USGS ScienceSearch

USGS · 70099986

Glacial and Quaternary geology of the northern Yellowstone area, Montana and Wyoming

Abstract

This field guide focuses on the glacial geology and paleoecology beginning in the Paradise Valley and progressing southward into northern Yellowstone National Park. During the last (Pinedale) glaciation, the northern Yellowstone outlet glacier flowed out of Yellowstone Park and down the Yellowstone River Valley into the Paradise Valley. The field trip will traverse the following Pinedale glacial sequence: (1) deposition of the Eightmile terminal moraines and outwash 16.5 ± 1.4 10Be ka in the Paradise Valley; (2) glacial recession of ~8 km and deposition of the Chico moraines and outwash 16.1 ± 1.7 10Be ka; (3) glacial recession of 45 km to near the northern Yellowstone boundary and moraine deposition during the Deckard Flats readjustment 14.2 ± 1.2 10Be ka; and (4) glacial recession of ~37 km and deposition of the Junction Butte moraines 15.2 ± 1.3 10Be ka (this age is a little too old based on the stratigraphic sequence). Yellowstone's northern range of sagebrush-grasslands and bison, elk, wolf, and bear inhabitants is founded on glacial moraines, sub-glacial till, and outwash deposited during the last glaciation. Floods released from glacially dammed lakes and a landslide-dammed lake punctuate this record. The glacial geologic reconstruction was evaluated by calculation of basal shear stress, and yielded the following values for flow pattern in plan view: strongly converging—1.21 ± 0.12 bars (n = 15); nearly uniform—1.04 ± 0.16 bars (n = 11); and strongly diverging—0.84 ± 0.14 bars (n = 16). Reconstructed mass balance yielded accumulation and ablation each of ~3 km3/yr, with glacial movement near the equilibrium line altitude dominated by basal sliding. Pollen and charcoal records from three lakes in northern Yellowstone provide information on the postglacial vegetation and fire history. Following glacial retreat, sparsely vegetated landscapes were colonized first by spruce parkland and then by closed subalpine forests. Regional fire activity increased significantly with the development of closed subalpine forests as a result of increased fuel biomass and warmer summers. Warm dry conditions prevailed at low elevations during the early Holocene, as indicated by the presence of steppe and open mixed conifer forest. At the same time, closed subalpine forests with low fire frequency were present at higher elevations, suggesting relatively wet summer conditions. Douglas fir populations expanded throughout northern Yellowstone in the middle Holocene as a result of effectively drier conditions than before, and a decline of mesophytic plant taxa during the late Holocene imply continued drying, even though fire frequency decreased in recent millennia.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 45° to 45.5° latitude; -111° to -110° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Kenneth L. Pierce, Joseph M. Licciardi, Teresa R. Krause, Cathy Whitlock. 2014. Glacial and Quaternary geology of the northern Yellowstone area, Montana and Wyoming. https://doi.org/10.1130/2014.0037(09)

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Geologic controls on cave development in Burnsville Cove, Bath and Highland Counties, Virginia

Burnsville Cove in Bath and Highland Counties (Virginia, USA) is a karst region in the Valley and Ridge Province of the Appalachian Mountains. The region contains many caves in Silurian to Devonian limestone, and is well suited for examining geologic controls on cave location and cave passage morphology. In Burnsville Cove, many caves are located preferentially near the axes of synclines and anticlines. For example, Butler Cave is an elongate cave where the trunk channel follows the axis of Sinking Creek syncline and most of the side passages follow joints at right angles to the syncline axis. In contrast, the Water Sinks Subway Cave, Owl Cave, and Helictite Cave have abundant maze patterns, and are located near the axis of Chestnut Ridge anticline. The maze patterns may be related to fact that the anticline axis is the site of the greatest amount of flexure, leading to more joints and (or) greater enlargement of joints. Many of the larger caves of Burnsville Cove (e.g., Breathing Cave, Butler Cave–Sinking Creek Cave System, lower parts of the Water Sinks Cave System) are developed in the Silurian Tonoloway Limestone, the stratigraphic unit with the greatest surface exposure in the area. Other caves are developed in the Silurian to Devonian Keyser Limestone of the Helderberg Group (e.g., Owl Cave, upper parts of the Water Sinks Cave System) and in the Devonian Shriver Chert and (or) Licking Creek Limestone of the Helderberg Group (e.g., Helictite Cave). Within the Tonoloway Limestone, the larger caves are developed in the lower member of the Tonoloway Limestone immediately below a bed of silica-cemented sandstone. In contrast, the larger caves in the Keyser Limestone are located preferentially in limestone beds containing stromatoporoid reefs, and some of the larger caves in the Licking Creek Limestone are located in beds of cherty limestone below the Devonian Oriskany Sandstone. Geologic controls on cave passage morphology include joints, bedding planes, and folds. The influence of joints results in tall and narrow cave passages, whereas the influence of bedding planes results in cave passages with flat ceilings and (or) floors. The influence of folds is less common, but a few cave passages follow fold axes and have distinctive arched ceilings.

