USGS ScienceSearch

USGS · 70022325

Kansas coal distribution, resources, and potential for coalbed methane

Abstract

100 ft (>30 m)] determined from 32 different coal beds. Strippable coal resources at a depth < 100 ft (<30 m) total 2.8 billion tons (2.6 billion MT), and this total is determined from 17 coals. Coal beds present in the Cherokee Group (Middle Pennsylvanian) represent most of these coal resource totals. Deep coal beds with the largest resource totals include the Bevier, Mineral, \"Aw\" (unnamed coal bed), Riverton, and Weir-Pittsburg coals, all within the Cherokee Group. Based on chemical analyses, coals in the southeastern part of the state are generally high volatile A bituminous, whereas coals in the east-central and northeastern part of the state are high-volatile B bituminous coals. The primary concern of coal beds in Kansas for deep mining or development of coalbed methane is the thin nature [<2 ft (0.6 m)] of most coal beds. Present production of coalbed methane is centered mainly in the southern Wilson/northern Montgomery County area of southeastern Kansas where methane is produced from the Mulky, Weir-Pittsburg, and Riverton coals."}" data-sheets-userformat="{"2":8403202,"4":[null,2,16777215],"11":4,"14":[null,2,0],"15":"Inconsolata, monospace, arial, sans, sans-serif","16":11,"26":400}" data-sheets-formula="=VLOOKUP(R[0]C[-5],Fixed!R2C[-6]:C[-4],3,false)">Kansas has large amounts of bituminous coal both at the surface and in the subsurface of eastern Kansas. Preliminary studies indicate at least 53 billion tons (48 billion MT) of deep coal [>100 ft (>30 m)] determined from 32 different coal beds. Strippable coal resources at a depth < 100 ft (<30 m) total 2.8 billion tons (2.6 billion MT), and this total is determined from 17 coals. Coal beds present in the Cherokee Group (Middle Pennsylvanian) represent most of these coal resource totals. Deep coal beds with the largest resource totals include the Bevier, Mineral, "Aw" (unnamed coal bed), Riverton, and Weir-Pittsburg coals, all within the Cherokee Group. Based on chemical analyses, coals in the southeastern part of the state are generally high volatile A bituminous, whereas coals in the east-central and northeastern part of the state are high-volatile B bituminous coals. The primary concern of coal beds in Kansas for deep mining or development of coalbed methane is the thin nature [<2 ft (0.6 m)] of most coal beds. Present production of coalbed methane is centered mainly in the southern Wilson/northern Montgomery County area of southeastern Kansas where methane is produced from the Mulky, Weir-Pittsburg, and Riverton coals.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

L. L. Brady. 2000. Kansas coal distribution, resources, and potential for coalbed methane. https://pubs.usgs.gov/publication/70022325

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

High-resolution seismic reflection to delineate shallow gas in Eastern Kansas

Unique amplitude characteristics of shallow gas sands within Pennsylvanian clastic-carbonate dominated sequences are discernible on high-resolution seismic reflection data in eastern Kansas. Upward grading sequences of sand into shale represent a potential gas reservoir with a low-impedence acoustic contrast at the base of the encasing layer. The gas sand and encasing shale, which define the gas reservoir studied here, are part of an erosional incised valley where about 30 m of carbonates and shale have been replaced by sandstone and shale confined to the incised valley. These consolidated geologic settings would normally possess high impedence gas sand reservoirs as defined by abrupt contacts between the gas sand and encasing shale. Based orr core and borehole logs, the gas sand studied here grades from sand into shale in a fashion analogous to that observed in classic low-impedance environments. Amplitude and phase characteristics of high-resolution seismic data across this approximately 400-m wide gas sand are indicative of a low-impedance reservoir. Shot gathers possess classic amplitude with offsett-dependent characteristics which are manifeted on the stacked section as "bright spots." Dominant Frequencies of around 120 Hz allow detection of several reflectors within the 30+ meters of sand/shale that make up this localized gas-rich incised valley fill. The gradational nature of the trapping mechanism observed in this gas reservoir would make detection with conventional seismic reflection methods unlikely.

The Compass: Earth Science Journal of Sigma Gamma

Carbonate-shelf depositional environments of the Ordovician Viola formation in South-Central Kansas

The Upper Ordovician Viola Formation, an important petroleum reservoir in the Midcontinent, is a carbonate unit present over much of the subsurface in Kansas. The Viola is composed of two fining-upward sedimentary packages that are separated from each other by a minor karstic surface representing a brief period of exposure. Each package represents a third-order sedimentary cycle and consists of an echinoderm-rich packstone overlain by a thicker lime mudstone. The echinoderm-rich packstone was deposited nearshore in agitated waters, but subsequently was bioturbated. The overlying lime mudstone was deposited in deeper, quiet waters, and locally contains storm-deposited carbonate sands. Subtle growth of the Central Kansas Arch and Pratt Anticline (structures transecting the depositional shelf) is indicated by packstones and grainstones being thicker over these arches, whereas finer grained lithologies dominate in basinal areas on the arch flanks. Structureless lime mudstones, probably intensely bioturbated, grade into laminated lime mudstones farther basinward.

The Compass: Earth Science Journal of Sigma Gamma

Assessing the Kansas water-level monitoring program: An example of the application of classical statistics to a geological problem

Geologists may feel that geological data are not amenable to statistical analysis, or at best require specialized approaches such as nonparametric statistics and geostatistics. However, there are many circumstances, particularly in systematic studies conducted for environmental or regulatory purposes, where traditional parametric statistical procedures can be beneficial. An example is the application of analysis of variance to data collected in an annual program of measuring groundwater levels in Kansas. Influences such as well conditions, operator effects, and use of the water can be assessed and wells that yield less reliable measurements can be identified. Such statistical studies have resulted in yearly improvements in the quality and reliability of the collected hydrologic data. Similar benefits may be achieved in other geological studies by the appropriate use of classical statistical tools.

The Compass: Earth Science Journal of Sigma Gamma