USGS Science⌕ Search
Home/Archive/USGS

USGS · 70025689

Chemical analyses of pore water from boreholes USW SD-6 and USW WT-24, Yucca Mountain, Nevada

I.C. Yang·Z. E. Peterman·K.M. Scofield
View original source ↗Export metadata ↓

Abstract

Analyses of pore water extracted from cores of boreholes USW SD-6 in the central part and USW WT-24 in the northern part of Yucca Mountain, Nevada, show significant vertical and lateral variations in dissolved-ion concentrations. Analyses of samples of only a few milliliters of pore water extracted by uniaxial or triaxial compression and by ultracentrifugation methods from adjacent core samples are generally in agreement, within the analytical error of 10% to 15%. However, the values of silica for water obtained by ultracentrifugation are consistently lower than values for water obtained by compression. The larger concentrations probably are due to localized pressure solution of silicate minerals during compression. The shallower water from core in borehole USW SD-6 was extracted from nonwelded units collectively referred to as the Paintbrush Tuff nonwelded (PTn). The deeper water was from core in both boreholes USW SD-6 and USW WT-24 in the nonwelded units referred to as the Calico Hills nonwelded (CHn). Significant differences in mean dissolved-ion concentrations in pore water between the PTn and CHn are (1) decreases in Ca, Mg, SO4, and NO3 and (2) increases in HCO3 and (Na+K)/(Ca+Mg) ratios. The decrease in NO3 and the increase in HCO3 could be the result of denitrification through the oxidation of organic matter. The decrease in Ca and associated increase in (Na+K)/(Ca+Mg) is the result of ion exchange with zeolites in the CHn in borehole USW WT-24. This effect is not nearly as pronounced in borehole USW SD-6, probably reflecting a smaller amount of zeolitization of the CHn in USW SD-6. Geochemical calculations using the PHREEQC code indicate that the pore water from both boreholes USW SD-6 and USW WT-24 is uniformly undersaturated in anhydrite, gypsum, and amorphous silica, but supersaturated in quartz and chalcedony. The saturation of calcite, aragonite, sepiolite, and dolomite is more variable from sample to sample. ?? 2002 Elsevier Science B.V. All rights reserved.

Explore related subjects

Journal of Contaminant HydrologyArticle

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

I.C. Yang, Z. E. Peterman, K.M. Scofield. 2003. Chemical analyses of pore water from boreholes USW SD-6 and USW WT-24, Yucca Mountain, Nevada. https://doi.org/10.1016/s0169-7722(02)00160-2

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Distinguishing natural from mining-related metal sources by including streambank groundwater data in a stream mass loading study

Distinguishing stream metal loading caused by mine features from that caused by natural background sources remains challenging, yet this distinction is essential for making effective remedial decisions at many legacy mine sites. We combine a stream tracer injection and synoptic sampling study with data from shallow near-stream groundwater wells to estimate left-bank versus right-bank metal loading contributions at the 100-m spatial scale. The study was performed in the East Mancos River, a mountain headwater stream in Colorado, USA. The dominant source of elevated stream metal concentrations could be either groundwater infiltration through right-bank Doyle Mine waste piles or natural acid rock drainage from hydrothermally altered bedrock located mainly on the left bank. For the five metals of concern (Cu, Al, Zn, Cd, and Mn), we find that 15 % of the load contributed by diffuse groundwater inputs in the section potentially influenced by Doyle mine waste originates from the right bank. This right-bank potential mine contribution equates to only 3 % of the total watershed instream load for these metals. Furthermore, apparent 3 H/ 3 He groundwater ages in segments contributing most of the right-bank metal loading are sufficiently old (9–12 yr) to suggest that infiltration through the waste piles, located only 140–180 m from the stream, is unlikely. Estimated potential Doyle mine loading contributions can therefore be considered maximum values. Study results thus indicate that Doyle mine waste piles are a minor source of metal loading under low-flow conditions, and streambank groundwater data can provide valuable additional information in stream mass loading studies.

Colorado↗
USGS2025

Per- and polyfluoroalkyl substances (PFAS) mass flux and mass balance at an aqueous film-forming foam release site in semiarid eastern New Mexico, USA

Passive flux meters (PFMs) directly measure groundwater chemistry mass flux and Darcy flux, providing insight into contaminant source-zone architecture and transport properties. This study uses PFMs to characterize PFAS flux in groundwater at a semiarid site with a thick (greater than 90-m) unsaturated zone where groundwater has been contaminated with per - and polyfluoroalkyl substances (PFAS) related to the use of aqueous film-forming foam (AFFF) for fire training and fire suppression. PFAS mass discharge (PFAS mass flux integrated over a control plane) in groundwater downgradient from several PFAS release areas is calculated using PFM results. In groundwater downgradient from fire-training areas, total PFAS mass discharge (summed across 14 compounds) was estimated to be between 6.0 and 31 g per day in 2020 and between 5.9 and 23 g per day in 2021. Site-specific documentation, generic information on AFFF properties, and literature values of PFAS concentration in AFFF are used to estimate site-specific PFAS-application rates at fire-training areas. These PFAS-application rates are compared to groundwater PFAS-discharge rates. Results suggest that transformation processes (exact pathways unknown) have led to increased discharge of measured PFAS in groundwater relative to initial AFFF formulations. The mass balance approach has broad applicability as a high-level approach that can provide insight into PFAS transport at AFFF sites.

New Mexico↗
USGS2025

Concentration-discharge relations and transient metal loads reveal spatiotemporal variability in solute-generation mechanisms in a mine-affected watershed

Concentration-discharge (CQ) relations are commonly used to understand geochemical and hydrologic controls on the generation of solutes in watersheds. Despite the widespread application of CQ relations, this technique has been infrequently applied to acid mine drainage (AMD) sites, but the CQ framework may allow mechanistic understanding of remedial outcomes such as impoundment of water within underground mines. Results of CQ analyses and changes in metal loads in an AMD affected watershed in Colorado, USA indicate that dissolved loads increased at many individual locations following water impoundment within mine workings. Although increased loads were observed at most individual locations, these increases were offset by a large decrease in loading from the largest mine. A loading analysis that included data from an instream monitoring location showed a statistically significant decrease in Fe and Zn after bulkhead emplacement, indicating a net positive effect of bulkheads. Streams generally displayed dilution CQ patterns whereas mines and springs showed either flushing or chemostatic patterns prior to bulkheading, which transitioned to chemostatic patterns following bulkheading, indicating a transition from dynamic to equilibrium geochemical processes. Saturation indices for sulfide and secondary minerals indicated that mines and springs were near equilibrium for phases including schwertmannite, fluorite, and gypsum. Saturation indices vary through time for mines suggesting progressive leaching of sulfide minerals as the mass of available minerals in the mine workings decreases. Together, these diverse analyses provide an integrated understanding of the variability in solute generating processes in this watershed and may inform remediation plans for similarly affected sites by indicating the nature of mineralogic controls on water quality.

Colorado↗