USGS Science⌕ Search
Home/Archive/USGS

USGS · 70028561

Coseismic and initial postseismic deformation from the 2004 Parkfield, California, earthquake, observed by global positioning system, electronic distance meter, creepmeters, and borehole strainmeters

J. Langbein·J.R. Murray·Hollice A. Snyder
View original source ↗Export metadata ↓

Abstract

Global Positioning System (GPS), electronic distance meter, creepmeter, and strainmeter measurements spanning the M 6.0 Parkfield, California, earthquake are examined. Using these data from 100 sec through 9 months following the main-shock, the Omori's law, with rate inversely related to time, l/t p and p ranging between 0.7 and 1.3, characterizes the time-dependent deformation during the post-seismic period; these results are consistent with creep models for elastic solids. With an accurate function of postseismic response, the coseismic displacements can be estimated from the high-rate, 1-min sampling GPS; and the coseismic displacements are approximately 75% of those estimated from the daily solutions. Consequently, fault-slip models using daily solutions overestimate coseismic slip. In addition, at 2 months and at 8 months following the mainshock, postseismic displacements are modeled as slip on the San Andreas fault with a lower bound on the moment exceeding that of the coseismic moment.

Explore related subjects

Bulletin of the Seismological Society of AmericaArticle

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

J. Langbein, J.R. Murray, Hollice A. Snyder. 2006. Coseismic and initial postseismic deformation from the 2004 Parkfield, California, earthquake, observed by global positioning system, electronic distance meter, creepmeters, and borehole strainmeters. https://doi.org/10.1785/0120050823

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Re-evaluation of shaking, dynamic strain, and the source of the 1886 Charleston, South Carolina, earthquake

As the largest historical event in the eastern United States, the 1886 Charleston, South Carolina, earthquake, plays a prominent role in our nation’s seismological and human history and an outsized role in our probabilistic ground‐motion hazard estimates, affecting building codes, insurance rates, and geophysical monitoring. Thus, constraining the characteristics of the 1886 earthquake source, as well as the nature of its shaking distribution and impacts to the extent possible, is essential. Given its vintage, however, societal, geological, and geophysical datasets are limited compared with those used in modern seismological analyses. Because of these limitations, some characteristics of the rupture model are fundamentally nonunique. Still, by re‐evaluating all available data, I can constrain several key aspects of this earthquake. I show that several interpretations in recent analyses are inconsistent regarding the inferred source; shaking; ground failure; and, particularly, railway impacts. Importantly, I have shown that although dynamic strain caused the ground failure that led to track deformation, without the intermediate liquefaction step, dynamic strain alone was unlikely to be the source of rail deformation, contrary to earlier studies. Had earlier pronouncements that dynamic strain is a real concern for bending railways held true, there would be serious ramifications for railway engineering as well as for other above‐ and below‐ground linear infrastructure.

South Carolina↗
USGS2026

ETAS-positive: Extracting unbiased epidemic-type aftershock models from incomplete earthquake catalogs

Earthquake catalogs are inherently incomplete, and short-term fluctuations in catalog completeness can strongly bias estimates of seismicity parameters. Here, we extend the positive statistics framework recently introduced for estimating Gutenberg–Richter a and b values to the Epidemic-Type Aftershock Sequence (ETAS) model. The approach focuses on complete magnitude–time intervals defined by pairs of earthquakes in which the second event is larger than the first. Comprehensive synthetic tests demonstrate that the proposed ETAS + method retrieves nearly unbiased parameter estimates even from highly incomplete catalogs, whereas parameters obtained using classical estimation approaches are strongly biased. Application to Southern California reveals a similar trend, with the productivity scaling parameter α approaching the b value, consistent with self-similar earthquake triggering within estimation uncertainties. Owing to its robustness against catalog incompleteness and computational efficiency, the ETAS + method provides a powerful new tool for seismicity analysis and earthquake forecasting.

California↗