USGS ScienceSearch

USGS · 70221199

Relations of fresh and salty ground water along the southeastern U. S. Atlantic Coast

Abstract

Studies of the hydrogeologic environments and the dynamic and equilibrium relations of fresh and salt water in aquifers have been intensified at several places along the southeastern Atlantic Coast. Some salt-water problems involve the coastal water-table aquifer, and others involve parts of the artesian system. On the sandy coastal islands of North Carolina, freshwater lenses under water-table conditions float on salt water. Salt-water contamination may take place by (1) lateral encroachment from the ocean and bay; (2) vertical encroachment from below; (3) overland inundation by ocean water during storms; and (4) downward percolation of salt spray and salt-bearing precipitation. In the Savannah, Georgia, and South Carolina area, salt-water encroachment along two of five water-bearing zones in the principal artesian (limestone) aquifer has been caused by the decline of artesian pressure due to pumping. Some wells in the limestone at nearby Parris Island, South Carolina, yield salty water when overpumped. From Savannah southward at least to Fernandina, Florida, connate salty water occurs in the artesian aquifer below the fresh water. At Brunswick, Georgia, connate salty water is stratified between fresh-water bodies in the limestone aquifer above depths of 2,000 feet. Connate salty water has contaminated the aquifer between depths of 500 and 800 feet in a small area in the city. Along the southeast Florida coast drainage canals have been the primary cause of salt-water contamination of the highly permeable Biscayne aquifer. Criteria have been established for the operation of salinity-control dams to prevent encroachment. The salt-water front in the aquifer along the coast is dynamically stable under natural conditions.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 24.926294766395593° to 37.23032838760384° latitude; -88.33007812499999° to -75.5859375° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R. L. Wait, J.T. Callahan. 2006-07-06. Relations of fresh and salty ground water along the southeastern U. S. Atlantic Coast. https://doi.org/10.1111/j.1745-6584.1965.tb01224.x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Computing flow-field distortion coefficients from well-construction and formation properties

Direct measurements of groundwater velocity made with borehole flowmeters in screened wells must be compensated for the effects of flow-field distortion (also known as borehole acceleration). A theoretical equation developed by Drost et al. (1968) and simple inputs describing hydraulic properties of well construction and geologic formation were programmed into an Excel workbook to facilitate computation by groundwater-flowmeter users. Tables describing the physical and hydraulic properties for well constructions and gravel pack media are provided with an example to facilitate use of the workbook. Groundwater flowlines converge or diverge as they pass from a geologic formation, through a gravel pack and well screen. The extent of flowline convergence or divergence and the value of the flow-field distortion coefficient is related to the relative changes in hydraulic conductivity of the well screen, gravel pack, and geologic formation. Convergence or divergence is accompanied by acceleration or deceleration of groundwater. Direct measurements of groundwater velocity at the center of the monitoring well can be adjusted to provide a more accurate estimate of velocity in the formation by applying a correction for flow-field distortion. Variables required to compute the flow-field distortion coefficient include the hydraulic conductivity of the gravel pack, well screen, and the geologic formation surrounding the well screen; the borehole radius, and the inside radius and outside radius of the well screen.

Groundwater

Deep groundwater total dissolved solids mapping in the Dakota Group, Williston Basin, USA

Growing concern about the quantity of available freshwater around the world has led to interest in surveying groundwater total dissolved solids (TDS) below water well depths. Deep TDS has not been systematically mapped, and there is much to learn about the distribution and controls on deeper groundwater. In sedimentary basins across the United States, groundwater resources often overlie hydrocarbon resources, providing an opportunity to use borehole geophysical data collected for hydrocarbons to characterize groundwater and pore space resources. This study adapts a recently developed subsurface geostatistical and geophysical modeling approach to continuously map groundwater TDS, porosity, and temperature in the Dakota Group of the Williston Basin—an undercharacterized regional aquifer system overlying deeper hydrocarbon reservoirs. Groundwater TDS in the Dakota Group ranges from approximately 4800 to 26,900 mg/L. TDS patterns are stratified with higher TDS in the lower and upper Dakota Group, and relatively lower TDS in the middle Dakota Group. The lower TDS in the middle zone may represent a preferential regional flow path for lower-TDS meteoric recharge from the west. The alternating pattern of TDS may also be evidence of higher-TDS inflows into the Dakota Group from underlying and potentially from overlying aquifers. Porosity is lower near the center of the Williston Basin and tends to be higher to the east, which may be related to grain size distributions. The new regional TDS and porosity modeling serves as a quantitative reference for water users and provides supporting evidence for hypotheses on Dakota Group recharge.

Montana, North Dakota, South Dakota