USGS ScienceSearch

USGS · 70196696

A numerical model investigation of the impacts of Hurricane Sandy on water level variability in Great South Bay, New York

Abstract

Hurricane Sandy was a large and intense storm with high winds that caused total water levels from combined tides and storm surge to reach 4.0 m in the Atlantic Ocean and 2.5 m in Great South Bay (GSB), a back-barrier bay between Fire Island and Long Island, New York. In this study the impact of the hurricane winds and waves are examined in order to understand the flow of ocean water into the back-barrier bay and water level variations within the bay. To accomplish this goal, a high resolution hurricane wind field is used to drive the coupled Delft3D-SWAN hydrodynamic and wave models over a series of grids with the finest resolution in GSB. The processes that control water levels in the back-barrier bay are investigated by comparing the results of four cases that include: (i) tides only; (ii) tides, winds and waves with no overwash over Fire Island allowed; (iii) tides, winds, waves and limited overwash at the east end of the island; (iv) tides, winds, waves and extensive overwash along the island. The results indicate that strong local wind-driven storm surge along the bay axis had the largest influence on the total water level fluctuations during the hurricane. However, the simulations allowing for overwash have higher correlation with water level observations in GSB and suggest that island overwash provided a significant contribution of ocean water to eastern GSB during the storm. The computations indicate that overwash of 7500–10,000 m 3 s −1 was approximately the same as the inflow from the ocean through the major existing inlet. Overall, the model results indicate the complex variability in total water levels driven by tides, ocean storm surge, surge from local winds, and overwash that had a significant impact on the circulation in Great South Bay during Hurricane Sandy.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 40.55° to 40.8° latitude; -73.7° to -72.7° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Vanessa C. C. Bennett, Ryan P. Mulligan, Cheryl J. Hapke. 2018. A numerical model investigation of the impacts of Hurricane Sandy on water level variability in Great South Bay, New York. https://doi.org/10.1016/j.csr.2018.04.003

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Nearshore bathymetric changes along the Alaska Beaufort Sea coast and possible physical drivers

Erosion rates along Alaska's Beaufort Sea coast, among the highest in the world, are negatively impacting communities, industrial and military infrastructure, and wildlife habitat. Decreasing maximal winter ice extent and increasing summer open water duration and extent in the Beaufort Sea may be making the coast more vulnerable to destructive storm waves than during recent, colder, icier decades. Previous studies of Beaufort Sea coastal change have been limited to subaerial analyses of the shoreline. Here we describe nearshore seafloor change by comparing post-World War II (WWII) (1945-53) bathymetry data to recently acquired (1985–2018) bathymetry data and relate the observed seafloor change to adjacent shoreline change near Utqiagvik, within Stefansson Sound, and immediately west of Barter Island and Kaktovik. Within the Utqiagvik region, seabed erosion was generally highest (>1.0 m of loss) offshore of Point Barrow and along the eastern end of the Tapkaluk Islands, while there were lesser amounts of deposition (<0.5 m of gain) within the protected waters of Elson Lagoon. Sedimentation was generally highest offshore of Point Barrow, in a region of converging currents, and on the landward side of the barrier islands and spits fronting Elson Lagoon, which is likely related to a regional trend of westerly sediment transport and landward migration of the barrier islands. Within Stefansson Sound, perhaps the most notable changes from post-WWII bathymetry data compared to recent data are a switch from mixed, low erosion and deposition in 1997 to low deposition (<0.5 m) in 2018 east of the Boulder Patch, a switch from low erosion in 1997 to neutral depth change in 2018 in the channel between the north and south Boulder Patch areas, and higher deposition from 1997 to 2018 landward of the rapidly retreating barrier islands along the Sound's northern border. At Barter Island, high erosion near north-facing shorelines and high deposition near west-facing shorelines generally matched shoreline changes. One of our goals is to identify possible processes responsible for the depth changes we quantified. Using simple metrics that relate sediment characteristics with modeled waves and non-wave induced currents, we show that sediment resuspension and transport by both wave and non-wave driven currents likely contribute to the overall patterns of change within the ∼13 m isobath along the open coast, and that the influence of wave action affecting sediment transport is expanding seaward.

