USGS ScienceSearch

USGS · 70029416

Constraints on fault slip rates of the southern California plate boundary from GPS velocity and stress inversions

Abstract

We use Global Positioning System (GPS) velocities and stress orientations inferred from seismicity to invert for the distribution of slip on faults in the southern California plate-boundary region. Of particular interest is how long-term slip rates are partitioned between the Indio segment of the San Andreas fault (SAF), the San Jacinto fault (SJF) and the San Bernardino segment of the SAE We use two new sets of constraints to address this problem. The first is geodetic velocities from the Southern California Earthquake Center's (SCEC) Crustal Motion Map (version 3 by Shen et al.), which includes significantly more data than previous models. The second is a regional model of stress-field orientations at seismogenic depths, as determined from earthquake focal mechanisms. While GPS data have been used in similar studies before, this is the first application of stress-field observations to this problem. We construct a simplified model of the southern California fault system, and estimate the interseismic surface velocities using a backslip approach with purely elastic strain accumulation, following Meade et al. In addition, we model the stress orientations at seismogenic depths, assuming that crustal stress results from the loading of active faults. The geodetically derived stressing rates are found to be aligned with the stress orientations from seismicity. We therefore proceed to invert simultaneously GPS and stress observations for slip rates of the faults in our network. We find that the regional patterns of crustal deformation as imaged by both data sets can be explained by our model, and that joint inversions lead to better constrained slip rates. In our preferred model, the SJF accommodates ???15 mm yr-1 and the Indio segment of the SAF ???23 mm yr-1 of right-lateral motion, accompanied by a low slip rate on the San Bernardino segment of the SAF 'Anomalous' fault segments such as around the 1992 Mw = 7.3 Landers surface rupture can be detected. There, observed stresses deviate strongly from the long-term loading as predicted by our simple model. Evaluation of model misfits together with information from palaeoseismology may provide further insights into the time dependence of strain accumulation along the San Andreas system. ?? 2004 RAS.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

T.W. Becker, J.L. Hardebeck, G. Anderson. 2005. Constraints on fault slip rates of the southern California plate boundary from GPS velocity and stress inversions. https://doi.org/10.1111/j.1365-246x.2004.02528.x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Surface-wave relocation and characterization of the 2024–2025 dyking episode along the Fentale–Dofen segment of the Ethiopian rift

From late-December 2024 to mid-March 2025, a 50-km-long dyke intrusion triggered over 300 earthquakes (magnitude 4 to 5.9) between Fentale and Dofen volcanoes along the Northern Main Ethiopian Rift. Dyke intrusions periodically occur along the Fentale–Dofen magmatic segment and are an expression of ongoing rift extension. Preliminary analyses using interferometric synthetic aperture radar revealed extensive ground deformation (up to 60 cm), which closely matched the temporal and spatial evolution of surface manifestations and earthquake locations from global catalogues. While global catalogues are critical for real-time monitoring, the precision of locations in remote and or sparsely instrumented regions can be low. In this investigation, we present surface-wave relocation results of the dyking episode that began near Fentale volcano in December 2024. We estimate relative locations using differential traveltimes measured from regional-to-teleseismic distance surface-wave observations of earthquakes reported by the U.S. Geological Survey. Relative relocations reduce the initial region of diffuse seismicity to a 50-km-long narrow band bounding the strike of surface manifestations and the zone of maximum surface deformation. We demonstrate the precision of surface-wave relocations over incremental time periods, capturing the progression of dyking from seismic onset through seismic migration and caldera subsidence. Results showcase the utility of surface-wave relocations in the characterization of dyking episodes and provide complementary insights into the current understanding of the Fentale–Dofen volcanic plumbing system.

