USGS ScienceSearch

USGS · 70226793

The Uralides and the motion of the Russian and Siberian Platforms

Abstract

The Uralides—the late Precambrian and Paleozoic orogenic terrane between the Russian and Siberian Platforms—in part are exposed in the Ural Mountains, in the central Soviet Arctic, along the west edge of the Siberian Platform, and in southern Siberia and Kazakhstan, and in part are buried beneath the fill of the West Siberian Lowlands and other basins. Paleomagnetic orientations suggest that the Russian and Siberian Platforms were far apart during the early Paleozoic, converged during the middle Paleozoic, and collided in the Permian or Triassic. The geology of the Uralides accords with the concept that the two subcontinents approached and collided as the intervening oceanic plate slid beneath them along subduction (Benioff) zones. The medial eugeosyncline of the Uralides consists largely of what may be oceanic material scraped off against the edges of the opposed subcontinents. Basalt-and-spilite belts may represent ocean-floor abyssal tholeiite, and the manganiferous cherts and other sediments upon them may be pelagic oozes. Andesite belts may have formed as island arcs within the ocean, swept subsequently against the continents. Fossil subduction zones are recorded by great faults soled by, or containing tectonic injections of, mafic and ultramafic rocks from the lower oceanic crust and upper mantle, and containing high-pressure metamorphic rocks. Granitic and silicic-volcanic rocks may have formed above the subduction zones in the accreted parts of the continental plates. Both these continental-margin magmatic rocks and the island-arc complexes display ratios of potassium to silicon that vary across strike and so indicate the directions of dip of the subduction zones. From the distribution of such indicators of various ages, a history of the continental margins can be deduced. An active subduction zone dipped beneath the Siberian Platform during at least parts of late Precambrian and early, middle, and late Paleozoic time. The late Precambrian and Cambrian history of the Russian side is unclear, but in the Ordovician and Silurian the Russian continental margin was stable, while somewhere offshore an island arc was present whose trench was on the Russian side; the last of the intervening oceanic plate vanished down the subduction zone in about the Early Devonian, and the island arc became part of the continental margin. During the remainder of the Devonian and during the Carboniferous and Early Permian, a subduction zone was present along the margin of the enlarged Russian continent and dipped beneath it. Each subcontinent grew oceanward as oceanic material was accreted against it, and the subduction zones stepped oceanward correspondingly. The continental magmatic zones migrated oceanward behind the accreting edges of the continental plates, so the tectonic and magmatic progression with time at any one place is analogous to the variations present across the entire orogenic belt at any one time. Severe right-lateral deformation of the Uralides, the Russian side having moved northward relative to the Siberian side during Mesozoic and early Cenozoic time, is inferred from structural and magnetic-anomaly patterns. The deformation was accomplished by oroclinal folding, strike-slip faulting, and tensional thinning of the crust. The Uralides may have been continuous in early Mesozoic time with the Ellesmerides of North Greenland and the Canadian Arctic islands. The Cenozoic (and late Mesozoic?) opening of the Arctic Ocean was accomplished by spreading of the Eurasia Basin, and by opening of the Canada Basin behind a counterclockwise-rotating Alaska.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 44.715513732021336° to 77.11803181203176° latitude; 44.6484375° to 77.34374999999999° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Warren B. Hamilton. 1970. The Uralides and the motion of the Russian and Siberian Platforms. https://doi.org/10.1130/0016-7606(1970)81%5B2553%3Atuatmo%5D2.0.co%3B2

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Uncertainties in slip-rate estimates for the Mission Creek strand of the southern San Andreas fault at Biskra Palms Oasis, southern California

This study focuses on uncertainties in estimates of the geologic slip rate along the Mission Creek strand of the southern San Andreas fault where it offsets an alluvial fan (T2) at Biskra Palms Oasis in southern California. We provide new estimates of the amount of fault offset of the T2 fan based on trench excavations and new cosmogenic 10 Be age determinations from the tops of 12 boulders on the fan surface. We present three alternative fan offset models: a minimum, a maximum, and a preferred offset of 660 m, 980 m, and 770 m, respectively. We assign an age of between 45 and 54 ka to the T2 fan from the 10 Be data, which is significantly older than previously reported but is consistent with both the degree of soil development associated with this surface, and with ages from U-series geochronology on pedogenic carbonate from T2, described in a companion paper by Fletcher et al. (this volume). These new constraints suggest a range of slip rates between ∼12 and 22 mm/yr with a preferred estimate of ∼14–17 mm/yr for the Mission Creek strand of the southern San Andreas fault. Previous studies suggested that the geologic and geodetic slip-rate estimates at Biskra Palms differed. We find, however, that considerable uncertainty affects both the geologic and geodetic slip-rate estimates, such that if a real discrepancy between these rates exists for the southern San Andreas fault at Biskra Palms, it cannot be demonstrated with available data.

