regional aquifer system overlying deeper hydrocarbon reservoirs. Groundwater TDS in the Dakota Group ranges from approximately 4800 to 26,900 mg/L. TDS patterns are stratified with higher TDS in the lower and upper Dakota Group, and relatively lower TDS in the middle Dakota Group. The lower TDS in the middle zone may represent a preferential regional flow path for lower-TDS meteoric recharge from the west. The alternating pattern of TDS may also be evidence of higher-TDS inflows into the Dakota Group from underlying and potentially from overlying aquifers. Porosity is lower near the center of the Williston Basin and tends to be higher to the east, which may be related to grain size distributions. The new regional TDS and porosity modeling serves as a quantitative reference for water users and provides supporting evidence for hypotheses on Dakota Group recharge.

Montana, North Dakota, South Dakota