USGS ScienceSearch

USGS · 70204731

Controls on organic matter distributions in Eocene Lake Uinta, Utah and Colorado

Abstract

The Green River Formation deposited in Eocene Lake Uinta in the Uinta and Piceance Basins, Utah and Colorado, contains the largest oil shale resource in the world with an estimated 1.53 trillion barrels of oil in-place in the Piceance Basin and 1.32 trillion barrels in the Uinta Basin. The Douglas Creek arch, a slowly subsiding hinge-line between the two basins, created separate deep depocenters with shallow water conditions near the crest of the arch. Lake Uinta was a saline lake throughout its history with a lower saline to hypersaline layer (monimolimnion) and an upper less saline layer (mixolimnion). Most of the organic matter in the Green River Formation was derived primarily from algae that lived in the photic zone of the lake and is very hydrogen-rich and oil-prone. In many modern large and deep lakes, rates of organic matter production are highly variable due to differences in nutrient supply. However, cyclonic circulation often leads to winnowing out organic and mineral matter in the mixolimnion leading to organic and fine-grained mineral matter being deposited in increasing amounts toward hydro-dynamically dead zones in the center of the circulation producing concentric bands of increasing organic matter content. Organic matter transport through the dense, hypersaline monimolimnion may have been facilitated by low density organic matter attaching to more dense clay mineral particles. Most of the oil shale intervals deposited in Lake Uinta display similar patterns in their organic matter distributions, increasing in very regular fashion toward the central areas of the lake’s two depocenters. This concentric feature is particularly prominent in the most laminated oil shale zones. Here, we propose that cyclonic circulation was present in Lake Uinta. Each basin appears to have had its own circulation currents, separated by shallow water conditions near the Douglas Creek arch, as well as one hydro-dynamically dead zone. Sediment gravity flow processes were also very active in some strata of Lake Uinta, leading to the reworking and redepositing of sediments. Two general types of sediment gravity flows are recognized: (1) organic-rich sediment gravity flows that reworked and may have concentrated organic-rich material closer to the two deep depocenters, and (2) sandstone and siltstone-rich organic-poor mass movement deposits that originated on marginal shelves. Mass movements could have been triggered by various natural processes and/or possibly by the movement of dense brines that evolved on marginal shelves and moved along the bottom of the water column toward the deep part of the lake. The uppermost, poorly consolidated sediment layer was incorporated in sediment gravity flows as they moved, and in many cases sediment gravity flows scoured down significantly into the more consolidated underlying sediment producing large rip-up clasts of laminated sediments. Truncation of more than 100 ft occurs at the base of a sequence of sediment gravity flows in one well, indicating a significant incised channel. Coarser-grained sediment gravity flows terminated before reaching the lake’s deepest areas, forming thick concentric buildups of organically-lean sediment near the base of the marginal slopes. Intervals dominated by organic-rich fine-grained sediment gravity flows have tightly concentric bands of increasing organic matter toward the deepest parts of the lake and can be organically richer than the richest laminated intervals. There is some evidence that the hydro-dynamically quiet zones did not always correspond closely to the deepest areas of the lake, extending in some cases into shallower areas.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 36.992426° to 42.001567° latitude; -114.052962° to -102.041524° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Ronald C. Johnson, Tracey J. Mercier, Justin E. Birdwell. 2019. Controls on organic matter distributions in Eocene Lake Uinta, Utah and Colorado. https://doi.org/10.31582/rmag.mg.55.4.177

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Characterization of feed coals and coal combustion byproducts from the Wyodak-Anderson coal zone, Powder River Basin, Wyoming

