Radiometric cross-calibration of EO-1 ALI with L7 ETM+ and Terra MODIS sensors using near-simultaneous desert observations

Gyanesh Chander; Amit Angal; Taeyoung Choi; Xiaoxiong Xiong

doi:10.1109/jstars.2013.2251999

Home/Archive/USGS

USGS · 70188332

Radiometric cross-calibration of EO-1 ALI with L7 ETM+ and Terra MODIS sensors using near-simultaneous desert observations

Gyanesh Chander·Amit Angal·Taeyoung Choi·Xiaoxiong Xiong

View original source ↗Export metadata ↓

Abstract

The Earth Observing-1 (EO-1) satellite was launched on November 21, 2000, as part of a one-year technology demonstration mission. The mission was extended because of the value it continued to add to the scientific community. EO-1 has now been operational for more than a decade, providing both multispectral and hyperspectral measurements. As part of the EO-1 mission, the Advanced Land Imager (ALI) sensor demonstrates a potential technological direction for the next generation of Landsat sensors. To evaluate the ALI sensor capabilities as a precursor to the Operational Land Imager (OLI) onboard the Landsat Data Continuity Mission (LDCM, or Landsat 8 after launch), its measured top-of-atmosphere (TOA) reflectances were compared to the well-calibrated Landsat 7 (L7) Enhanced Thematic Mapper Plus (ETM+) and the Terra Moderate Resolution Imaging Spectroradiometer (MODIS) sensors in the reflective solar bands (RSB). These three satellites operate in a near-polar, sun-synchronous orbit 705 km above the Earth's surface. EO-1 was designed to fly one minute behind L7 and approximately 30 minutes in front of Terra. In this configuration, all the three sensors can view near-identical ground targets with similar atmospheric, solar, and viewing conditions. However, because of the differences in the relative spectral response (RSR), the measured physical quantities can be significantly different while observing the same target. The cross-calibration of ALI with ETM+ and MODIS was performed using near-simultaneous surface observations based on image statistics from areas observed by these sensors over four desert sites (Libya 4, Mauritania 2, Arabia 1, and Sudan 1). The differences in the measured TOA reflectances due to RSR mismatches were compensated by using a spectral band adjustment factor (SBAF), which takes into account the spectral profile of the target and the RSR of each sensor. For this study, the spectral profile of the target comes from the near-simultaneous EO-1 Hyperion data over these sites. The results indicate that the TOA reflectance measurements for ALI agree with those of ETM+ and MODIS to within 5% after the application of SBAF.

Explore related subjects

IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing Article

Source-reported bounding extent: 9.644076964907923° to 34.88593094075317° latitude; -16.962890625° to 60.1171875° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Gyanesh Chander, Amit Angal, Taeyoung Choi, Xiaoxiong Xiong. 2013. Radiometric cross-calibration of EO-1 ALI with L7 ETM+ and Terra MODIS sensors using near-simultaneous desert observations. https://doi.org/10.1109/jstars.2013.2251999

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2022

Constructing a large-scale landslide database across heterogeneous environments using task-specific model updates

Preparation and mitigation efforts for widespread landslide hazards can be aided by a large-scale, well-labeled landslide inventory with high location accuracy. Recent smallscale studies for pixel-wise labeling of potential landslide areas in remotely-sensed images using deep learning (DL) showed potential but were based on data from very small, homogeneous regions with unproven model transferability. In this paper we consider a more realistic and practical setting for large-scale heterogeneous landslide data collection and DL-based labeling. In this setting, remotely sensed images are collected sequentially in temporal batches, where each batch focuses on images from a particular ecoregion, but different batches can focus on different ecoregions with distinct landscape characteristics. For such a scenario, we study the following questions: (1) How well do DL models trained in homogeneous regions perform when they are transferred to different ecoregions, (2) Does increasing the spatial coverage in the data improve model performance in a given ecoregion (even when the extra data do not come from the ecoregion), and (3) Can a landslide pixel labeling model be incrementally updated with new data, but without access to the old data and without losing performance on the old data (so that researchers can share models obtained from proprietary datasets)' We address these questions by extending the Learning without Forgetting framework, which is used for incremental training of image classification models, to the setting of incremental training of semantic segmentation models (e.g., identifying all landslide pixels in an image). We call the resulting extension Task-Specific Model Updates (TSMU). TSMU semantic segmentation framework consists of an encoder shared by all ecoregions to capture the similarities between them, and ecoregion-specific decoders to capture the nuances of each ecoregion. This framework is continually updated using a threestage training procedure for each new addition of an ecoregion without having to revisit data from old ecoregions and without losing performance on them.

IEEE Journal of Selected Topics in Applied Earth O↗

USGS2022

New generation hyperspectral data From DESIS compared to high spatial resolution PlanetScope data for crop type classification

Thoroughly investigating the characteristics of new generation hyperspectral and high spatial resolution spaceborne sensors will advance the study of agricultural crops. Therefore, we compared the performances of hyperspectral Deutsches Zentrum fur Luftund Raumfahrt- (DLR) Earth Sensing Imaging Spectrometer (DESIS) and high spatial resolution PlanetScope in classifying eight crop types in California's Central Valley during the 2020 growing season. The DESIS sensor onboard the International Space Station collects data at 235 hyperspectral narrowbands (HNB) each with 2.55 nm bandwidth from 400–1000 nm and 30 m spatial resolution. In contrast, PlanetScope Dove-R data have four multispectral broadbands (MBB) with 3–4 m spatial resolution. We obtained best classification accuracies using 14 DESIS HNB from the August 2020 image, with an overall accuracy of 85% and producer's and user's accuracies of 72–100% and 75–100%, respectively, for the eight crops. The best classification accuracies using PlanetScope data were obtained using an image mosaic pair from June and August 2020; this resulted in an overall accuracy of 79% and producer's and user's accuracies of 56–100% and 61–100%, respectively. Combining the best 14 DESIS HNB from August 2020 with the 4 PlanetScope MBB from August 2020 yielded an overall accuracy of 82% and producer's and user's accuracies of 65–100% and 60–94%, respectively. On one-to-one single date comparisons of DESIS versus PlanetScope data, the hyperspectral data always outperformed high spatial resolution data in crop type classification. Nevertheless, high spatial resolution data will remain invaluable in assessing within-field variability and crop biophysical/biochemical modeling in precision agriculture.

IEEE Journal of Selected Topics in Applied Earth O↗

USGS2021

Applications of bistatic radar to volcano topography – A review of 10 years of TanDEM-X

The TanDEM-X satellite mission has revolutionized DEM generation from spaceborne synthetic aperture radar. In addition to the primary objective of generating a consistent digital elevation model with global coverage and unprecedented accuracy, the mission has acquired time series of topographic data over several volcanoes, providing an excellent opportunity to test the use of this innovative dataset for volcano monitoring and research. In this article, we review the utilization of the single-pass TanDEM-X data for studying various kinds of volcanic activity, such as basaltic lava flows, the formation and destruction of lava domes and related pyroclastic density currents, and subsurface magma withdrawal and intrusion. We then consider the uses of these data for hazard assessment and forecasting. Our goal is to highlight the importance of timely and repeated topographic information in volcanology, and to suggest the development of future spaceborne bistatic synthetic aperture radar satellite missions, such as ESA's Earth Explorer 10 candidate mission, “Harmony.”

IEEE Journal of Selected Topics in Applied Earth O↗