USGS ScienceSearch

USGS · 70182136

Catastrophic rockfalls and rockslides in the Sierra Nevada, USA

Abstract

Despite having a low recorded historical incidence of landsliding, the Sierra Nevada has undergone large prehistoric and historical rockfalls and rockslides that could be potentially catastrophic if they occurred today in the more densely populated parts of the region. Several large documented rockfall and rockslides have been triggered either by strong seismic shaking or long periods of unusually wet weather; however, in several instances no obvious triggering event can be identified. The glaciated topography of the higher elevations of the Sierra Nevada has produced many relatively small falls and slides within relatively hard, massively jointed, granitic rocks; however, where exposed to weathering for long periods after glaciation, the oversteepened rock slopes are prone to uncommonly large falls and slides. At lower elevations on the nonglaciated slopes of the Sierra Nevada, rockslides commonly occur within more weathered granitic rocks, where the strength of the rock mass is typically affected by joint weathering and alteration of the intact rock to saprolite. Historical large rockfalls and rockslides in the Sierra Nevada have created additional secondary natural hazards, including debris flows and floods from the breaching of landslide dams that can be as hazardous as the initial rockfalls and rockslides.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 34.97600151317588° to 40.069664523297774° latitude; -121.607666015625° to -115.697021484375° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Gerald F. Wieczorek. 2002-01-01. Catastrophic rockfalls and rockslides in the Sierra Nevada, USA. https://doi.org/10.1130/reg15-p165

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Shallow landslide hazard map of Seattle, Washington

Landslides, particularly debris flows, have long been a significant cause of damage and destruction to people and property in the Puget Sound region. Following the years of 1996 and 1997, the Federal Emergency Management Agency designated Seattle as a “Project Impact” city with the goal of encouraging the city to become more disaster resistant to landslides and other natural hazards. A major recommendation of the Project Impact council was that the city and the U.S. Geological Survey collaborate to produce a landslide hazard map. An exceptional data set archived by the city containing more than 100 yr of landslide data from severe storm events allowed comparison of actual landslide locations with those predicted by slope-stability modeling. We used an infinite-slope analysis, which models slope segments as rigid friction blocks, to estimate the susceptibility of slopes to debris flows, which are water-laden slurries that can form from shallow failures of soil and weathered bedrock and can travel at high velocities down steep slopes. Data used for the analysis consisted of a digital slope map derived from recent light detection and ranging (LiDAR) imagery of Seattle, recent digital geologic mapping of the city, and shear-strength test data for the geologic units found in the surrounding area. The combination of these data layers within a geographic information system (GIS) platform allowed us to create a shallow landslide hazard map for Seattle.

Washington

Assessing deep-seated landslide susceptibility using 3-D groundwater and slope-stability analyses, southwestern Seattle, Washington

In Seattle, Washington, deep-seated landslides on bluffs along Puget Sound have historically caused extensive damage to land and structures. These large failures are controlled by three-dimensional (3-D) variations in strength and pore-water pressures. We assess the slope stability of part of southwestern Seattle using a 3-D limit-equilibrium analysis coupled with a 3-D groundwater flow model. Our analyses use a high-resolution digital elevation model (DEM) combined with assignment of strength and hydraulic properties based on geologic units. The hydrogeology of the Seattle area consists of a layer of permeable glacial outwash sand that overlies less permeable glacial lacustrine silty clay. Using a 3-D groundwater model, MODFLOW-2000, we simulate a water table above the less permeable units and calibrate the model to observed conditions. The simulated pore-pressure distribution is then used in a 3-D slope-stability analysis, SCOOPS, to quantify the stability of the coastal bluffs. For wet winter conditions, our analyses predict that the least stable areas are steep hillslopes above Puget Sound, where pore pressures are elevated in the outwash sand. Groundwater flow converges in coastal reentrants, resulting in elevated pore pressures and destabilization of slopes. Regions predicted to be least stable include the areas in or adjacent to three mapped historically active deep-seated landslides. The results of our 3-D analyses differ significantly from a slope map or results from one-dimensional (1-D) analyses.

Washington

A prototype system for forecasting landslides in the Seattle, Washington, area

Empirical rainfall thresholds and related information form the basis of a prototype system for forecasting landslides in the Seattle area. The forecasts are tied to four alert levels, and a decision tree guides the use of thresholds to determine the appropriate level. From analysis of historical landslide data, we developed a formula for a cumulative rainfall threshold (CT), P 3 = 88.9 − 0.67 P 15 , defined by rainfall amounts in millimeters during consecutive 3 d (72 h) periods, P 3 , and the 15 d (360 h) period before P 3 , P 15 . The variable CT captures more than 90% of historical events of three or more landslides in 1 d and 3 d periods recorded from 1978 to 2003. However, the low probability of landslide occurrence on a day when the CT is exceeded at one or more rain gauges (8.4%) justifies a low-level of alert for possible landslide occurrence, but it does trigger more vigilant monitoring of rainfall and soil wetness. Exceedance of a rainfall intensity-duration threshold I = 82.73 D −1.13 , for intensity, I (mm/hr), and duration, D (hr), corresponds to a higher probability of landslide occurrence (30%) and forms the basis for issuing warnings of impending, widespread occurrence of landslides. Information about the area of exceedance and soil wetness can be used to increase the certainty of landslide forecasts (probabilities as great as 71%). Automated analysis of real-time rainfall and subsurface water data and digital quantitative precipitation forecasts are needed to fully implement a warning system based on the two thresholds.

Washington