USGS Science⌕ Search

USGS · 70185637

Monitoring regional effects of high pressure injection of wastewater in a limestone aquifer

Abstract

More than 10 billion gallons (38 × 10 6 m 3 ) of acid industrial liquid waste has been injected in about 11 years under high pressure into a saline-water-filled part of a limestone aquifer of low transmissivity between 1,400 and 1,700 feet (430 and 520 m) below land surface near Pensacola, Florida. A similar waste disposal system is planned for the same zone at a site about 8.5 miles (13.7 km) to the east. The injection zone is the lower limestone of the Floridan aquifer. The lower limestone is overlain by a confining layer of plastic clay about 220 feet (67 m) thick at the active injection site and underlain by another confining layer of shale and clay. The upper confining layer is overlain by the upper limestone of the Floridan aquifer. The active injection system consists of two injection wells about a quarter of a mile (0.4 km) apart and three monitor wells. Two of the monitor wells (deep monitors) are used to observe hydraulic and geochemical effects of waste injection in the injection zone at locations about 1.5 miles (2.4 km) south and 1.9 miles (3.1 km) north of the center of the injection site. The third well (shallow monitor), used to observe any effects in the upper limestone, is about 100 feet (30 m) from one of the injection wells. Since 1972 the injection zone has also been monitored at a test well at the planned new injection site. Three more monitor wells in the injection zone were activated in early 1974 at sites 17 miles (27 km) northeast, 22 miles (35 km) east and 33 miles (53 km) northeast of the injection site. The six deep monitors provide a system for evaluating the regional effects of injecting wastes. No change in pressure or water quality due to injection was, by mid-1974, evident in the upper limestone at the injection site, but static pressures in the lower limestone at the site had increased 8 fold since injection began in 1963. Chemical analyses indicated probable arrival of the diluted waste at the south monitor well in 1973. By mid-1974 waste evidently had not reached the north monitor well. Calculations indicate that by mid-1974 pressure effects from waste injection extended radially more than 40 miles (64 km) from the injection site. By mid-1974 pressure effects of injection were evident from water-level measurements made at the five deep monitor wells nearest the active injection site. No effects were recognized at the well 33 miles (53 km) away. Less than 20 miles (32 km) northeast of the active injection site, the lower limestone contains fresh water. Changes in the pressure regime due to injection indicate a tendency for northeastward movement of the fresh-water/salt-water interface in the lower limestone.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Glen L. Faulkner, Charles A. Pascale. 2006-07-06. Monitoring regional effects of high pressure injection of wastewater in a limestone aquifer. https://doi.org/10.1111/j.1745-6584.1975.tb03077.x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Computing flow-field distortion coefficients from well-construction and formation properties

Direct measurements of groundwater velocity made with borehole flowmeters in screened wells must be compensated for the effects of flow-field distortion (also known as borehole acceleration). A theoretical equation developed by Drost et al. (1968) and simple inputs describing hydraulic properties of well construction and geologic formation were programmed into an Excel workbook to facilitate computation by groundwater-flowmeter users. Tables describing the physical and hydraulic properties for well constructions and gravel pack media are provided with an example to facilitate use of the workbook. Groundwater flowlines converge or diverge as they pass from a geologic formation, through a gravel pack and well screen. The extent of flowline convergence or divergence and the value of the flow-field distortion coefficient is related to the relative changes in hydraulic conductivity of the well screen, gravel pack, and geologic formation. Convergence or divergence is accompanied by acceleration or deceleration of groundwater. Direct measurements of groundwater velocity at the center of the monitoring well can be adjusted to provide a more accurate estimate of velocity in the formation by applying a correction for flow-field distortion. Variables required to compute the flow-field distortion coefficient include the hydraulic conductivity of the gravel pack, well screen, and the geologic formation surrounding the well screen; the borehole radius, and the inside radius and outside radius of the well screen.

Groundwater↗

Predicting groundwater hydrochemical facies in three dimensions with random forest classification, USA

A random forest classification (RFC) model was developed to predict hydrochemical facies (HCFs) of groundwater in three dimensions across the conterminous United States (CONUS). Major-ion data from 152,673 sites were used to categorize groundwater into one of six HCFs (CaMg-HCO 3 , NaK-HCO 3 , CaMg-SO 4 , NaK-SO 4 , Cl, or Mixed). These six HCFs were used as targets for RFC modeling. Model features that represent relevant geochemical processes and/or physical conditions were derived from previously published data. Additional model features were specifically engineered to support this analysis: elevation of the bottom of a well relative to the base of drinking water (ERDW) and six flags that relate geologic units to HCFs. The most important model feature was ERDW. The model was used to map HCFs at a 1-km 2 resolution across CONUS and to depths of 400 m below the base of drinking water (which varies from 22 m to 2 km). Model predictions are consistent with expectations. CaMg-HCO 3 is predicted to occur near the water table in more humid settings, and areas underlain by carbonate or crystalline rocks. At depths below the base of drinking-water supplies, the model predicts a rapid transition from HCO 3 HCFs to Cl. Model predictions are accurate based on point data, and data averaged across hydrogeologic regions and with depth. Model predictions of HCFs could be used for multiple purposes, including the mapping of salinity and other groundwater characteristics.

Groundwater↗