USGS Science⌕ Search
Home/Archive/USGS

USGS · 70215758

Surface elevation change evaluation in mangrove forests using a low‐cost, rapid‐scan terrestrial laser scanner

Ali Rouzbeh Kargar·Richard A. MacKenzie·Alexander Fafard·Ken Krauss·Jan van Aardt
View original source ↗Export metadata ↓

Abstract

Mangrove forests have adapted to sea level rise (SLR) increases by maintaining their forest floor elevation via belowground root growth and surface sediment deposits. Researchers use surface elevation tables (SETs) to monitor surface elevation change (SEC) in mangrove forests, after which this information is used to assess SLR resiliency or to dictate active forest management for vulnerable systems. This method requires significant investments in terms of time and human resources and is limited in the number of points it can measure per plot. We use a low‐cost, portable terrestrial laser scanning (TLS) system to assess SEC for three mangrove forests on Pohnpei Island (Federated States of Micronesia). Cloth simulation filtering was used for ground detection, after which results were refined by filtering points using angular orientation. Digital elevation models then were generated via kriging interpolation for data collected in 2017 and 2019, after which the heights of corresponding points were compared across years. Extreme elevation changes, due to disturbances such as footprints or fallen logs, were removed using interquartile range analysis. The TLS‐obtained average SEC ranged between −6.92 and +6.01 mm, which exhibited an average consistency of 72% when compared to simultaneously collected SET data (root mean square error = 1.36 mm). We contend that this approach represents an improvement over the manual method, where very few points typically are used, that is, ≅ 36 points vs. ≅ 30,000 points in the case of TLS, and could contribute to improved monitoring and management of these rapidly changing forest environments.

Explore related subjects

Limnology and Oceanography MethodsArticle

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Ali Rouzbeh Kargar, Richard A. MacKenzie, Alexander Fafard, Ken Krauss, Jan van Aardt. 2020-10-26. Surface elevation change evaluation in mangrove forests using a low‐cost, rapid‐scan terrestrial laser scanner. https://doi.org/10.1002/lom3.10401

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

A simplified two-station approach for modeling metabolism in dam tailwaters subject to diel flow variation

Tailwaters are ubiquitous and highly managed ecosystems whose food webs often rely disproportionately on autochthonous energy. In situ continuous dissolved oxygen data are increasingly being used to estimate gross primary productivity and ecosystem respiration in rivers, but this approach is complicated in tailwaters, where upriver discontinuities (i.e., dams) violate commonly employed one-station approaches. In such cases, two-station metabolism models can be applied, although substantial diel variation in flow (a common outcome of hydropower production) requires more complex treatment of water parcel travel times. Here, we present a new two-station metabolism model that allows estimation of reach-scale gross primary productivity and ecosystem respiration in streams and rivers that experience within-day variation in flow. Our approach simplifies two-station variable flow model implementation compared to previous efforts. We apply our model to a 6-yr dissolved oxygen time series and use Bayesian inference to estimate daily gross primary productivity, ecosystem respiration, and gas exchange velocity ( k 600 ) for a ~12-km reach of the Colorado River downriver of Glen Canyon Dam. We compare our model's performance to a more mechanistically detailed and computationally intensive Eulerian dynamic flow model and also to a widely-used one-station model that uses assumptions of reach uniformity that are often strongly violated in tailwaters. These comparisons show that our metabolism estimates conform with output from the more detailed dynamic flow model and that the one-station approach deviates substantially from both two-station approaches. Our new stream metabolism model can help resolve a fundamental analytical impediment in tailwater ecology.

Arizona↗
USGS2026

Demonstration, validation, and application of hyperspectral microscopy for the collection of cyanobacterial spectral signatures

Cyanobacterial and other algal blooms are an environmental concern in waterbodies worldwide. While these blooms are a nuisance for recreational activities, they can also be harmful to human and wildlife health when the algae produce and release toxins. Algal community composition can be monitored and analyzed by acquiring hyperspectral images that provide information on various photosynthetic and accessory pigments. Validated, traceable measurements are needed to compare data collected by different hyperspectral instruments. In this proof-of-concept study, we detail the development and validation of a custom hyperspectral microscopy imaging system and assess whether this technology can differentiate between cyanobacteria genera based on differences in their reflectance characteristics. As not all cyanobacteria produce toxins, the ability to distinguish among taxa could be used to identify potential toxin-producers and guide field sampling and further research. Spectral characterization of these taxa contributes to remote sensing efforts to characterize and identify cyanobacterial genera at larger spatial scales.

Oregon↗
USGS2025

Spatial mapping of dissolved methane using an in situ sensor in Puget Sound

Release of methane, as gas bubbles or in the dissolved phase, from the seafloor has been observed in coastal waters (< 200 m) and deep ocean basins (> 1000 m). Methane dissolution within the water column affects the geochemistry of the surrounding water, leading to localized oxygen loss and potential escape to the atmosphere, particularly from shallower sites. Traditional methods for detecting and quantifying dissolved methane rely on collecting discrete water samples for ship- or land-based ex situ analysis and post processing. Here, we report on the use of a reduced response time, in situ methane sensor, the Sensor for Aqueous Gases in the Environment (SAGE), for detecting and quantifying dissolved methane concentrations in a wide range of seafloor environments. During a Fall 2022 research cruise on the R/V Thomas G. Thompson in Puget Sound, SAGE was integrated onto a towed conductivity/temperature/depth rosette and deep-sea camera system with live-stream 1 Hz telemetry and used to spatially map the concentration of methane approximately 1 m above the seafloor. The site had been previously identified as an active methane plume field characterized by gas bubbles, fluid venting, and a faulted seabed. The widespread background dissolved concentration of methane measured by SAGE was 83 nM, and a range of 78–670 nM was observed throughout the survey. The results highlight the capacity of SAGE to map the spatial and temporal variability of dissolved methane concentrations in situ and to identify and localize sites of variable methane emissions from the seafloor.

Washington↗