USGS Science⌕ Search

USGS · 70023599

Calcite crystal growth rate inhibition by polycarboxylic acids

Abstract

Calcite crystal growth rates measured in the presence of several polycarboxyclic acids show that tetrahydrofurantetracarboxylic acid (THFTCA) and cyclopentanetetracarboxylic acid (CPTCA) are effective growth rate inhibitors at low solution concentrations (0.01 to 1 mg/L). In contrast, linear polycarbocylic acids (citric acid and tricarballylic acid) had no inhibiting effect on calcite growth rates at concentrations up to 10 mg/L. Calcite crystal growth rate inhibition by cyclic polycarboxyclic acids appears to involve blockage of crystal growth sites on the mineral surface by several carboxylate groups. Growth morphology varied for growth in the absence and in the presence of both THFTCA and CPTCA. More effective growth rate reduction by CPTCA relative to THFTCA suggests that inhibitor carboxylate stereochemical orientation controls calcite surface interaction with carboxylate inhibitors. ?? 20O1 Academic Press.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

M.M. Reddy, A.R. Hoch. 2001. Calcite crystal growth rate inhibition by polycarboxylic acids. https://doi.org/10.1006/jcis.2000.7378

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Effects of sulfate ligand on uranyl carbonato surface species on ferrihydrite surfaces

Understanding uranium (U) sorption processes in permeable reactive barriers (PRB) are critical in modeling reactive transport for evaluating PRB performance at the Fry Canyon demonstration site in Utah, USA. To gain insight into the U sequestration mechanism in the amorphous ferric oxyhydroxide (AFO)-coated gravel PRB, U(VI) sorption processes on ferrihydrite surfaces were studied in 0.01 M Na 2 SO 4 solutions to simulate the major chemical composition of U-contaminatedgroundwater (i.e., [SO 4 2- ]~13 mM L -1 ) at the site. Uranyl sorption was greater at pH 7.5 than that at pH 4 in both air- and 2% pCO 2 -equilibrated systems. While there were negligible effects of sulfate ligands on the pH-dependent U(VI) sorption (<24 h) in both systems, X-ray absorption spectroscopy (XAS) analysis showed sulfate ligand associated U(VI) surface species at the ferrihydrite&ndash;water interface. In air-equilibrated systems, binary and mono-sulfate U(VI) ternary surface species co-existed at pH 5.43. At pH 6.55&ndash;7.83, a mixture of mono-sulfate and bis-carbonato U(VI) ternary surface species became more important. At 2% pCO 2 , there was no contribution of sulfate ligands on the U(VI) ternary surface species. Instead, a mixture of bis-carbonato inner-sphere (38%) and tris-carbonato outer-sphere U(VI) ternary surface species (62%) was found at pH 7.62. The study suggests that the competitive ligand (bicarbonate and sulfate) coordination on U(VI) surface species might be important in evaluating the U solid-state speciation in the AFO PRB at the study site where pCO 2 fluctuates between 1 and 2 pCO 2 %.

Journal of Colloid and Interface Science↗

EXAFS study of mercury(II) sorption to Fe- and Al-(hydr)oxides - II. Effects of chloride and sulfate

Common complexing ligands such as chloride and sulfate can significantly impact the sorption of Hg(II) to particle surfaces in aqueous environmental systems. To examine the effects of these ligands on Hg(II) sorption to mineral sorbents, macroscopic Hg(II) uptake measurements were conducted at pH 6 and [Hg]i=0.5 mM on goethite (??-FeOOH), ??-alumina (??-Al2O3), and bayerite (??-Al(OH)3) in the presence of chloride or sulfate, and the sorption products were characterized by extended X-ray absorption fine structure (EXAFS) spectroscopy. The presence of chloride resulted in reduced uptake of Hg(II) on all three substrates over the Cl- concentration ([Cl-]) range 10-5 to 10-2 M, lowering Hg surface coverages on goethite, ??-alumina, and bayerite from 0.42 to 0.07 ??mol/m2, 0.06 to 0.006 ??mol/m2, and 0.55 to 0.39 ??mol/m2 ([Cl -]=10-5 to 10-3 M only), respectively. This reduction in Hg(II) uptake is primarily a result of the formation of stable, nonsorbing aqueous HgCl2 complexes in solution, limiting the amount of free Hg(II) available to sorb. At higher [Cl-] beam reduction of Hg(II) to Hg(I) was observed, resulting in the possible formation of aqueous Hg2Cl2 species and the precipitation of calomel, Hg 2Cl2(s). The presence of sulfate caused enhanced Hg(II) uptake over the sulfate concentration ([SO42-]) range 10-5 to 0.9 M, increasing Hg surface coverages on goethite, ??-alumina, and bayerite from 0.39 to 0.45 ??mol/m2, 0.11 to 0.38 ??mol/m2, and 0.36 to 3.33 ??mol/m2, respectively. This effect is likely due to the direct sorption or accumulation of sulfate ions at the substrate interface, effectively reducing the positive surface charge that electrostatically inhibits Hg(II) sorption. Spectroscopic evidence for ternary surface complexation was observed in isolated cases, specifically in the Hg-goethite-sulfate system at high [SO42-] and in the Hg-goethite-chloride system. ?? 2003 Elsevier Inc. All rights reserved.

Journal of Colloid and Interface Science↗

Clay-catalyzed reactions of coagulant polymers during water chlorination

The influence of suspended clay/solid particles on organic-coagulant reactions during water chlorination was investigated by analyses of total product formation potential (TPFP) and disinfection by-product (DBP) distribution as a function of exchanged clay cation, coagulant organic polymer, and reaction time. Montmorillonite clays appeared to act as a catalytic center where the reaction between adsorbed polymer and disinfectant (chlorine) was mediated closely by the exchanged clay cation. The transition-metal cations in clays catalyzed more effectively than other cations the reactions between a coagulant polymer and chlorine, forming a large number of volatile DBPs. The relative catalytic effects of clays/solids followed the order Ti-Mont > Fe-Mont > Cu-Mont > Mn-Mont > Ca-Mont > Na-Mont > quartz > talc. The effects of coagulant polymers on TPFP follow the order nonionic polymer > anionic polymer > cationic polymer. The catalytic role of the clay cation was further confirmed by the observed inhibition in DBP formation when strong chelating agents (o-phenanthroline and ethylenediamine) were added to the clay suspension. Moreover, in the presence of clays, total DBPs increased appreciably when either the reaction time or the amount of the added clay or coagulant polymer increased. For volatile DBPs, the formation of halogenated methanes was usually time-dependent, with chloroform and dichloromethane showing the greatest dependence. ?? 2003 Elsevier Inc. All rights reserved.

Journal of Colloid and Interface Science↗