Geology and ground-water resources of Cerro Gordo County, Iowa

H.G. Hershey; K.D. Wahl; W. L. Steinhilber

Home/Archive/USGS

USGS · 70174097

Geology and ground-water resources of Cerro Gordo County, Iowa

H.G. Hershey·K.D. Wahl·W. L. Steinhilber

View original source ↗Read source document ↗Export metadata ↓

Abstract

The basic geologic framework underlying Cerro Gordo County consists of an igneous or metamorphic Precambrian basement complex overlain by, in ascending order, consolidated sedimentary rocks of Precambrian, Cambrian, Ordovician, Devonian, Mississippian, and Cretaceous age, and unconsolidated sand, gravel, and clay of Quaternary age. Structurally the county is in the northern part of the Iowan Basin, and the sedimentary units of Cambrian through Devonian age dip southward at 9 to 14 feet per mile. Three major glacial advances, the Nebraskan, Kansan, and Wisconsin, covered all or part of the county during the Pleistocene Epoch and left behind glacial drift consisting of 0 to 125 feet of till and related outwash deposits. De posits of Holocene age, aside from surficial soil, are thin and scattered. Ground water occurs in the sedimentary units of Cambrian through Mississippian age and in the glacial drift and outwash deposits of Quaternary age. The chief aquifers, in ascending order, are the deep Cambrian sandstones, Jordan aquifer, St. Peter Sandstone, Devonian and Mississippian limestones and dolomites, and the Pleistocene glacial drift and related interglacial deposits. Units between the St. Peter Sandstone and the Devonian limestones, the Platteville, Decorah, Galena, and Maquoketa Formations, are of low permeability and are considered to be an aquiclude in comparison to the overlying and under lying units. The deep Cambrian sandstones will yield about 60 gpm (gallons per minute) to an individual well; the Jordan aquifer about 1,200 gpm; the St. Peter Sandstone 30 to 200 gpm; the Devonian limestones and dolomites 120 to 200 gpm; and the glacial outwash or shallow bedrock generally will yield 10 gpm or more. The Jordan aquifer supplies large quantities of water for municipal and industrial use at Mason City. Pumping tests on wells tapping the Jordan in that area show that the aquifer has a transmissibility of about 35,000 gallons per day per foot and a storage coefficient of 2 x 10 -4 Pumping in the Mason City area from 1912 to 1969 has produced about 200 feet of draw down in the areas of maximum withdrawal. Ground water in Cerro Gordo County is of suitable chemical quality for domestic, industrial, or municipal use. The total dis solved solids ranges from 152 mg/l (milligrams per liter) in water from the shallow bedrock to 885 mg/l in water from the deep Cambrian sandstones. Water from the Jordan, which is the most productive aquifer in the county, generally contains less than 500 mg/l dissolved solids. Ground water is the major source of water supplies throughout Cerro Gordo County. The majority of wells in the county are used for domestic and stock supplies, but the largest withdrawals of water are for municipal and industrial supplies. Municipal pumpage in the county in 1968 was about 1.5 billion gallons; industrial pumpage was about 1.8 billion gallons and most of the water was obtained from the Jordan aquifer. If future development of water from the Jordan aquifer is to be to the best economical advantage, careful consideration should be given to the location, capacity, and pumping schedules of proposed wells and nearby existing wells so that local overdevelopment or excessive interference do not occur.

Explore related subjects

Water Supply Bulletin Report

Source-reported bounding extent: 42.9071° to 43.2576° latitude; -93.4989° to -93.0241° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

H.G. Hershey, K.D. Wahl, W. L. Steinhilber. 1970. Geology and ground-water resources of Cerro Gordo County, Iowa. https://pubs.usgs.gov/publication/70174097

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS1986

Hydrology of carbonate aquifers in southwestern Linn County and adjacent parts of Benton, Iowa, and Johnson Counties, Iowa

Groundwater is the major source of water in Linn County and the surrounding area. Approximately 90 percent of the groundwater production is from Silurian, Devonian, and Quaternary aquifers. The Silurian and Devonian aquifers consist of limestone and dolomite with minor shale beds, which have a regional dip to the southwest of approximately 20 feet per mile. The Silurian aquifer in east-central Iowa is confined from below by Upper Ordovician, Maquoketa Formation shales, and from above by the Kenwood Member of the Wapsipinicon Formation and the Otis and Bertram formations. The Quaternary aquifer consists of unconsolidated sand and gravel beds in the glacial drift, and in the alluvium which is associated with modern streams. The alluvium consists of lenticular beds of poorly-to well-sorted silt, sand, and gravel. The sand and gravel beds are interlayered with relatively-impermeable beds of till, silt, and clay. Water moves through the Silurian aquifer in part due to a complex distribution of porous and dense carbonate facies. Horizons containing skeletal molds in the Silurian dolomite have porosities as much as 39 percent, and are laterally equivalent to dolomites with porosities as little as less than one percent. Because of subsequent fracturing and solutional enlargement of these porous horizons, hydrologic correlation of the primary water-yielding zones is not always possible. One horizon, however, does occur approximately 70 to 105 feet above the base of the Silurian, and is the most consistently productive water-yielding unit in the area. This horizon is Informally referred to as the Farmers Creek aquifer. The potentiometric surface of the Silurian aquifer has a gradient towards the Cedar River, indicating discharge from the aquifer through the alluvium into the river. By comparison, the potentiometric surface of the overlying Devonian aquifer is equal to that of the Silurian and may range to more than 40 feet higher. Yields to individual wells completed in the Silurian and Devonian carbonate aquifers vary from less than 10 to about 500 gallons per minute. Individual wells completed in the Quaternary aquifer yield as much as 2,000 gallons per minute. Water analyses from the Devonian and Silurian aquifers indicate that they are of similar chemical quality at most locations in the study area. However, they may commonly contain concentrations of sulfate that exceed 1,000 mil grams per liter. Dissolved-solids concentrations as much as 2,350 milligrams per liter occur in the Silurian aquifer in the western and southwestern part of the study area. Water from the Quaternary aquifer generally is suitable for most uses and dissolved-solids concentrations generally are less than 750 milligrams per liter.