Geophysical Journal International

Subsurface structure across the Tacoma Basin, Washington State, using trans-dimensional Bayesian inversion of fundamental mode spatial autocorrelation data

Spatial autocorrelation (SPAC), the azimuthal average of the normalized cross-correlation between equidistant station pairs deployed in a 2-D array, is widely used to image the subsurface structure. However, the rigorous estimate of subsurface structure and its uncertainties as a function of depth using SPAC data is challenging due to the nonlinear relation between the SPAC data and Earth structure as well as the trade-off between depth and velocity. Additionally, data noise is strongly correlated due to data processing (e.g. filtering, stacking from multiple time segments and azimuthal averaging). Most studies do not account for the correlated noise and fix the ratio of compressional-wave velocity ( V P ) to shear-wave velocity ( V s ) (i.e. V P / V s ratio) and the number of layers, both of which are typically unknown. To address these challenges, we develop a hierarchical trans-dimensional Bayesian inversion of fundamental mode of SPAC data that properly accounts for the correlated data noise, samples the V P / V s ratio and relaxes the number of layers (i.e. model parametrization) to be unknown in the inversion. We further examine the limitation of using only fundamental modes in the inversion. Our synthetic experiments show that the inversion recovers an incorrect model unless we sample the correlated noise and V P / V s ratio in the inversion. The inversion is then applied to SPAC data acquired at 19 sites across the Tacoma basin in Washington State to characterize the V s and the time-averaged V s over 30-m depth ( V s 30 ). Our results show that the V s 30 varies from ∼200 to 800 m s −1 . The V s 30 within the basin is higher in the middle and lower on the east and west sides. We find that these V s 30 values vary with geologic unit. The uncertainties for V s 30 are within 20 m s −1 in average except for the most eastern site TB28. Additionally, the uncertainties are greater for deeper depths beneath most of the sites as the sensitivity decreases as a function of depth. The Vs structure as a function of depth is also complex beneath some sites, possibly because the SPAC curves are affected by higher order Rayleigh modes that are not considered in the inversion. To better constrain the deeper V s structure, V s 30 and/or other average measures of V s over depth, additional constraints from complementary data, such as ellipticity or geologic data are needed. Moreover, our synthetic experiments show that higher order modes can have significant effect in the inversion results, particularly when there is a low-velocity layer.

Washington

Refinements to the attenuated propagation of local earthquake shaking (APPLES) ground-motion-based earthquake early warning algorithm

We refined the Attenuated ProPagation of Local Earthquake Shaking (APPLES) ground-motion-based earthquake early warning (EEW) approach, and directly compare APPLES performance with that of the source-characterization-based U.S. ShakeAlert EEW system for a suite of historical earthquakes in the U.S. West Coast and Japan. APPLES is an extension of the Propagation of Local Undamped Motion (PLUM) algorithm in which observed shaking intensity at seismic stations is used to forward-predict intensity distributions to surrounding areas using an attenuation model derived from an intensity prediction equation. We test new configuration options within APPLES, such as using the second highest estimated ground motion rather than the maximum, to better match median ground-motion observations and reduce alerts for small magnitude earthquakes, both of which are key alerting priorities within ShakeAlert. We evaluate these configurations alongside ShakeAlert by comparing the ground-motion estimation accuracy and available warning times relative to station observations and ShakeMap distributions. Our preferred APPLES configuration produces accurate ground-motion estimates and corresponds better with median observations compared to ShakeAlert’s estimates. This preferred configuration substantially reduces alert issuance for M < 5.0 earthquakes compared to the previous APPLES configuration, and alert-release criteria can further restrict alerts to primarily M ≥ 5.5 earthquakes without requiring magnitude estimation. Prioritizing matching median-observed ground motions may reduce APPLES warning times compared to configurations that were tuned to avoid missed alerts (such as those that use the maximum estimated ground motions), which can lead to shorter warning times compared to ShakeAlert for the same alert threshold. However, station-based warning time assessments demonstrate that APPLES can outperform ShakeAlert for high target thresholds. APPLES is a simple, independent EEW approach that may improve the robustness of EEW for the West Coast of the U.S.

California, Oregon, Washington