USGS ScienceSearch

USGS · 70023956

Factors controlling navigation-channel Shoaling in Laguna Madre, Texas

Abstract

Shoaling in the Gulf Intracoastal Waterway of Laguna Madre, Tex., is caused primarily by recycling of dredged sediments. Sediment recycling, which is controlled by water depth and location with respect to the predominant wind-driven currents, is minimal where dredged material is placed on tidal flats that are either flooded infrequently or where the water is extremely shallow. In contrast, nearly all of the dredged material placed in open water >1.5 m deep is reworked and either transported back into the channel or dispersed into the surrounding lagoon. A sediment flux analysis incorporating geotechnical properties demonstrated that erosion and not postemplacement compaction caused most sediment losses from the placement areas. Comparing sediment properties in the placement areas and natural lagoon indicated that the remaining dredged material is mostly a residual of initial channel construction. Experimental containment designs (shallow subaqueous mound, submerged levee, and emergent levee) constructed in high-maintenance areas to reduce reworking did not retain large volumes of dredged material. The emergent levee provided the greatest retention potential approximately 2 years after construction.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R.A. Morton, R.C. Nava, M. Arhelger. 2001. Factors controlling navigation-channel Shoaling in Laguna Madre, Texas. https://doi.org/10.1061/(asce)0733-950x(2001)127%3A2(72)

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Process-based coastal erosion modeling for Drew Point (North Slope, Alaska)

A predictive, coastal erosion/shoreline change model has been developed for a small coastal segment near Drew Point, Beaufort Sea, Alaska. This coastal setting has experienced a dramatic increase in erosion since the early 2000’s. The bluffs at this site are 3-4 m tall and consist of ice-wedge bounded blocks of fine-grained sediments cemented by ice-rich permafrost and capped with a thin organic layer. The bluffs are typically fronted by a narrow ( ∼ 5 m wide) beach or none at all. During a storm surge, the sea contacts the base of the bluff and a niche is formed through thermal and mechanical erosion. The niche grows both vertically and laterally and eventually undermines the bluff, leading to block failure or collapse. The fallen block is then eroded both thermally and mechanically by waves and currents, which must occur before a new niche forming episode may begin. The erosion model explicitly accounts for and integrates a number of these processes including: (1) storm surge generation resulting from wind and atmospheric forcing, (2) erosional niche growth resulting from wave-induced turbulent heat transfer and sediment transport (using the Kobayashi niche erosion model), and (3) thermal and mechanical erosion of the fallen block. The model was calibrated with historic shoreline change data for one time period (1979-2002), and validated with a later time period (2002-2007).

Alaska

Building destruction from waves and surge on the bolivar peninsula during hurricane ike

The Bolivar Peninsula in Texas was severely impacted by Hurricane Ike with strong winds, large waves, widespread inundation, and severe damage. This paper examines the wave and surge climate on Bolivar during the storm and the consequent survival and destruction of buildings. Emphasis is placed on differences between buildings that survived (with varying degrees of damage) and buildings that were completely destroyed. Building elevations are found to be the primary indicator of survival for areas with large waves. Here, buildings that were sufficiently elevated above waves and surge suffered relatively little structural damage, while houses at lower elevations were impacted by large waves and generally completely destroyed. In many areas, the transition from destruction to survival was over a very small elevation range of around 0.5 m. In areas where waves were smaller, survival was possible at much lower elevations. Higher houses that were not inundated still survived, but well-built houses at lower elevations could also survive as the waves were not large enough to cause structural damage. However, the transition height where waves became damaging could not be determined from this study. ?? 2011 American Society of Civil Engineers.

Journal of Waterway, Port, Coastal and Ocean Engin

Estimation of contraction scour in riverbed using SERF

Contraction scour in a firm-clay estuarine riverbed is estimated at an oil-unloading terminal at the Port of Haldia in India, where a scour hole attained a maximum depth greater than 5 m relative to the original bottom. A linear equation for the erosion flux as a function of the excess bed shear stress was semicalibrated in a rotating-cylinder device called SERF (Simulator of Erosion Rate Function) and coupled to a hydrodynamic code to simulate the hole as a clear-water scour process. SERF, whose essential design is based on previous such devices, additionally included a load cell for in situ and rapid measurement of the eroded sediment mass. Based on SERF's performance and the degree of comparison between measured and simulated hole geometry, it appears that this device holds promise as a simple tool for prediction of scour in firm-clay beds. ?? ASCE.

Journal of Waterway, Port, Coastal and Ocean Engin