Iowa↗

USGS1982

Hydrology of the surficial aquifer in the Floyd River Basin, Iowa

The Floyd River basin was studied to provide water-resources Information for a typical surficial aquifer in northwest Iowa. Data collection included test drilling, water-level measurements, and chemical analyses of surface and ground water. The Floyd River basin drains 961 square miles of highly dissected to gently rolling topography. Major streams generally are flanked by flood plains underlain by uncemented sand and-gravel deposits. Most of the basin is directly underlain by glacial drift of Pleistocene age which is In turn underlain by rocks of Cretaceous age. Sand-and-gravel deposits underlying the major flood plains and in buried bedrock channels within the drift comprise the surficial aquifer. The surficial aquifer ranges from 10 to 40 feet In thickness and averages about 20 feet thick. Both unconfined and confined conditions occur in the aquifer and water levels range from 2 to 55 feet below land surface. An aquifer test conducted in the surficial aquifer where it is about 25 feet thick and is confined by an overlying low permeability bed Indicated an average hydraulic conductivity of 383 feet per day and a storage coefficient of 0.0001. The well was pumped at 650 gallons per minute for 43 hours. An observation well about 70 feet from the pumping well had a maximum drawdown of about 10 feet.

Iowa↗

USGS1977

Geohydrology of Muscatine Island, Muscatine County, Iowa

Muscatine Island is a wide segment of the west bank of the Mississippi River flood plain that covers about 50 square miles in Muscatine and Louisa Counties; the project area encompasses the 30 square miles in Muscatine County. The flood plain is underlain by thick, permeable alluvial deposits that comprise a water-table aquifer that is developed extensively for water supplies in the area. The aquifer consists principally of sand and gravel, interbedded with lenses of silt and clay. Its saturated thickness ranges from about 40 to 140 feet. The transmissivity and storage coefficients of the aquifer range from about 20,000 ft. 2 /day and 0.15. respectively, in the western part of the Island to about 39,500 ft.2/day and 0.24 in the eastern part. The amount of water stored in the aquifer, under normal conditions, is about 100 billion gallons. Discharge from the aquifer is principally by pumpage, which has increased from about 1 mgd (million gallons per day) in 1906 to about 37 mgd in 1970. About 2.5 mgd is normally lost to seepage and evapotranspiration along a 9-mile reach of Muscatine Slough in Muscatine County. About 0.9 mgd is discharged by evaporation from gravel pits. Recharge to the aquifer is by induced infiltration from the Mississippi River, seepage from the river during major flood events, precipitation, and seepage from the underlying limestone bedrock. Induced infiltration provides about 80 to 85 percent of the water withdrawn from the principal pumping centers along the river and also replaces about 70 to 80 percent of the water that is evaporated from the gravel pits; this amounted to about 30 mgd in 1971. Additional significant recharge from the river occurs during major floods, when prolonged high stages provide the head for considerable underflow to the aquifer. Recharge from precipitation on the Island was calculated to average about 6inches per year or about 0.3 mgd per square mile. Seepage from bedrock is significant and is attributed to the increased head differential between the alluvial and bedrock aquifers in the areas of major pumping. The chemical constituents of water from the aquifer are generally within the recommended limits established by the U. S. Public Health Service for drinking water. Stresses on the hydrologic system have affected the position and configuration of the water table and the chemical quality of the ground water. The large-scale withdrawals, which began at the principal pumping centers in 1946, have caused the water table to decline from about 1 foot in the interior of the Island to about 5 feet near the edges of the main pumping centers; the decline was more than 8 feet under the pumping centers. A slight increase in hardness of water from riverward wells in the pumping centers is attributed to the induced infiltration of slightly harder river water; a noticeable increase in hardness and iron content in water from landward wells is attributed to seepage of water from the bedrock. In the central irrigated area, which is underlain by very permeable, highly drained soils that are mulched with organic fertilizers, the nitrate content of the ground water is as high as 46 mg/l (milligrams per liter). Land-use practices have had, and probably will continue to have, an impact on the quality and quantity of water available in the system. The hydrologic system in 1971 was in dynamic equilibrium or in near-equilibrium with the stresses imposed on it to that date. This equilibrium would be disturbed by any additional stresses on the system and water levels would change until a new equilibrium was established. The effects of future stresses can be reasonably predicted by developing a digital model of the system. The data to develop such a model are available in this report. Continued and expanded monitoring of water levels would provide data for better model verification. Periodic monitoring of nitrate and other chemical constituents would permit early detection of changes in concentration before the concentrations reached excessive levels.

Iowa↗