Late Neogene sedimentary facies and sequences in the Pannonian Basin, Hungary

E. Juhasz; L. Phillips; P. Muller; B. Ricketts; A. Toth-Makk; M. Lantos; L.O. Kovacs

doi:10.1144/gsl.sp.1999.156.01.16

Home/Archive/USGS

USGS · 70021655

Late Neogene sedimentary facies and sequences in the Pannonian Basin, Hungary

E. Juhasz·L. Phillips·P. Muller·B. Ricketts·A. Toth-Makk·M. Lantos·L.O. Kovacs

View original source ↗Export metadata ↓

Abstract

This paper is part of the special publication No.156, The Mediterranean basins: Tertiary extension within the Alpine Orogen. (eds B.Durand, L. Jolivet, F.Horvath and M.Seranne). Detailed sedimentological, facies and numerical cycle analysis, combined with magnetostratigraphy, have been made in a number of boreholes in the Pannonian Basin, in order to study the causes of relative water-level changes and the history of the basin subsidence. Subsidence and infilling of the Pannonian Basin, which was an isolated lake at that time occurred mainly during the Late Miocene and Pliocene. The subsidence history was remarkably different in the individual sub-basins: early thermal subsidence was interrupted in the southern part of the basin, while high sedimentation rate and continuous subsidence was detected in the northeastern sub-basin. Three regional unconformities were detected in the Late Neogene Pannonian Basin fill, which represent 0.5 and 7.5 Ma time spans corresponding to single and composite unconformities. Consequently two main sequences build up the Late Neogene Pannonian Basin fill: a Late Miocene and a Pliocene one. Within the Late Miocene sequence there are smaller sedimentary cycles most probably corresponding to climatically driven relative lake-level changes in the Milankovitch frequency band. Considering the periods, the estimated values for precession and eccentricity in this study (19 and 370 ka) are close to the usually cited ones. In the case of obliquity the calculated period (71 ka) slightly deviates from the generally accepted number. Based on the relative amplitudes of oscillations, precession (sixth order) and obliquity (fifth order) cycles had the most significant impact on the sedimentation. Eccentricity caused cycles (fourth order) are poorly detectable in the sediments. The longer term (third order) cycles had very slight influence on the sedimentation pattern. Progradation, recorded in the Late Miocene sequence, correlates poorly in time within the basin. The dominant controls of this process probably were changes of basin subsidence rate and the very high sedimentation rate. The slow, upward trend of silt and sand bed thickness as well as that of the grain size also reflects the local progradation.

Explore related subjects

Geological Society Special Publication Article

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

E. Juhasz, L. Phillips, P. Muller, B. Ricketts, A. Toth-Makk, M. Lantos, L.O. Kovacs. 1999-10-12. Late Neogene sedimentary facies and sequences in the Pannonian Basin, Hungary. https://doi.org/10.1144/gsl.sp.1999.156.01.16

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2018

Slope failure and mass transport processes along the Queen Charlotte Fault, southeastern Alaska

