USGS Science⌕ Search

USGS · 70186788

Velocity dependent friction of granite over a wide range of conditions

Abstract

Direct shear sliding experiments on bare ground surfaces of Westerly granite have been conducted over an exceptionally wide range of sliding rates (10 −4 µm/s to 10³ µm/s) at unconfined normal stresses (σ n ) of 5, 15, 30, 70, and 150 MPa. A new sample configuration was developed that permitted measurements at normal stresses of 70 and 150 MPa without immediate sample failure. Measurements of steady-state velocity dependence of friction at velocities between 10 −4 and 1 µm/s show similar velocity weakening behavior at all normal stresses, with more negative dependence at lower slip rates. However, at rates above 10 µm/s, velocity weakening is observed only at σ n =30, 70 and 150 MPa, while velocity neutral behavior is observed at σ n =15 MPa and velocity strengthening is observed at σ n =5 MPa. The greater velocity weakening observed at velocities below 10 −2 µm/s may suggest a transition in competing deformation mechanisms, or the influence of additional mechanisms. The transition to velocity strengthening at high velocity and low normal stress implies that rapid slip on shallow faults could be arrested before resulting in true stick-slip behavior. Stable fault creep and creep events observed at shallow levels on some natural faults may result from this transition in velocity dependence.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Brian D. Kilgore, Michael L. Blanpied, James H. Dieterich. 2012-12-07. Velocity dependent friction of granite over a wide range of conditions. https://doi.org/10.1029/93gl00368

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Evolution of summit magma pressure during the 2018 caldera collapse at Kılauea volcano

We utilized geodetic data from the 16 May to 4 August 2018 caldera collapse sequence to refine the geometries and pressure evolution of two summit reservoirs at Kīlauea volcano: the shallower Halema‘uma‘u (HMM) and deeper South Caldera (SC) reservoirs. We modeled magma reservoirs as pressurized spheroidal cavities and constrained reservoir geometries with Global Positioning System (GPS) and Interferometric Synthetic Aperture Radar displacements. Inverting high-rate GPS and borehole tilt time series recovered time-dependent reservoir pressure changes and caldera ring fault shear stress. During the collapse sequence, the HMM reservoir accommodated episodic, co-collapse pressure increases of 1.9 MPa (median) and a net 5.8 MPa (median) decrease. Simultaneously, the SC reservoir underwent monotonic depressurization of 6.7 MPa (median). Negligible co-collapse pressure changes in the SC reservoir imply it was not exclusively supplying magma to the eruption vent. These results provide a coherent view of magma reservoir pressure evolution during the 2018 eruption.

Hawaii↗

EMIT reveals elevated calcite signatures in shorelines of Lake Powell and Lake Mead exposed by drought and Colorado River management

Nearly half of Earth’s seasonal freshwater storage variability occurs in human-managed reservoirs, resulting in large areas of reservoir-bed that are episodically inundated or subaerially exposed. Here we use hyperspectral data from NASA’s Earth Surface Mineral Dust Source Investigation (EMIT) mission to map calcite mineral assemblages across exposed surfaces in two large U.S. reservoirs, Lake Mead and Lake Powell. Results show distinct patterns in the occurrence of carbonate, clay, and mica minerals. Reservoir-deposited sediments exhibited significantly higher calcite proportions than adjacent, lithologically similar, non-inundated terrestrial surfaces. These differences likely reflect hydrologically-driven calcite precipitation, wherein warm, clear, productive reservoir waters drive calcium carbonate out of solution. We also detect reductions in calcite proportions in areas of the shoreline disturbed by human recreation. EMIT's imaging capabilities enable rapid, high-resolution mineralogical inventories across vast areas where field sampling is infeasible. We find EMIT is a scalable tool for monitoring geochemical changes associated with large water level fluctuations.

Arizona, Nevada, Utah↗

First application of a coastal-dune model (AeoLiS) to simulate fluvial-aeolian morphodynamics

Quantifying aeolian processes is important to decision-making in river management and for optimizing strategies for ecosystem conservation, natural resource management, and recreation. We applied the AeoLiS aeolian transport model, originally developed for coastal environments, to a dryland river corridor to evaluate its ability to simulate sediment dynamics in a fluvial-aeolian system. The model reproduced spatial and temporal patterns of geomorphic change at a Grand Canyon sandbar, including aeolian dune formation, observed in field data. The model effectively captured trends in observed sediment movement in the spring and summer months. Thus, despite assuming a single grain-size, static vegetation, and not directly accounting for variable sediment supply from fluvial sources, the model performs well at capturing aeolian processes in a complex fluvial-aeolian system. AeoLiS demonstrates strong potential for dryland river applications and management, due to its flexibility and compatibility with coupled modeling frameworks.

Arizona↗