Virginia

Geology and geologic history of the Moscow-Pullman basin, Idaho and Washington, from late Grande Ronde to late Saddle Mountains time

The Moscow-Pullman basin, located on the eastern margin of the Columbia River flood basalt province, consists of a subsurface mosaic of interlayered Miocene sediments and lava flows of the Imnaha, Grande Ronde, Wanapum, and Saddle Mountains Basalts of the Columbia River Basalt Group. This sequence is ~1800 ft (550 m) thick in the east around Moscow, Idaho, and exceeds 2300 ft (700 m) in the west at Pullman, Washington. Most flows entered from the west into a topographic low, partially surrounded by steep mountainous terrain. These flows caused a rapid rise in base level and deposition of immature sediments. This field guide focuses on the upper Grande Ronde Basalt, Wanapum Basalt, and sediments of the Latah Formation. Late Grande Ronde flows terminated midway into the basin to begin the formation of a topographic high that now separates a thick sediment wedge of the Vantage Member to the east of the high from a thin layer to the west. Disrupted by lava flows, streams were pushed from a west-flowing direction to a north-northwest orientation and drained the basin through a gap between steptoes toward Palouse, Washington. Emplacement of the Roza flow of the Wanapum Basalt against the western side of the topographic high was instrumental in this process, plugging west-flowing drainages and increasing deposition of Vantage sediments east of the high. The overlying basalt of Lolo covered both the Roza flow and Vantage sediments, blocking all drainages, and was in turn covered by sediments interlayered with local Saddle Mountains Basalt flows. Reestablishment of west-flowing drainages has been slow. The uppermost Grande Ronde, the Vantage, and the Wanapum contain what is known as the upper aquifer. The water supply is controlled, in part, by thickness, composition, and distribution of the Vantage sediments. A buried channel of the Vantage likely connects the upper aquifer to Palouse, Washington, outside the basin. This field guide locates outcrops; relates them to stratigraphic well data; outlines paleogeographic basin evolution from late Grande Ronde to the present time; and notes structures, basin margin differences, and features that influence upper aquifer water supply.

Idaho, Nevada, Oregon, Washington

Geology and geomorphology of the Carolina Sandhills, Chesterfield County, South Carolina

This two-day field trip focuses on the geology and geomorphology of the Carolina Sandhills in Chesterfield County, South Carolina. This area is located in the updip portion of the U.S. Atlantic Coastal Plain province, supports an ecosystem of longleaf pine ( Pinus palustris ) and wiregrass ( Aristida stricta ), and contains three major geologic map units: (1) An ~60–120-m-thick unit of weakly consolidated sand, sandstone, mud, and gravel is mapped as the Upper Cretaceous Middendorf Formation and is interpreted as a fluvial deposit. This unit is capped by an unconformity, and displays reticulate mottling, plinthite, and other paleosol features at the unconformity. The Middendorf Formation is the largest aquifer in South Carolina. (2) A 0.3–10-m-thick unit of unconsolidated sand is mapped as the Quaternary Pinehurst Formation and is interpreted as deposits of eolian sand sheets and dunes derived via remobilization of sand from the underlying Cretaceous strata. This unit displays argillic horizons and abundant evidence of bioturbation by vegetation. (3) A <3-m-thick unit of sand, pebbly sand, sandy mud, and mud is mapped as Quaternary terrace deposits adjacent to modern drainages. In addition to the geologic units listed above, a prominent geomorphologic feature in the study area is a north-trending escarpment (incised by headwater streams) that forms a markedly asymmetric drainage divide. This drainage divide, as well as the Quaternary terraces deposits, are interpreted as evidence of landscape disequilibrium (possibly geomorphic responses to Quaternary climate changes).

South Carolina