The Queen Charlotte Fault defines the Pacific–North America transform plate boundary in western Canada and southeastern Alaska for c. 900 km. The entire length of the fault is submerged along a continental margin dominated by Quaternary glacial processes, yet the geomorphology along the margin has never been systematically examined due to the absence of high-resolution seafloor mapping data. Hence the geological processes that influence the distribution, character and timing of mass transport events and their associated hazards remain poorly understood. Here we develop a classification of the first-order shape of the continental shelf, slope and rise to examine potential relationships between form and process dominance. We found that the margin can be split into six geomorphic groups that vary smoothly from north to south between two basic end-members. The northernmost group (west of Chichagof Island, Alaska) is characterized by concave-upwards slope profiles, gentle slope gradients (<6°) and relatively low along-strike variance, all features characteristic of sediment-dominated siliciclastic margins. Dendritic submarine canyon/channel networks and retrogressive failure complexes along relatively gentle slope gradients are observed throughout the region, suggesting that high rates of Quaternary sediment delivery and accumulation played a fundamental part in mass transport processes. Individual failures range in area from 0.02 to 70 km2 and display scarp heights between 10 and 250 m. Transpression along the Queen Charlotte Fault increases southwards and the slope physiography is thus progressively more influenced by regional-scale tectonic deformation. The southernmost group (west of Haida Gwaii, British Columbia) defines the tectonically dominated end-member: the continental slope is characterized by steep gradients (>20°) along the flanks of broad, margin-parallel ridges and valleys. Mass transport features in the tectonically dominated areas are mostly observed along steep escarpments and the larger slides (up to 10 km2) appear to be failures of consolidated material along the flanks of tectonic features. Overall, these observations highlight the role of first-order margin physiography on the distribution and type of submarine landslides expected to occur in particular morphological settings. The sediment-dominated end-member allows for the accumulation of under-consolidated Quaternary sediments and shows larger, more frequent slides; the rugged physiography of the tectonically dominated end-member leads to sediment bypass and the collapse of uplifted tectonic features. The maximum and average dimensions of slides are an order of magnitude smaller than those of slides observed along other (passive) glaciated margins. We propose that the general patterns observed in slide distribution are caused by the interplay between tectonic activity (long- and short-term) and sediment delivery. The recurrence (<100 years) of M > 7 earthquakes along the Queen Charlotte Fault may generate small, but frequent, failures of under-consolidated Quaternary sediments within the sediment-dominated regions. By contrast, the tectonically dominated regions are characterized by the bypass of Quaternary sediments to the continental rise and the less frequent collapse of steep, uplifted and consolidated sediments.

Alaska↗

USGS2012

Advances in carbonate exploration and reservoir analysis

The development of innovative techniques and concepts, and the emergence of new plays in carbonate rocks are creating a resurgence of oil and gas discoveries worldwide. The maturity of a basin and the application of exploration concepts have a fundamental influence on exploration strategies. Exploration success often occurs in underexplored basins by applying existing established geological concepts. This approach is commonly undertaken when new basins ‘open up’ owing to previous political upheavals. The strategy of using new techniques in a proven mature area is particularly appropriate when dealing with unconventional resources (heavy oil, bitumen, stranded gas), while the application of new play concepts (such as lacustrine carbonates) to new areas (i.e. ultra-deep South Atlantic basins) epitomizes frontier exploration. Many low-matrix-porosity hydrocarbon reservoirs are productive because permeability is controlled by fractures and faults. Understanding basic fracture properties is critical in reducing geological risk and therefore reducing well costs and increasing well recovery. The advent of resource plays in carbonate rocks, and the long-standing recognition of naturally fractured carbonate reservoirs means that new fracture and fault analysis and prediction techniques and concepts are essential.

Geological Society Special Publication↗

USGS2011

The indication of Martian gully formation processes by slope-area analysis

The formation process of recent gullies on Mars is currently under debate. This study aims to discriminate between the proposed formation processes - pure water flow, debris flow and dry mass wasting - through the application of geomorphological indices commonly used in terrestrial geomorphology. High-resolution digital elevation models (DEMs) of Earth and Mars were used to evaluate the drainage characteristics of small slope sections. Data from Earth were used to validate the hillslope, debris-flow and alluvial process domains previously found for large fluvial catchments on Earth, and these domains were applied to gullied and ungullied slopes on Mars. In accordance with other studies, our results indicate that debris flow is one of the main processes forming the Martian gullies that were being examined. The source of the water is predominantly distributed surface melting, not an underground aquifer. Evidence is also presented indicating that other processes may have shaped Martian crater slopes, such as ice-assisted creep and solifluction, in agreement with the proposed recent Martian glacial and periglacial climate. Our results suggest that, within impact craters, different processes are acting on differently oriented slopes, but further work is needed to investigate the potential link between these observations and changes in Martian climate.

Geological Society Special Publication↗