Alaska

Crowd-sourced SfM: Best practices for high resolution monitoring of coastal cliffs and bluffs

Structure from motion (SfM) photogrammetry is an increasingly common technique for measuring landscape change over time by deriving 3D point clouds and surface models from overlapping photographs. Traditional change detection approaches require photos that are geotagged with a differential GPS (DGPS) location, which requires expensive equipment that can limit the ability of communities and researchers to perform frequent ( i.e. daily, weekly, and/or monthly) surveys. Crowd-sourced photos can lower the barrier to entry and substantially increase the frequency of surveys, although such photos often lack accurate location information and can vary in quality. This paper presents a SfM approach for monitoring environmental change in high relief coastal environments that does not require all photos have DGPS location information and does not require field survey data. A 1.5 km section of coastal bluffs near the Elwha River Delta (Washington state) is used to demonstrate the efficacy of this approach. Photos of the bluff were collected with a digital SLR camera or phone camera while either on foot along the beach or from a boat as part of monitoring following removal of two large dams along the Elwha River during 2011–2013. Only 33% of photos had DGPS location information, whereas most photos had no location information or locations that were accurate to a couple of meters. All photos were processed using 3D, 4D, and fixed-floating (FF) SfM alignment methods and the resulting dense point clouds are used to compare the different alignment approaches with crowd-sourced photo sets. Results demonstrate that 4D and FF approaches are more likely to reconstruct and are more accurate than the 3D approach. While the 4D and FF have comparable accuracies, the FF approach is several orders of magnitude more efficient, as this method can leverage camera location information from relatively few photos to improve the accuracy of all aligned and derived products. Effectively utilizing crowd-sourced photos in SfM change detection can improve the frequency of surveying a landscape in a more cost-effective approach that also has potential for citizen-science engagement and communication. This is especially important for data-poor environments such as high-relief coastal cliffs and bluffs, where near-nadir imagery and LIDAR may fail to accurately capture near-vertical cliffs or bluff faces. Based on the analysis of different photo alignment and filtering approaches, we present suggested best practices for engaging citizen scientists in coastal cliff and bluff monitoring efforts through collecting photos amenable for SfM reconstruction.

Washington

Observations of mixing and transport on a steep beach

Surfzone mixing and transport on a sandy, steep (∼1/8 slope), reflective beach at Carmel River State Beach, California, are described for a range of wave and alongshore flow conditions. Depth-limited wave breaking occurred close to the shore due to the steepness of the beach, creating a narrow surf/swash zone (∼10 m wide). Fluorescent Rhodamine dye was released as a slug in the surfzone, and the temporal and spatial evolution was measured using in-situ dye sensors. Dye concentration measured as a function of time reveals sharp fronts that quickly decay resulting in narrow peaks near the dye release, which subsequently broaden and decrease in peak concentration with alongshore distance. The measurements indicate two stages of mixing and transport occur inside the surfzone on the steep beach. 1) In the near-field (<50 m downstream of the dye release location), the dye fully mixed throughout the water column after a few incident waves then continued to disperse in two dimensions, with both advection and diffusion processes being important. 2) In the far-field (>50 m downstream from the dye release location), the mass transport was dominated by advection. The distance to the far-field is much shorter in the alongshore on a steep beach compared with a dissipative beach. Estimates of cross-shore and alongshore diffusion coefficients ( κ x , κ y ) were found to be similar in magnitude within the surfzone. Outside the surfzone in the far-field, the results suggest that the mixing processes are independent of those inside the surfzone. The mixing and transport of material observed on this steep beach are found to be analogous to that previously measured on dissipative beaches, however the diffusion coefficients within and outside the surfzone were found to be smaller on this steep beach.

California