The U.S. Geological Survey (USGS) determined the physical and chemical properties of more than 260 feed coal and coal combustion byproducts from two coal-fired power plants. These plants utilized a low-sulfur (0.23-0.47 wt. % S) and low ash (4.9-6.3 wt. % ash) subbituminous coal from the Wyodak-Anderson coal zone in the Tongue River Member of the Paleocene Fort Union Formation, Powder River Basin, Wyoming. Fifty-three samples of bituminous coal were collected and analyzed from a Kentucky power plant, which used several sources of bituminous coals from the Appalachian and Illinois Basins. Based on scanning electron microscopy (SEM) and X-ray diffraction (XRD) analyses of feed coal samples collected and analyzed from 1996 through the late 2000s, two mineral suites were identified: (1) a primary or detrital suite consisting of quartz (including beta-form grains), biotite, feldspar, and minor zircon; and (2) a secondary authigenic mineral suite containing alumino-phosphates (crandallite and gorceixite), kaolinite, carbonates (calcite and dolomite), quartz, anatase, barite, and pyrite. The detrital mineral suite is interpreted, in part, to be of volcanic origin, whereas the authigenic mineral suite is interpreted, in part, to be the result of the alteration of the volcanic minerals. The mineral suites have contributed to the higher amounts of barium, calcium, magnesium, phosphorus, sodium, strontium, and titanium in the Powder River Basin feed coals in comparison to eastern US coals. XRD analysis indicates that (1) fly ash is mostly aluminate glass, perovskite, lime, gehlenite, quartz, and phosphates with minor amounts of periclase, anhydrite, hematite, and spinel group minerals; and (2) bottom ash is predominantly quartz, plagioclase (albite and anorthite), pyroxene (augite and fassaite), rhodonite, and akermanite, and spinel group minerals. Microprobe and SEM analyses of fly ash samples revealed quartz, zircon, and monazite, euhedral laths of corundum with merrillite, hematite, dendritic spinels/ferrites, wollastonite, and periclase. The abundant calcium and magnesium mineral phases in the fly ash are attributed to the alteration of carbonate, clay, and phosphate minerals in the feed coal during combustion. The calcium- and magnesium-rich and alumino-phosphate mineral phases in the coal combustion byproducts can be attributed to volcanic minerals deposited in peat-forming mires. Dissolution and alteration of these detrital volcanic minerals occurred either in the peat-forming stage or during coalification and diagenesis, resulting in the authigenic mineral suite. The presence of free lime (CaO) in fly ash produced from Wyodak-Anderson coal acts as a self-contained “scrubber” for SO 3 , where CaO + SO 3 form anhydrite either during combustion or in the upper parts of the boiler. Considering the high lime content in the fly ash and the resulting hydration reactions after its contact with water, there is little evidence that major amounts of leachable metals are mobilized in the disposal or utilization of this fly ash.

Wyoming

Mineralogy and lithology of the Upper Cretaceous Niobrara Formation determined by hyperspectral core imaging

Sections of the Upper Cretaceous (Coniacian to Campanian) Niobrara Formation in two cores from Kansas and Colorado, the Amoco Rebecca Bounds and USGS Portland 1, respectively, were examined by hyperspectral core imaging and analysis. A spectral imaging system combining high-resolution photography (50 μm), 3D laser profiling (20 μm), and near-visible + short-wave infrared reflectance spectroscopy (wavelengths from 450 to 2500 nm, 500 μm pixel size) was applied to these cores to provide spectral and textural data facilitating creation of continuous mineral and lithology class maps. In addition, compositing of pixel-based results to group pixels to create mineralogical and lithological logs (0.5 ft resolution) was performed to facilitate comparisons to other geochemical datasets. The results show general correspondence in trends identified by previous geochemistry studies, with some exceptions due to instrumental limitations related to low reflectance of some rock intervals and the limited range of infrared wavelengths examined. This study provides a cursory overview of an extensive dataset meant to demonstrate the utility of hyperspectral core scanning to studies of mudrocks in petroleum systems as well as the kinds of information this technique can provide for detailed examination of stratigraphic features in sedimentary systems more generally.

Mountain Geologist

Controls on petroleum resources for the Devonian Marcellus Shale in the Appalachian Basin Province, Kentucky, West Virginia, Ohio, Pennsylvania, and New York

Greater than 33 trillion cubic feet of gas, 68 million barrels of natural gas liquids (NGL), and 192 million barrels of water have been produced from the Middle Devonian Marcellus Shale of the Hamilton Group in the Appalachian Basin. These volumes are from more than 11,700 non-commingled wells. Areas of greatest production and future potential for gas and NGL from the Marcellus Shale are within and near the northeast-trending Rome trough in northern West Virginia and Pennsylvania. Southernmost New York, eastern Ohio, western Virginia, and Maryland also contain petroleum potential and (or) reserves. A confluence of factors enhances gas and NGL reserves and resources in the Marcellus Shale. These include (1) brittleness based on lithofacies composition; (2) thickness and distribution of brittle and organic-rich shale; (3) measured thermal maturity of 1% vitrinite reflectance and greater; (4) at least 2 weight percent total organic carbon; (5) dense and complex fracturing and faulting; (6) presence of evaporite beds in the underlying Silurian Salina Group; (7) potential overpressure; (8) current depths of 1,370 m (4,500 ft) and greater; and (9) predominately horizontal wells with laterals that are oriented to the northwest or southeast, or roughly perpendicular to the direction of maximum horizontal stress, and that cross major fault and fracture sets.

Kentucky, West Virginia, Ohio, Pennsylvania, New Y