USGS Science⌕ Search

USGS · 70249946

Increasing salt marsh elevation using sediment augmentation: Critical insights from surface sediments and sediment cores

Abstract

Sea-level rise is particularly concerning for tidal wetlands that reside within an area with steep topography or are constrained by human development and alteration of sedimentation. Sediment augmentation to increase wetland elevations has been considered as a potential strategy for such areas to prevent wetland loss over the coming decades. However, there is little information on the best approaches and whether adaptive management actions can mimic natural processes to build sea-level rise resilience. In addition, the lack of information on long-term marsh characteristics, processes, and variability can hamper development of effective augmentation strategies. Here, we assess a case study in a southern California marsh to determine the nature of the pre-existing sediments and variability of the site in relation to sediments applied during an augmentation experiment. Although sediment cores revealed natural variations in the grain size and organic content of sediments deposited at the site over the past 1500 years, the applied sediments were markedly coarser in grain size than prehistoric sediments at the site (100% maximum sand versus 76% maximum sand). The rate of the experimental sediment application (25.1 ± 1.09 cm in ~2 months) was also much more rapid than natural accretion rates measured for the site historically. In contrast, post-augmentation sediment accretion rates on the augmentation site have been markedly slower than pre-augmentation rates or current rates on a nearby control site. The mismatch between the characteristics of the applied sediment and thickness of application and the historic conditions are likely strong contributors to the slow initial recovery of vegetation. Sediment augmentation has been shown to be a useful strategy in some marshes, but this case study illustrates that vegetation recovery may be slow if applied sediments are not similar or at a thickness similar to historic conditions. However, testing adaptation strategies to build wetland elevations is important given the long-term risk of habitat loss with sea-level rise. Lessons learned in the case study could be applied elsewhere.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 33.69542678704275° to 33.75624740889455° latitude; -118.14022977437972° to -118.01663358297355° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Elizabeth Fard, Lauren N. Brown, Richard F. Ambrose, Christine R Whitcraft, Karen M. Thorne, Nathaniel J. Kemnitz, Douglas E. Hammond, Glen M. MacDonald. 2023-11-01. Increasing salt marsh elevation using sediment augmentation: Critical insights from surface sediments and sediment cores. https://doi.org/10.1007/s00267-023-01897-8

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Assessing low-dose copper treatment for dreissenid mussels: Effects on nontarget organisms

Zebra mussels ( Dreissena polymorpha ), an invasive dreissenid mussel, have been established and caused considerable effects in many North American aquatic ecosystems. In response, copper-based pesticides have been used to manage zebra mussel populations. We evaluated the effects of a low-dose (60 µg Cu/L for 10 d) copper-based molluscicide for zebra mussel suppression on nontarget species in Lake Minnetonka (Minnesota, USA). Specifically, we assessed changes in four fish species, a native mussel species, adult zebra mussels, chlorophyll-a concentrations (as a proxy for phytoplankton productivity), the zooplankton community, and the benthic invertebrate community before and after treatment. Chlorophyll- a concentration increased in both the treated and reference bays 1 and 4 d posttreatment. Non-target zooplankton community composition changed in both bays over the course of this study; zooplankton abundance and diversity initially decreased in the treated bay but gradually recovered and was back to pretreatment and reference bay levels after one year. We observed no significant differences in non-target benthic invertebrate abundance or diversity between the treated and reference bays, although abundance and diversity estimates were dynamic and uncertain. Among caged non-target organisms, copper bioaccumulation was higher in both mussel species than in fish, and among fish, was highest in fathead minnow ( Pimephales promelas ). These findings contribute to our understanding of the potential effects of copper-based pesticides on aquatic ecosystems and provide insights for zebra mussel management.

Minnesota↗

Assessing a low-dose copper treatment for dreissenid mussels: Effects on zebra mussel (Dreissena polymorpha) population

We conducted and evaluated a low-dose copper treatment (applied as EarthTec QZ) to suppress zebra mussel ( Dreissena polymorpha Pallas 1771) veliger abundance and settlement in a 66.3 ha bay in Lake Minnetonka (Hennepin County, MN) over a 3-y period. We maintained a mean (standard deviation [SD]) concentration of 83.0 (10.3) µg/L as copper over the 10-d treatment period, much lower than the maximum allowable 1 mg/L as copper. Veliger density was reduced from 6.0 veligers/L before treatment to 0.3 veligers/L following the treatment period. Posttreatment zebra mussel settlement was 1900 times lower in the treated bay compared to an untreated bay days after the treatment despite similar pretreatment veliger densities. Veliger density and settlement remained suppressed nearly 2 y following the treatment. Sampling for adult zebra mussels within the treated bay returned variable results but survival of caged adult zebra mussels indicated ~30% treatment-related mortality. Copper in surface waters returned to near pretreatment concentrations 90 d after treatment. Our study demonstrates that low-dose applications of a copper molluscicide can effectively reduce zebra mussel veliger densities and settlement.

Minnesota↗

Lessons learned from a hybrid approach to collecting user feedback on coastal science products

Science products play a critical role in assisting environmental decision-makers to manage coastal systems; yet there are challenges to developing products that align with needs of end-users. By combining aspects of usability testing and contextual inquiry methods, we describe a hybrid approach for collecting user feedback, especially applicable within the federal government context. This paper presents results of this hybrid testing approach on two of U.S. Geological Survey’s science products, the Coastal Change Likelihood (CCL) and Hazard Exposure Reporting and Analytics (HERA). Both science products synthesize coastal hazard exposure at different geographies and scales. By comparing two science products in different stages of development, we identify common usability issues across both products; the importance of defining a target audience; requested functionalities beyond the products’ scope; and the effect of previous stakeholder engagement on how testers describe technical issues and barriers. Results from user feedback contribute to understanding needs and barriers of coastal decision-makers for science product development. This paper broadens the understanding of environmental decision-makers in the science product development cycle, and how social dimensions can be integrated in project design through iteratively working with end-users and product developers. Further, we present general lessons in usability for development cycles and how these lessons can inform development of actionable science products in coastal management.

Environmental Management↗