California

Stratigraphic and structural synthesis of a Miocene extensional terrane, southeast California and west-central Arizona

Detailed stratigraphy and isotopic dating of stratigraphic sections in the Colorado River extensional corridor support a regional correlation of highly faulted Tertiary stratigraphic sequences and provide a chronologic framework for interpreting the evolution of low-angle normal (detachment) faults. On the basis of this correlation, we define six tilting domains in the upper plate of the Whipple, Chemehuevi, and Rawhide detachment faults and identify three discrete episodes of detachment faulting that began in the early Miocene and ended in middle Miocene time. Episodes of rapid detachment faulting are indicated by extreme tilting of upper-plate fault blocks and overlying Miocene sequences, fanning dips of basinal deposits, and angular unconformities that represent short time gaps in the accumulation of syntectonic sequences. During the first episode of detachment faulting at about 20 Ma, the upper plate segmented to form the domains. Basin subsidence and extreme tilting of upper-plate fault blocks and syntectonic deposits characterized the eastern Topock, Crossman, Aubrey, Parker Dam, and Buckskin-Rawhide domains, whereas the western Mopah domain was the site of abundant volcanic activity but no basins or tilting. A second episode of extension at about 18 Ma produced extreme tilts in the Buckskin-Rawhide domain but upper-plate blocks in the Mopah domain tilted moderately. A third regionwide faulting episode between 14 and 12 Ma was due to localized uplift of middle and lower crust and eventual exposure of the detachment faults and their footwalls. The upper-plate fault blocks responded passively to localized slip on the detachment faults. Rapid extension began on the Whipple-Chemehuevi detachment fault at 20 Ma and had shifted southward to the Buckskin-Rawhide detachment fault by 18 Ma; volcanic activity also shifted southward to the Buckskin-Rawhide domain at this time. The southward shift of rapid extension and volcanism probably represents buildup and release of strain at localized sites in the lower plate. Otherwise, stratigraphic and structural relations indicate that the locations of upper-plate basins, faulting and tilting of upper-plate blocks, and position of the breakaway zone remained stable throughout the major phases of extension.

Arizona, California

Basin and range structure: A system of horsts and grabens produced by deep-seated extension

Basin and Range structure can be interpreted as a system of horsts and grabens produced by the fragmentation of a crustal slab above a plastically extending substratum. According to this view, the extension of the substratum causes the basal part of the slab to be pulled apart along narrow, systematically spaced zones which in turn cause the downdropping of complex horizontal prisms (grabens) in the brittle upper crust. The grabens form valleys at the surface; the intervening areas are horsts, or tilted horsts. Not all geologists have agreed, however, that Basin and Range structure consists of a system of horsts and grabens. Instead, the structure is commonly considered to consist of tilted blocks in which the upslope part of an individual block forms a mountain and the downslope part a valley. Recent detailed studies, including geophysical work, suggest that the horst and graben model may be more generally applicable. Many of the valleys in the Great Basin are bounded on both sides by faults that drop the valley block down; these faults are exposed at the surface or can be inferred from steep gravity gradients indicative of steep faulted subsurface bedrock slopes. Some areas that were thought to represent a typical series of tilted blocks may be a series of highly asymmetrical grabens in which one side of a valley is marked by a master fault and the other side by valleyward tilt. With present knowledge, most, or perhaps all, of the major valleys in the Great Basin can plausibly be considered to be grabens, and most or all of the mountains can be considered to be horsts or tilted horsts. The grabens, and the underlying inferred deep zones of extension that cause them, are systematically distributed in the Great Basin. They are generally north-trending features spaced 15 to 20 mi apart. Locally, the pattern is more complex, and individual grabens divide and trend away from each other at acute or high angles. In a few places, the pattern may even be roughly polygonal. The distribution pattern of the grabens and the related deep zones of extension resemble crack patterns in small-scale tensional systems, and both patterns may be mechanically related. By analogy with the small-scale systems, the areas of generally north-trending and parallel grabens require east-west extension, whereas the areas with a possible polygonal pattern of grabens must extend radially. The geometry of block faulting related to Basin and Range structure requires sizable east-west extension, estimated at about 1.5 mi on the average for each major valley and at about 30 to 60 mi across the entire Great Basin. Most of this extension has taken place in the last 17 m.y., or perhaps even in the last 7 to 11 m.y., indicating a rate of extension in the range of 0.3 to 1.5 cm/yr.

Arizona, California, Idaho, Nevada, Oregon, Utah